- 您现在的位置：买卖IC网 > PDF目录98008 > M66290AFP UNIVERSAL SERIAL BUS CONTROLLER, PQFP48 PDF资料下载
参数资料
| 型号： | M66290AFP |
| 元件分类： | 总线控制器 |
| 英文描述： | UNIVERSAL SERIAL BUS CONTROLLER, PQFP48 |
| 封装： | TQFP-48 |
| 文件页数： | 25/54页 |
| 文件大小： | 452K |
| 代理商： | M66290AFP |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页当前第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页
USB DEVICE CONTROLLER
M66290AGP/FP
MITSUBISHI <DIGITAL ASSP>
30
FIFO control
Access to endpoint buff er of EP0 to EP5 is done by
three FIFO data registers. One is only f or EP0 and
Others are common to EP1 to EP5. Common data
registers are div ided into two, because accessing
is diff erent, that is f or CPU access and f or DMA
transf er. Which endpoint of EP1 to EP5 to be
accessed can be selected to set each FIFO
selection register.
Endpoint
EP0
EP1 to EP5
Accessing
CPU access
DMA transf er
Register name
EP0_FIFO
data register
CPU_FIFO
data register
DMA_FIFO
data register
Each of three FIFO registers has f unctions as
f ollows. And these f unctions can be used to set
"Each FIFO Selection/Control Register".
Short packet transmission f unction
(IVAL : IN buff er status bit)
Transmit/receiv e buff er clear f unction
(BCLR : Buff er clear bit)
Null data (data length 0) transmit f unction
(IVAL & BCLR)
Data length (8/16 bit) set f unction
(Octl : Register 8bit mode bit)
Receiv ed data length count down f unction
(RCNT : Read count mode bit)
*: There is none f or DMA transf er
Access to CPU_FIFO data register when interrupt
occurred, to know the endpoint which requested
access, access the "Interrupt Status Register 0/1"
and by checking the interrupt status f lag and know
the endpoint which requested access, and then set
endpoint to be accessed by "CPU_FIFO Selection
Register".
If there is no change of endpoint setting, it is not
needed to set again the CPU access endpoint
appointment bit.
Data transfer procedure
Data which is set to endpoint FIFO, is sent to USB
bus by LSB f irst. When store the receiv ed data
f rom USB bus to endpoint FIFO, it is as the same
as abov e.
D0 D1 D2 D3 D4 D5 D6 D7 D8 D9 D10 D11 D12 D13 D14D15
1
16
Time scale
(Data send procedure to USB bus)
DMA transfer
To endpoint of EP1 to EP5, 16bits width or 8bit width of
DMA
transf er is av ailable.
Each endpoint of EP1 to EP5 can be set to CPU access
mode or DMA access mode by set of "EPx Conf iguration
Register 1" mentioned later.
DMA transf er is realized to hand shake with external DMAC
and Dreq, Dack signal. Dreq is asserted when endpoint
buff er, which is set to DMA transf er mode, became ready.
The means of Buff er ready state is, if the endpoint
transf er
direction is set to Out (reciv e data f rom host) buff er ready
means that in read enable state, if the endpoint transf er
direction is set to IN(transmit data to host) buff er ready
means that in write enable state. Setting the transf er
direction can be done by "EPi Conf iguration Register 0" to
each endpoint.
When Dack comes f rom external DMAC af ter asserted
Dreq, Dreq is negated.
In DMA transf er, Dack is dealt equiv alently with CS signal
and DMA_FIFO address appointment.
Appoint read or write operation by RD or WR signal.
This DMA transf er can be used only f or single transf er,
which
transf ers one word (16bit or 8bit) by one time Dreq start.
In DMA transf er, as same as the CPU access, occurs
endpoint buff er not ready interrupt and endpoint buff er
empty interrupt according to endpoint buff er state. But as
to endpoint buff er ready interrupt, it is not same as the
CPU access as f ollows.
In DMA transf er, endpoint buff er ready interrupt is not
occurred if the transf er direction is IN.
If the transf er direction is OUT, interrupt is occurred when
receiv ed short data packet and ended data transf er of all
data which receiv ed in DMA transf er.
Occurring of endpoint buff er ready interrupt and to ref er
DMA_DTLN, it can be known that short data packet was
receiv ed.
DMA_DTLN shows the number of by te of short data
packet,
or in the continuous receiv e mode it shows the number of
by te
of receiv ed data bef ore short data packet receiv e.
相关PDF资料 |
PDF描述 |
|---|---|
| M66291GP | UNIVERSAL SERIAL BUS CONTROLLER, PQFP48 |
| M68HC08AZ0 | 8-BIT, EEPROM, 8 MHz, MICROCONTROLLER, PQFP100 |
| M69030 | GRAPHICS PROCESSOR, PBGA278 |
| MA4T85633 | C BAND, Si, NPN, RF SMALL SIGNAL TRANSISTOR |
| MA4T85600 | Si, RF POWER TRANSISTOR |
相关代理商/技术参数 |
参数描述 |
|---|---|
| M66290AGP | 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:USB DEVICE CONTROLLER |
| M66291GP | 制造商:Renesas Electronics Corporation 功能描述: |
| M66291GP#201 | 制造商:Renesas Electronics Corporation 功能描述:IC ASSP USB2.0 DEVICE CONTROLLER 48LQFP |
| M66291GP#RB0S | 功能描述:IC USB CONTROLLER GEN-PUR 48LQFP RoHS:是 类别:集成电路 (IC) >> 接口 - 控制器 系列:- 标准包装:4,900 系列:- 控制器类型:USB 2.0 控制器 接口:串行 电源电压:3 V ~ 3.6 V 电流 - 电源:135mA 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:36-VFQFN 裸露焊盘 供应商设备封装:36-QFN（6x6） 包装:* 其它名称:Q6396337A |
| M66291GPRB0S | 制造商:Renesas Electronics Corporation 功能描述:USB2.0 Device Controller,LQFP48 |
发布紧急采购，3分钟左右您将得到回复。