- 您现在的位置：买卖IC网 > PDF目录214844 > M95080-WMB3TG/S (STMICROELECTRONICS) 1K X 8 SPI BUS SERIAL EEPROM, DSO8 PDF资料下载
参数资料
| 型号： | M95080-WMB3TG/S |
| 厂商： | STMICROELECTRONICS |
| 元件分类： | PROM |
| 英文描述： | 1K X 8 SPI BUS SERIAL EEPROM, DSO8 |
| 封装： | 2 X 3 MM, ROHS COMPLIANT, MLP-8 |
| 文件页数： | 9/39页 |
| 文件大小： | 714K |
| 代理商： | M95080-WMB3TG/S |
第1页第2页第3页第4页第5页第6页第7页第8页当前第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页
17/39
M95160, M95080
Write to Memory Array (WRITE)
As shown in Figure 12., to send this instruction to
the device, Chip Select (S) is first driven Low. The
bits of the instruction byte, address byte, and at
least one data byte are then shifted in, on Serial
Data Input (D).
The instruction is terminated by driving Chip Se-
lect (S) High at a byte boundary of the input data.
In the case of Figure 12., this occurs after the
eighth bit of the data byte has been latched in, in-
dicating that the instruction is being used to write
a single byte. The self-timed Write cycle starts,
in Progress (WIP) bit is reset to 0.
If, though, Chip Select (S) continues to be driven
Low, as shown in Figure 13., the next byte of input
data is shifted in, so that more than a single byte,
starting from the given address towards the end of
the same page, can be written in a single internal
Write cycle.
Each time a new data byte is shifted in, the least
significant bits of the internal address counter are
incremented. If the number of data bytes sent to
the device exceeds the page boundary, the inter-
nal address counter rolls over to the beginning of
the page, and the previous data there are overwrit-
ten with the incoming data. (The page size of
these devices is 32 bytes).
The instruction is not accepted, and is not execut-
ed, under the following conditions:
–
if the Write Enable Latch (WEL) bit has not
been set to 1 (by executing a Write Enable
instruction just before)
–
if a Write cycle is already in progress
–
if the device has not been deselected, by Chip
Select (S) being driven High, at a byte
boundary (after the eighth bit, b0, of the last
data byte that has been latched in)
–
if the addressed page is in the region
protected by the Block Protect (BP1 and BP0)
bits.
Figure 12. Byte Write (WRITE) Sequence
Note: Depending on the memory size, as shown in Table 7., the most significant address bits are Don’t Care.
C
D
AI01795D
S
Q
15
2
1
3456789 10
20 21 22 23 24 25 26 27
14 13
3210
28 29 30
High Impedance
Instruction
16-Bit Address
0
765432
0
1
Data Byte
31
相关PDF资料 |
PDF描述 |
|---|---|
| MMCK-67130V-45 | 1K X 8 MULTI-PORT SRAM, 45 ns, CDIP48 |
| MHO+46FGG-FREQ | CRYSTAL OSCILLATOR, CLOCK, 67.001 MHz - 80 MHz, CMOS OUTPUT |
| MHO+46TCD-FREQ3 | CRYSTAL OSCILLATOR, CLOCK, 50.001 MHz - 60 MHz, CMOS OUTPUT |
| MHO+51FAD-FREQ1 | CRYSTAL OSCILLATOR, CLOCK, 732 MHz - 2.999 MHz, CMOS/TTL OUTPUT |
| MHO+52FGG-FREQ | CRYSTAL OSCILLATOR, CLOCK, 67.001 MHz - 80 MHz, CMOS OUTPUT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| M95080-WMB6TG | 功能描述:电可擦除可编程只读存储器 2.5 V to 5.5V 8K RoHS:否 制造商:Atmel 存储容量:2 Kbit 组织:256 B x 8 数据保留:100 yr 最大时钟频率:1000 KHz 最大工作电流:6 uA 工作电源电压:1.7 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 |
| M95080-WMN3 | 功能描述:电可擦除可编程只读存储器 5.5V 8K (1Kx8) RoHS:否 制造商:Atmel 存储容量:2 Kbit 组织:256 B x 8 数据保留:100 yr 最大时钟频率:1000 KHz 最大工作电流:6 uA 工作电源电压:1.7 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 |
| M95080-WMN3T | 功能描述:电可擦除可编程只读存储器 5.5V 8K (1Kx8) RoHS:否 制造商:Atmel 存储容量:2 Kbit 组织:256 B x 8 数据保留:100 yr 最大时钟频率:1000 KHz 最大工作电流:6 uA 工作电源电压:1.7 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 |
| M95080-WMN3TP | 制造商:STMicroelectronics 功能描述: |
| M95080-WMN3TP/S | 制造商:STMicroelectronics 功能描述:EEPROM Serial-SPI 8K-Bit 1K x 8 3.3V/5V 8-Pin SO N T/R 制造商:ST 功能描述:16 Kbit and 8 Kbit serial SPI bus EEPROM with high speed clock |
发布紧急采购，3分钟左右您将得到回复。