- 您现在的位置：买卖IC网 > PDF目录2008 > MAX132EWG+T (Maxim Integrated Products)IC ADC 18BIT SERIAL 24-SOIC PDF资料下载
参数资料
| 型号： | MAX132EWG+T |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 16/16页 |
| 文件大小： | 0K |
| 描述： | IC ADC 18BIT SERIAL 24-SOIC |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 1,000 |
| 位数： | 18 |
| 采样率（每秒）： | 100 |
| 数据接口： | MICROWIRE?，串行，SPI? |
| 转换器数目： | 1 |
| 电压电源： | 双 ± |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 24-SOIC（0.295"，7.50mm 宽） |
| 供应商设备封装： | 24-SOIC W |
| 包装： | 带卷 (TR) |
| 输入数目和类型： | 1 个伪差分，双极 |
MAX132
±18-Bit ADC with Serial Interface
_______________________________________________________________________________________
9
Note: Capacitor values are for a 3.0V integrator swing.
Manufactures of miniature quartz resonators include:
Epson of America
C-2 (through-hole), MC-306 (SMD)
Phone: (310) 787-6300; Fax: (310) 782-5320
Integrator Resistor
The integrator resistor sets the maximum integrator out-
put current for the integrate phase. A 602k
low-noise,
metal-film integrator resistor is recommended for use
with reference voltages between 545mV and 655mV.
Best linearity is achieved when the integration current
(IINT) does not exceed 2.5A. For other reference volt-
ages, select RINT as follows:
Integrator Capacitor
The oscillator frequency, integrator resistor, and inte-
grator capacitor set the maximum integrator output volt-
age swing for full-scale reading. The integrator voltage
swing is about 3V and should not come within 2V of
either supply rail to avoid saturation. A 602k
integrator
resistor and a 4.7nF integrator capacitor are recom-
mended with a clock frequency of 32,768Hz. If different
clock frequencies are used, select CINT using the fol-
lowing equations:
The integrator capacitor’s dielectric absorption directly
affects integral nonlinearity. High-quality metal-film
capacitors are recommended in the following order of
preference: polypropylene, polystyrene, polycarbon-
ate, and polyester (Mylar). The polyester capacitor will
generate some integral nonlinearity.
To minimize noise, INT OUT should drive the outside
foil (negative end) of the capacitor. Manufacturers of
polypropylene capacitors include Sprague (715P),
Panasonic (ECQ-P), Roderstein (KP1835), Wima (FKP),
and CSF Thompson (PL/PS).
Reference Capacitor
The reference capacitor must be small enough to fully
charge from a discharged state on power-up in reason-
able time, and large enough so the charge does not
droop excessively during a conversion. The reference
capacitor is normally 0.1F for all oscillator frequencies.
For applications that require a physically smaller capaci-
tor, the equation below will maintain CREF proportionality:
The reference capacitor must have low leakage, since
it stores the reference voltage while floating during the
deintegrate phase. Any leakage or charge loss during
this phase changes the scale factor and will cause an
error. Appropriate metal-film capacitors recommended
for their low-leakage characteristics1 are (in this order):
polypropylene (up to +105°C, large size), teflon (suit-
able for use up to +125°C, large size), polystyrene,
polycarbonate, and polyester.
At temperatures above +85°C, capacitor leakage may
affect accuracy. In such cases, increasing the value of
CREF up to 50% and more will help at the expense of
longer start-up time at power-on. The start-up time is
proportional to CREF and can be estimated by:
Table 1. Crystal Frequencies and
Integrator Capacitors for 50Hz to 60Hz
Operation
Conv/sec
16
32
48
64
80
96
Crystal
Freq.
(Hz)
32,768
65,536
98, 304
131,072
163,840
196,608
CINT/60Hz
(pF)
4700
2700
1800
CINT/50Hz
(pF)
6800
3300
2000
1200
1000
820
1500
1200
1000
Resistor
(k
)
602
R
V
AI
A
and
I
V
R
INT
REF
INT
REF
INT
.
=
<<
=
25
05
t
f
for
Hz
e
or
t
f
for
Hz
e
INT
OSC
INT
OSC
,
mod
,
mod
=
545
60
655
50
C
f
REF
OSC
.
=
0 0033
tC
F x
x
k
START UP
REF
=
()
10
100
1 Pease, R.A., “Understanding Capacitor Soakage to Optimize
Analog Systems,”
EDN, October 13, 1982, p.125.
C
Vt
RV
where V
V
and
INT
IN FS
INT
SWING
() (
)
() (
)
,
.
;
()
=<
<
13 5
相关PDF资料 |
PDF描述 |
|---|---|
| MAX135EPI+ | IC ADC 15BIT PARALLEL 28-DIP |
| MAX1361MEUB+T | IC SYSTEM MON 10BIT 4CH 10-UMAX |
| MAX1364MEUB+T | IC SYSTEM MON 12BIT 4CH 10-UMAX |
| MAX1394ETB+T | IC ADC 8BIT 416KSPS 10-TDFN-EP |
| MAX1395ETB+T | IC ADC 10BIT 357KSPS 10-TDFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX132MRG | 功能描述:模数转换器 - ADC RoHS:否 制造商:Texas Instruments 通道数量:2 结构:Sigma-Delta 转换速率:125 SPs to 8 KSPs 分辨率:24 bit 输入类型:Differential 信噪比:107 dB 接口类型:SPI 工作电源电压:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-32 |
| MAX1330 | 功能描述:ADC / DAC多通道 RoHS:否 制造商:Texas Instruments 转换速率: 分辨率:8 bit 接口类型:SPI 电压参考: 电源电压-最大:3.6 V 电源电压-最小:2 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-40 |
| MAX13300EVKIT+ | 功能描述:音频 IC 开发工具 MAX13300/01 EVAL KIT RoHS:否 制造商:Texas Instruments 产品:Evaluation Kits 类型:Audio Amplifiers 工具用于评估:TAS5614L 工作电源电压:12 V to 38 V |
| MAX13301AUM/V+ | 制造商:Maxim Integrated Products 功能描述:4-CHANNEL, AUTOMOTIVE CLASS D AUDIO AMPLIFIER - Rail/Tube |
| MAX13301AUM/V+T | 制造商:Maxim Integrated Products 功能描述:4-CHANNEL, AUTOMOTIVE CLASS D AUDIO AMPLIFIER - Tape and Reel |
发布紧急采购，3分钟左右您将得到回复。