参数资料
| 型号： | MAX1109CUB+T |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 6/20页 |
| 文件大小： | 0K |
| 描述： | IC ADC 8BIT LP 10-UMAX |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 2,500 |
| 位数： | 8 |
| 采样率（每秒）： | 50k |
| 数据接口： | MICROWIRE?，QSPI?，串行，SPI? |
| 转换器数目： | 1 |
| 功率耗散（最大）： | 444mW |
| 电压电源： | 单电源 |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-TFSOP，10-MSOP（0.118"，3.00mm 宽） |
| 供应商设备封装： | 10-µMAX |
| 包装： | 带卷 (TR) |
| 输入数目和类型： | 2 个单端，单极；2 个单端，双极；1 个伪差分，单极；1 个伪差分，双极 |
MAX1108/MAX1109
Single-Supply, Low-Power,
2-Channel, Serial 8-Bit ADCs
14
______________________________________________________________________________________
initiated. The MSB successive-approximation bit deci-
sion is made on the rising edge of the seventh SCLK.
On the falling edge of the eighth SCLK, the MSB is
clocked out on the DOUT pin; on each of the next
seven SCLK falling edges, the remaining bits of conver-
sion are clocked out. Zeros are clocked out on DOUT
after the LSB has been clocked out, until CS is dis-
abled. Then DOUT becomes high impedance and the
part is ready for another conversion (Figure 6).
The conversion must complete in 1ms, or droop on the
sample-and-hold capacitors may degrade conversion
results. Use internal clock mode if the serial-clock fre-
quency is less than 50kHz, or if serial-clock interruptions
could cause the conversion interval to exceed 1ms.
Internal Clock
Internal clock mode frees the P from the burden of
running the SAR conversion clock. This allows the con-
version results to be read back at the processor’s con-
venience, at any clock rate up to 2MHz.
An internal register stores data when the conversion is
in progress. On the falling edge of the fourth SCLK,
track mode is enabled, and on the falling edge of the
eighth SCLK, acquisition is complete and internal con-
version is initiated. The internal 400kHz clock com-
pletes the conversion in 20s typically (35s max), at
which time the MSB of the conversion is present at the
DOUT pin. The falling edge of SCLK clocks the remain-
ing data out of this register at any time after the conver-
sion is complete (Figure 8).
CS
SCLK
DIN
DOUT
14
8
12
16
20
START
SEL2
MSB
LSB
SEL1
SEL0
I/ECLK I/EREF
REF
SHDN
D7
MSB
LSB
D6
D5
D4
D3
D2
D1
D0
IDLE
tCONV
tACQ
A/D STATE
Figure 6. Single Conversion Timing, External Clock Mode
CS
SCLK
DIN
DOUT
tCSH
tCSS
tCL
tDS
tDH
tDV
tCH
tDO
tTR
tCSH
Figure 7. Detailed Serial-Interface Timing
相关PDF资料 |
PDF描述 |
|---|---|
| MS27484T22F32PB | CONN PLUG 32POS STRAIGHT W/PINS |
| MS27472T14B35P | CONN RCPT 37POS WALL MNT W/PINS |
| CS3106A-14S-52P | CONN PLUG 4POS STRAIGHT W/PINS |
| MAX1108CUB+T | IC ADC 8BIT LP 10-UMAX |
| D38999/26WD19SC | CONN PLUG 19POS STRAIGHT W/SCKT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX1109CUB-TG07 | 制造商:Maxim Integrated Products 功能描述:10 PINS UMAX PKG - Tape and Reel |
| MAX1109EUB | 功能描述:模数转换器 - ADC RoHS:否 制造商:Texas Instruments 通道数量:2 结构:Sigma-Delta 转换速率:125 SPs to 8 KSPs 分辨率:24 bit 输入类型:Differential 信噪比:107 dB 接口类型:SPI 工作电源电压:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-32 |
| MAX1109EUB+ | 功能描述:模数转换器 - ADC 2Ch Single-Supply Low-P Serial 8-Bit RoHS:否 制造商:Texas Instruments 通道数量:2 结构:Sigma-Delta 转换速率:125 SPs to 8 KSPs 分辨率:24 bit 输入类型:Differential 信噪比:107 dB 接口类型:SPI 工作电源电压:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-32 |
| MAX1109EUB+T | 功能描述:模数转换器 - ADC 2Ch Single-Supply Low-P Serial 8-Bit RoHS:否 制造商:Texas Instruments 通道数量:2 结构:Sigma-Delta 转换速率:125 SPs to 8 KSPs 分辨率:24 bit 输入类型:Differential 信噪比:107 dB 接口类型:SPI 工作电源电压:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-32 |
| MAX1109EUB-G07 | 制造商:Maxim Integrated Products 功能描述:- Rail/Tube |
发布紧急采购，3分钟左右您将得到回复。