- 您现在的位置：买卖IC网 > PDF目录67775 > M48T129V-70PM1 (STMICROELECTRONICS) 0 TIMER(S), REAL TIME CLOCK, PDIP32 PDF资料下载
参数资料
| 型号： | M48T129V-70PM1 |
| 厂商： | STMICROELECTRONICS |
| 元件分类： | 时钟/数据恢复及定时提取 |
| 英文描述： | 0 TIMER(S), REAL TIME CLOCK, PDIP32 |
| 封装： | 0.600 INCH, PLASTIC, MODULE, DIP-32 |
| 文件页数： | 9/30页 |
| 文件大小： | 483K |
| 代理商： | M48T129V-70PM1 |
第1页第2页第3页第4页第5页第6页第7页第8页当前第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
17/30
M48T129Y, M48T129V
Setting the Alarm Clock
Registers 1FFF6h-1FFF2h contain the alarm set-
tings. The alarm can be configured to go off at a
prescribed time on a specific month, date, hour,
minute, or second or repeat every month, day,
hour, minute, or second. It can also be pro-
grammed to go off while the M48T129Y/V is in the
battery back-up to serve as a system wake-up call.
Bits RPT5-RPT1 put the alarm in the repeat mode
of operation. Table 6., page 17 shows the possible
configurations. Codes not listed in the table default
to the once per second mode to quickly alert the
user of an incorrect alarm setting.
Note: User must transition address (or toggle Chip
Enable) to see Flag Bit change.
When the clock information matches the alarm
clock settings based on the match criteria defined
by RPT5-RPT1, the AF (Alarm Flag) is set. If AFE
(Alarm Flag Enable) is also set, the alarm condi-
tion activates the IRQ/FT pin. To disable alarm,
write ’0’ to the Alarm Date register and RPT1-5.
The IRQ/FT output is cleared by a READ to the
Flags Register as shown in Figure 12. A subse-
quent READ of the Flags Register is necessary to
see that the value of the Alarm Flag has been re-
set to '0.'
The IRQ/FT pin can also be activated in the bat-
tery back-up mode. The IRQ/FT will go low if an
alarm occurs and both ABE (Alarm in Battery
Back-up Mode Enable) and AFE are set. The ABE
and AFE Bits are reset during power-up, therefore
an alarm generated during power-up will only set
AF. The user can read the Flag Register at system
boot-up to determine if an alarm was generated
while the M48T129Y/V was in the deselect mode
during power-up. Figure 13., page 18 illustrates
the back-up mode alarm timing.
Figure 12. Alarm Interrupt Reset Waveform
Table 6. Alarm Repeat Mode
RPT5
RPT4
RPT3
RPT2
RPT1
Alarm Activated
1
Once per Second
1
0
Once per Minute
1
0
Once per Hour
1
0
Once per Day
1
0
Once per Month
0
Once per Year
AI02581
AD0-AD7
ACTIVE FLAG BIT
ADDRESS 1FF0h
IRQ/FT
HIGH-Z
15ns Min
相关PDF资料 |
PDF描述 |
|---|---|
| M48T251Y-70PM1 | 0 TIMER(S), REAL TIME CLOCK, PDIP32 |
| M48T35Y-70PC6 | 0 TIMER(S), REAL TIME CLOCK, PDIP28 |
| M5M80C85AP-2 | 8-BIT, 5 MHz, MICROPROCESSOR, PDIP40 |
| M5M82C55AFP-2 | 24 I/O, PIA-GENERAL PURPOSE, PDSO40 |
| M5M82C55AP-2 | 24 I/O, PIA-GENERAL PURPOSE, PDIP40 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| M48T129V-85CS1 | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:3.3V-5V 1 Mbit 128Kb x8 TIMEKEEPER SRAM |
| M48T129V-85PM1 | 功能描述:实时时钟 1M (128Kx8) 85ns RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube |
| M48T129VPM | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:3.3V-5V 1 Mbit 128Kb x8 TIMEKEEPER SRAM |
| M48T129VSH | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:3.3V-5V 1 Mbit 128Kb x8 TIMEKEEPER SRAM |
| M48T129Y | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:5.0 or 3.3V, 1 Mbit (128 Kbit x 8) TIMEKEEPER SRAM |
发布紧急采购，3分钟左右您将得到回复。