- 您现在的位置：买卖IC网 > PDF目录80580 > M38259EFFP 8-BIT, OTPROM, 4 MHz, MICROCONTROLLER, PQFP100 PDF资料下载
参数资料
| 型号： | M38259EFFP |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 8-BIT, OTPROM, 4 MHz, MICROCONTROLLER, PQFP100 |
| 封装： | 14 X 20 MM, 0.65 MM PITCH, PLASTIC, QFP-100 |
| 文件页数： | 51/73页 |
| 文件大小： | 1323K |
| 代理商： | M38259EFFP |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页当前第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页
Rev.2.02
Jun 19, 2007
page 53 of 73
REJ03B0146-0202
3823 Group
Fig. 56 Clock generating circuit block diagram
Oscillation Control
(1) Stop Mode
If the STP instruction is executed, the internal clock φ stops at an
“H” level, and XIN and XCIN oscillators stop. Timer 1 is set to
“FF16” and timer 2 is set to “0116”.
Either XIN or XCIN divided by 16 is input to timer 1 as count
source, and the output of timer 1 is connected to timer 2. The bits
of the timer 123 mode register except bit 4 are cleared to “0”. Set
the timer 1 and timer 2 interrupt enable bits to disabled (“0”) be-
fore executing the STP instruction. Oscillator restarts at reset or
when an external interrupt is received, but the internal clock φ is
not supplied to the CPU until timer 2 underflows. This allows timer
for the clock circuit oscillation to stabilize.
Execution of the STP instruction sets the LCD enable bit (bit 3 of
the LCD mode register) to “0” and the LCD panel turns off.To
make the LCD panel turn on after returning from the stop mode,
set the LCD enable bit to “1”.
(2) Wait Mode
If the WIT instruction is executed, only the system clock φ stops at
an "H" state. The states of main clock, on-chip oscillator and sub
clock are the same as the state before executing the WIT instruc-
tion, and oscillation does not stop. Since supply of system clock φ
is started immediately after the interrupt is received, the instruc-
tion can be executed immediately.
Timing φ
(Internal system clock)
Main clock stop bit
Timer 2
Timer 1
1/2
1/4
XIN
XOUT
WIT
instruction
STP instruction
S
R
Q
STP instruction
S
R
Q
S
R
Q
Interrupt request
Interrupt disable flag 1
Reset
1/2
“1”
“0”
Timer 1
count source
selection bit
“0”
“1”
Timer 2
count source
selection bit
Low-speed mode
Frequency/2/4/8
mode
(Note 1)
Frequency/8 mode
Frequency/2/4
mode or low-
speed mode
Internal system clock selection bit
Main clock division
ratio selection bit
“1”
“0”
“1”
Notes 1: When using the low-speed mode, set the port XC switch bit to “1” .
2: Although a feed-back resistor exists on-chip, an external feed-back resistor may be needed depending
on conditions.
Frequency/4
mode
control bit
1/2
XCOUT
XCIN
Port XC
switch bit
“0”
“1”
On-chip
oscillator
On-chip oscillator
control bit
f(SUB)
(Note 2)
相关PDF资料 |
PDF描述 |
|---|---|
| MB90348EPF | MICROCONTROLLER, PQFP100 |
| MB90F345CEPF | MICROCONTROLLER, PQFP100 |
| M30102F3TFP | 16-BIT, FLASH, 16 MHz, MICROCONTROLLER, PQFP48 |
| M37481M8-XXXFP | 8-BIT, MROM, 4 MHz, MICROCONTROLLER, PQFP44 |
| M37481M8T-XXXSP | 8-BIT, MROM, 4 MHz, MICROCONTROLLER, PDIP42 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| M3826 | 功能描述:电缆固定件和配件 LTRSCG 1000 BLACK RoHS:否 制造商:Heyco 类型:Cable Grips, Liquid Tight 材料:Nylon 颜色:Black 安装方法:Cable 最大光束直径:11.4 mm 抗拉强度: |
| M3826 BK001 | 制造商:Alpha Wire Company 功能描述:CBL 2COND 16AWG BLK 1000' |
| M3826 BK002 | 制造商:Alpha Wire Company 功能描述:CBL 2COND 16AWG BLK 500' |
| M3826 BK005 | 制造商:Alpha Wire Company 功能描述:CBL 2COND 16AWG BLK 100' |
| M3826 BK199 | 制造商:Alpha Wire Company 功能描述:CBL 2COND 16AWG BLK 3000=3000' |
发布紧急采购，3分钟左右您将得到回复。