参数资料
型号: MAX11040KGUU+T
厂商: Maxim Integrated Products
文件页数: 15/35页
文件大小: 0K
描述: IC ADC 24BIT 4CH 38TSSOP
产品培训模块: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
标准包装: 2,500
位数: 24
采样率(每秒): 3.07M
数据接口: DSP,MICROWIRE?,QSPI?,串行,SPI?
转换器数目: 4
功率耗散(最大): 1.1W
电压电源: 模拟和数字
工作温度: -40°C ~ 105°C
安装类型: 表面贴装
封装/外壳: 38-TFSOP(0.173",4.40mm 宽)
供应商设备封装: 38-TSSOP
包装: 带卷 (TR)
输入数目和类型: 4 个差分,双极
MAX11040K/MAX11060
24-/16-Bit, 4-Channel, Simultaneous-Sampling,
Cascadable, Sigma-Delta ADCs
22
Maxim Integrated
DRDYOUT
CS
DATA READ
CHANGE DATA RATE
1
2
15
16
17
DATA AT THE OLD
DATA RATE
DATA AT THE NEW
DATA RATE
Figure 12. Timing Diagram for a Data-Rate Change
The data length of the Data-Rate Control register is 16
bits total for writes and reads (see Table 2). Changes to
the Data-Rate Control register take effect after 16 con-
version periods (Figure 12), i.e., the ADC continues to
operate at the old data rate for another 16 periods. Also,
the last sample at the old data rate (sample 16 in Figure
12) may contain some noise component and should be
discarded. Changes in data rate should be limited to
±5% for correct operation. The data rate register should
not be updated more than once every 32 data rate peri-
ods.
Note: Write to the data rate register in the time window of
10ns after the rising edge of DRDYOUT and 100ns
before the falling edge of DRDYOUT.
The digital filter determines the latency. Latency is
defined as the time between the effective point in time
that a sample is taken and when the resulting digital data
is available for reading (DRDYOUT goes low). The laten-
cy of the converter is specified by the following equation:
Latency = (6 x tDOUT) + (PHI x 1.3μs) + 30μs
where tDOUT is the data output period (inverse of the
programmed sample rate) determined by XINCLOCK
and the selected output data rate, and PHI is the pro-
grammed sampling instant delay for the channel in ques-
tion (0
≤ PHI ≤ 255). The latency is approximately 405μs
at 16ksps.
Because the two filters operate at different output data
rates, a skew builds up between them over the 16 sam-
ples that both are in operation. For example, at 30ksps,
the minimum data rate step size is 0.125%; so over 16
samples, the difference becomes 2%. This causes the
period from sample 16 to sample 17 to be different by
this amount.
相关PDF资料
PDF描述
D38999/24MB98PA CONN RCPT 6POS JAM NUT W/PINS
MC10H116DR2G IC LINE RCVR TRIPLE ECL 16-SOIC
ISL4485EIB IC TXRX RS-485/422 5V ESD 8-SOIC
MAX177CWG+T IC ADC 10BIT W/ T/H 24-SOIC
MS3111J14-12P CONN RCPT 12POS CBL MNT W/PINS
相关代理商/技术参数
参数描述
MAX11041 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Wired Remote Controllers
MAX11041_08 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Wired Remote Controllers
MAX11041_10 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Wired Remote Controller
MAX11041ETC 功能描述:接口 - 专用 RoHS:否 制造商:Texas Instruments 产品类型:1080p60 Image Sensor Receiver 工作电源电压:1.8 V 电源电流:89 mA 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:BGA-59
MAX11041ETC+ 功能描述:接口 - 专用 Wired Remote Controller RoHS:否 制造商:Texas Instruments 产品类型:1080p60 Image Sensor Receiver 工作电源电压:1.8 V 电源电流:89 mA 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:BGA-59