- 您现在的位置：买卖IC网 > PDF目录383311 > MAX1153 (Maxim Integrated Products, Inc.) Stand-Alone. 10-Channel. 10-Bit System Monitors with Internal Temperature Sensor and VDD Monitor PDF资料下载
参数资料
| 型号： | MAX1153 |
| 厂商： | Maxim Integrated Products, Inc. |
| 元件分类： | 温度/湿度传感器 |
| 英文描述： | Stand-Alone. 10-Channel. 10-Bit System Monitors with Internal Temperature Sensor and VDD Monitor |
| 中文描述： | 独立的10通道、10位系统监视器，内置温度传感器和VDD监视器 |
| 文件页数： | 11/29页 |
| 文件大小： | 481K |
| 代理商： | MAX1153 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页当前第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页
M
Stand-Alone, 10-Channel, 10-Bit System Monitors
with Internal Temperature Sensor and V
DD
Monitor
______________________________________________________________________________________
11
During the acquisition interval, IN+ and IN- charge both
a positive (CHOLDP) and a negative (CHOLDN) sam-
pling capacitor. After completing the acquisition inter-
val, the T/H switches open, storing an accurate sample
of the differential voltage between IN+ and IN-. This
charge is then transferred to the ADC and converted.
Finally, the conversion result is transferred to the cur-
rent data register.
Temperature conversions require 46μs (typ) and mea-
sure the difference between two sequential voltage
measurements (see the
Temperature Measurement
section for a detailed description).
Fully Differential Track/Hold (T/H)
The T/H acquisition interval begins with the rising edge
of
CS
(for manually triggered conversions) and is inter-
nally timed to 1.5μs (typ). The accuracy of the input sig-
nal sample is a function of the input signal
’
s source
impedance and the T/H
’
s capacitance. In order to
achieve adequate settling of the T/H, limit the signal
source impedance to a maximum of 1k
.
Input Bandwidth
The ADC
’
s input tracking circuitry has a 1MHz small-
signal bandwidth. To avoid high-frequency signals
aliasing into the frequency band of interest, anti-alias
prefiltering of the input signals is recommended.
Analog Input Protection
Internal protection diodes, which clamp the analog
inputs to V
DD
and GND, allow the channel input pins to
swing from (GND - 0.3V) to (V
DD
+ 0.3V) without dam-
age. However, for accurate conversions near full scale,
the inputs must not exceed V
DD
by more than 50mV or
be lower than GND by 50mV. If the analog input range
must exceed 50mV beyond the supplies, limit the input
current.
Single Ended/Differential
The MAX1153/MAX1154 use a fully differential ADC for
all conversions. Through the input configuration regis-
ter, the analog inputs can be configured for either dif-
ferential or single-ended conversions. When sampling
signal sources close to the MAX1153/MAX1154, single-
ended conversion is generally sufficient. Single-ended
conversions use only one analog input per signal
source, internally referenced to GND.
MUX
AIN 0
V
DD
AIN 1
AIN 2
AIN 3
AIN 4
AIN 5
AIN 6
AIN 7
TEMP
SENSE
12-BIT
ADC WITH T/H
DIGITAL
COMPARATOR
INPUT REGISTERS 0–10
CURRENT DATA
UPPER THRESHOLD
LOWER THRESHOLD
# FAULT CYCLES
AVERAGE
CONFIGURATION/
STATUS
REGISTERS
SCAN AND
CONVERSION
CONTROL
SERIAL
INTERFACE
DIN
DOUT
SCLK
CS
INT
Figure 3. Simplified Alarm Block Diagram of the MAX1153/MAX1154
相关PDF资料 |
PDF描述 |
|---|---|
| MAX1154 | Stand-Alone. 10-Channel. 10-Bit System Monitors with Internal Temperature Sensor and VDD Monitor |
| MAX1153-MAX1154 | Stand-Alone, 10-Channel, 10-Bit System Monitors with Internal Temperature Sensor and VDD Monitor |
| MAX1154AEUE | Stand-Alone, 10-Channel, 10-Bit System Monitors with Internal Temperature Sensor and VDD Monitor |
| MAX1154BEUE | Stand-Alone, 10-Channel, 10-Bit System Monitors with Internal Temperature Sensor and VDD Monitor |
| MAX1153AEUE | Stand-Alone, 10-Channel, 10-Bit System Monitors with Internal Temperature Sensor and VDD Monitor |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX1153_10 | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Stand-Alone, 10-Channel, 10-Bit System Monitors with Internal Temperature Sensor and VDD Monitor |
| MAX1153AEUE | 功能描述:模数转换器 - ADC RoHS:否 制造商:Texas Instruments 通道数量:2 结构:Sigma-Delta 转换速率:125 SPs to 8 KSPs 分辨率:24 bit 输入类型:Differential 信噪比:107 dB 接口类型:SPI 工作电源电压:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-32 |
| MAX1153AEUE+ | 功能描述:模数转换器 - ADC RoHS:否 制造商:Texas Instruments 通道数量:2 结构:Sigma-Delta 转换速率:125 SPs to 8 KSPs 分辨率:24 bit 输入类型:Differential 信噪比:107 dB 接口类型:SPI 工作电源电压:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-32 |
| MAX1153AEUE+T | 功能描述:模数转换器 - ADC RoHS:否 制造商:Texas Instruments 通道数量:2 结构:Sigma-Delta 转换速率:125 SPs to 8 KSPs 分辨率:24 bit 输入类型:Differential 信噪比:107 dB 接口类型:SPI 工作电源电压:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-32 |
发布紧急采购，3分钟左右您将得到回复。