- 您现在的位置：买卖IC网 > PDF目录359112 > M93S56-WMN6TG (意法半导体) Hex Schmitt-Trigger Inverters 14-SSOP -40 to 85 PDF资料下载
参数资料
| 型号： | M93S56-WMN6TG |
| 厂商： | 意法半导体 |
| 英文描述： | Hex Schmitt-Trigger Inverters 14-SSOP -40 to 85 |
| 中文描述： | 4Kbit，2Kbit和1Kbit 16位宽MICROWIRE串行EEPROM的访问与街区保护 |
| 文件页数： | 5/34页 |
| 文件大小： | 525K |
| 代理商： | M93S56-WMN6TG |
第1页第2页第3页第4页当前第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页
5/34
M93S66, M93S56, M93S46
An internal Power-on Data Protection mechanism
in the M93Sx6 inhibits the device when the supply
is too low.
POWER-ON DATA PROTECTION
To prevent data corruption and inadvertent write
operations during power-up, a Power-On Reset
(POR) circuit resets all internal programming cir-
cuitry, and sets the device in the Write Disable
mode.
–
At Power-up and Power-down, the device
must
not
be selected (that is, Chip Select Input
(S) must be driven Low) until the supply
voltage reaches the operating value V
CC
specified in
Table 5.
to
Table 6.
.
–
When V
CC
reaches its valid level, the device is
properly reset (in the Write Disable mode) and
is ready to decode and execute incoming
instructions.
For the M93Sx6 devices (5V range) the POR
threshold voltage is around 3V. For the M93Sx6-
W (3V range) and M93Sx6-R (2V range) the POR
threshold voltage is around 1.5V.
INSTRUCTIONS
The instruction set of the M93Sx6 devices con-
tains seven instructions, as summarized in
Table
2.
to
Table 3.
. Each instruction consists of the fol-
lowing parts, as shown in
Figure 4.
:
Each instruction is preceded by a rising edge
on Chip Select Input (S) with Serial Clock (C)
being held Low.
A start bit, which is the first ‘1’ read on Serial
Data Input (D) during the rising edge of Serial
Clock (C).
Two op-code bits, read on Serial Data Input
(D) during the rising edge of Serial Clock (C).
(Some instructions also use the first two bits of
the address to define the op-code).
The address bits of the byte or word that is to
be accessed. For the M93S46, the address is
made up of 6 bits (see
Table 2.
). For the
M93S56 and M93S66, the address is made up
of 8 bits (see
Table 3.
).
The M93Sx6 devices are fabricated in CMOS
technology and are therefore able to run as slow
as 0 Hz (static input signals) or as fast as the max-
imum ratings specified in
Table 16.
to
Table 19.
.
■
■
■
■
相关PDF资料 |
PDF描述 |
|---|---|
| M93S56-WMN6T | Hex Schmitt-Trigger Inverters 14-SSOP -40 to 85 |
| M93S56-WMN6P | 4Kbit, 2Kbit and 1Kbit 16-bit wide MICROWIRE Serial Access EEPROM with Block Protection |
| M93S56-WMN6G | Hex Schmitt-Trigger Inverters 14-SOIC -40 to 85 |
| M93S56-WMN6 | 4Kbit, 2Kbit and 1Kbit 16-bit wide MICROWIRE Serial Access EEPROM with Block Protection |
| M93S56-WMN3TP | 4Kbit, 2Kbit and 1Kbit 16-bit wide MICROWIRE Serial Access EEPROM with Block Protection |
相关代理商/技术参数 |
参数描述 |
|---|---|
| M93S56-WMN6TP | 功能描述:电可擦除可编程只读存储器 2KBIT E-EPROM RoHS:否 制造商:Atmel 存储容量:2 Kbit 组织:256 B x 8 数据保留:100 yr 最大时钟频率:1000 KHz 最大工作电流:6 uA 工作电源电压:1.7 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 |
| M93S56-WMN6TP/S | 制造商:STMicroelectronics 功能描述:EEPROM SERL-MICROWIRE 2KBIT 128X16 3.3V/5V 8PIN SO N - Tape and Reel |
| M93S56-WMN6TP-CUT TAPE | 制造商:ST 功能描述:M93S56 Series 2 Kb (128 x 16) 2.5 V 3 Wire Microwire?Serial EEPROM - SOIC-8 |
| M93S66 | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:4Kbit, 2Kbit and 1Kbit 16-bit wide MICROWIRE Serial Access EEPROM with Block Protection |
| M93S66BN | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:4Kbit, 2Kbit and 1Kbit 16-bit wide MICROWIRE Serial Access EEPROM with Block Protection |
发布紧急采购，3分钟左右您将得到回复。