- 您现在的位置：买卖IC网 > PDF目录383324 > MAX1515ETG (MAXIM INTEGRATED PRODUCTS INC) Low-Voltage, Internal Switch, Step-Down/DDR Regulator PDF资料下载
参数资料
| 型号： | MAX1515ETG |
| 厂商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | Low-Voltage, Internal Switch, Step-Down/DDR Regulator |
| 中文描述： | 4.7 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, QCC24 |
| 封装： | 4 X 4 MM, 0.8 MM HEIGHT, MO-220-WGGD, TQFN-8 |
| 文件页数： | 15/24页 |
| 文件大小： | 504K |
| 代理商： | MAX1515ETG |
M
Low-Voltage, Internal Switch,
Step-Down/DDR Regulator
______________________________________________________________________________________
15
Short-Circuit/Overload Protection
The MAX1515 can sustain a constant short circuit or
overload. Under a source-mode short-circuit or over-
load condition, when V
FB
< 0.3 x V
TARGET
, the
MAX1515 uses an extended off-time to control the cur-
rent. Operation during a short circuit or overload is sim-
ilar to forced-PWM mode except the off-time is 4 x t
OFF.
At the end of each off-time, the high-side NMOS switch
turns on and remains on until the output is in regulation
or the current through the switch increases to the maxi-
mum current limit. When the high-side NMOS switch
turns off, it remains off for four times the programmed
off-time (t
OFF
), and the low-side NMOS synchronous
switch turns on. Since either NMOS switch is always on,
the inductor current is continuous. The RMS inductor
current during a short circuit remains below the maxi-
mum current-limit threshold. The MAX1515 operates
using the extended off-time until the short circuit or
overload is removed and V
FB
> 0.3 x V
TARGET
.
Prolonged short circuit or overload can result in thermal
shutdown.
Summing Comparator
Three signals are added together at the input of the
summing comparator (Figure 2): an output-voltage
error signal relative to the reference voltage, an inte-
grated output-voltage error-correction signal, and the
sensed high-side NMOS switch current. The integrated
error signal is provided by a transconductance amplifi-
er with an external capacitor at COMP. This integrator
provides high DC accuracy without the need for a high-
gain amplifier. Connecting a capacitor at COMP modi-
fies the overall loop response (see the
Integrator
Amplifier
section).
Integrator Amplifier
The MAX1515 includes an internal transconductance
amplifier that improves the output DC accuracy.
A capacitor, C
COMP
, from COMP to V
CC
compensates
the transconductance amplifier. For stability, choose
C
COMP
= 470pF.
Modes of Operation (MODE)
Use MODE to configure the MAX1515 for DDR mode
(MODE = V
CC
) or non-DDR mode (MODE = GND). In
DDR mode, the MAX1515 can sink current even while
SKIP
is low (see the
Pulse Skipping (Source Mode)
and
Pulse Skipping (Sink Mode)
sections). Also, DDR mode
enables the REFOUT buffer, providing a buffered out-
put of the REFIN voltage. In non-DDR mode, the
MAX1515 can only source current when
SKIP
is low.
The REFOUT buffer is also disabled in non-DDR mode.
Light-Load Operation (
SKIP
)
The MAX1515 includes a pulse-skipping mode that
reduces current consumption during light loads. To con-
figure the MAX1515 for pulse-skipping mode, connect
SKIP
to GND. Forced-PWM mode keeps the switching
frequency relatively constant and is desirable in appli-
cations that must always keep the frequency of con-
ducted and radiated emissions in a narrow band. Visit
Maxim’s website (www.maxim-ic.com) for more informa-
tion on how to control electromagnetic interference
(EMI). Pulse-skipping mode has a dynamic switching
frequency under light loads and is desirable in applica-
tions that require high efficiency at light loads.
Forced-PWM Mode
Connect
SKIP
to V
CC
to force the MAX1515 to operate
in low-noise, constant-off-time PWM mode. Constant
off-time PWM architecture provides a relatively constant
switching frequency (see the
Frequency Variation with
Output Current
section). A single resistor (R
TOFF
) sets
the high-side NMOS power-switch off-time that results
in a switching frequency up to 1MHz, allowing perfor-
mance trade-offs in efficiency, switching noise, compo-
nent size, and cost.
Forced-PWM mode regulates the output voltage by
increasing the high-side NMOS switch on-time to
increase the amount of energy transferred to the load
per cycle. At the end of each off-time, the high-side
NMOS switch turns on and remains on until the output is
in regulation or the current through the switch reaches
the 4.2A current limit. When the high-side NMOS switch
turns off, it remains off for the programmed off-time
(t
OFF
), and the low-side NMOS synchronous switch
turns on. The low-side NMOS switch remains on until the
end of t
OFF
. Since either NMOS switch is always on in
PWM mode, the inductor current is continuous.
1.8V
0.7V
I
LIMIT_P
V
SS
(V)
I
LIMIT
(A)
SHDN
Figure 3. Soft-Start Current Limit
相关PDF资料 |
PDF描述 |
|---|---|
| MAX1516 | TFT-LCD DC-DC Converters with Operational Amplifiers |
| MAX1516ETJ | TFT-LCD DC-DC Converters with Operational Amplifiers |
| MAX1517 | TFT-LCD DC-DC Converters with Operational Amplifiers |
| MAX1517ETJ | TFT-LCD DC-DC Converters with Operational Amplifiers |
| MAX1518 | TFT-LCD DC-DC Converters with Operational Amplifiers |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX1515ETG+ | 功能描述:直流/直流开关调节器 3A 1MHz Step-Down DDR Regulator RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| MAX1515ETG+T | 功能描述:直流/直流开关调节器 3A 1MHz Step-Down DDR Regulator RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| MAX1515ETG-T | 功能描述:直流/直流开关调节器 RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| MAX1515EVKIT | 制造商:Maxim Integrated Products 功能描述:3A 1MHZ LOW-VOLTAGE INTERNAL SWI - Rail/Tube |
| MAX15166EWE+ | 制造商:Maxim Integrated Products 功能描述:HIGH-EFFICIENCY, 4A, STEP-DOWN DC-DC REGULATOR WITH INTERNAL - Rail/Tube |
发布紧急采购，3分钟左右您将得到回复。