- 您现在的位置：买卖IC网 > PDF目录20718 > MAX16812ATI+T (Maxim Integrated)IC LED DRIVR HIGH BRIGHT 28-TQFN PDF资料下载
参数资料
| 型号： | MAX16812ATI+T |
| 厂商： | Maxim Integrated |
| 文件页数： | 13/21页 |
| 文件大小： | 0K |
| 描述： | IC LED DRIVR HIGH BRIGHT 28-TQFN |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 2,500 |
| 恒定电流： | 是 |
| 拓扑： | PWM，SEPIC，降压（降压），升压（升压） |
| 输出数： | 1 |
| 内部驱动器： | 是 |
| 类型 - 主要： | 车载 |
| 类型 - 次要： | 高亮度 LED（HBLED） |
| 频率： | 125kHz ~ 500kHz |
| 电源电压： | 5.5 V ~ 76 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-WFQFN 裸露焊盘 |
| 供应商设备封装： | 28-TQFN-EP（5x5） |
| 包装： | 带卷 (TR) |
| 工作温度： | -40°C ~ 125°C |
Integrated High-Voltage LED Driver
with Analog and PWM Dimming Control
The overvoltage protection (OVP) comparator com-
pares the voltage at OV with a 1.238V (typ) internal ref-
erence. Use the following equation to calculate resistor
values:
REF
L_REG
R OV1 OV2 x ?
?
? V OV_LIM ? V OV ?
= R
? V OV ?
where V OV is the 1.238V OV threshold. Choose R OV1
and R OV2 to be reasonably high-value resistors to pre-
vent the discharge of filter capacitors. This prevents
degraded performance during dimming.
R DIM1
R DIM2
DIM
MAX16812
TGRM
AGND
R TGRM
C TGRM
Internal Oscillator Switching Frequency
The oscillator switching frequency is programmed by a
resistor connected from RT to AGND. To program the
oscillator frequency above 125kHz, choose the appro-
priate resistor RT from the curves shown in the
Oscillator Frequency vs. R T graph in the Typical
Operating Characteristics section.
PWM Dimming
PWM dimming can be achieved by driving DIM with an
analog voltage less than V REF . See Figure 7. An exter-
nal resistor on TGRM from L_REG in conjunction with
the ramp capacitor, C TGRM , from TGRM to AGND cre-
ates a sawtooth ramp that is compared with the DC
voltage on DIM. The output of the comparator is a pul-
sating dimming signal. The frequency f RAMP of the
sawtooth signal on TGRM is given by:
Figure 7. PWM Dimming from REF
PWM dimming can also be achieved by connecting
TGRM to a DC voltage less than V REF and applying the
PWM signal at DIM. The moment the internal dimming
signal goes low, gate drive DRV to the internal switching
MOSFET is turned off. The error amplifier goes to state B
(see the Internal Error Amplifier section and Figures 4
and 5). The peak current in the inductor prior to dis-
abling DRV is I LX . Gate drive DGT to the external dim-
ming MOSFET is held high. Then after a switchover
period, gate voltage V DGT on the external dimming
MOSFET is linearly controlled to reduce the LED current
f RAMP ?
3 . 67
C TGRM × R TGRM
to 0. The fall time of the LED current is controlled by an
internal timing circuit to 5μs for the MAX16812. During
this period, the gate (DRV) to the internal switching
Use the following formula to calculate the voltage V DIM ,
necessary for a given output duty cycle, D:
V DIM = D x 1.238V
where V DIM is the DC voltage applied to DIM in volts.
The DC voltage for DIM can also be created by con-
necting DIM to REF through a resistive voltage-divider.
Using the required dimming input voltage, V DIM , calcu-
late the resistor values for the divider string using the
following equation:
R DIM2 = [V DIM / (V REF - V DIM )] x R DIM1
where V REF is the voltage on REF.
MOSFET is enabled. After the fall time, the gate drive to
the external dimming MOSFET is turned off and the gate
drive to the internal switching MOSFET is still held high
after the switchover period. The peak current in the
inductor is controlled at I LX . Then after a time period of
20μs, the gate drive is disabled. The scope shots in
Figures 8–11 show the dimming waveforms.
______________________________________________________________________________________
13
相关PDF资料 |
PDF描述 |
|---|---|
| VE-J23-CX-F1 | CONVERTER MOD DC/DC 24V 75W |
| NCV4276DT50RKG | IC REG LDO 5V .4A DPAK-5 |
| VE-J2J-CX-F2 | CONVERTER MOD DC/DC 36V 75W |
| TPSE477M010R0060 | CAP TANT 470UF 10V 20% 2917 |
| VE-J2J-CX-F1 | CONVERTER MOD DC/DC 36V 75W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX16812EVKIT+ | 功能描述:LED 照明开发工具 Evaluation Kit for the MAX16812 RoHS:否 制造商:Fairchild Semiconductor 产品:Evaluation Kits 用于:FL7732 核心: 电源电压:120V 系列: 封装: |
| MAX16813ATP/V+ | 制造商:Maxim Integrated Products 功能描述:IC LED DVR 4CH CTLR/DISC QFN |
| MAX16813ATP/V+T | 功能描述:LED照明驱动器 Integrated 4Ch HB LED Driver RoHS:否 制造商:Maxim Integrated 输入电压: 工作频率: 最大电源电流: 输出电流: 最大工作温度: 安装风格: 封装 / 箱体: |
| MAX16813ATP+ | 制造商:Maxim Integrated Products 功能描述:IC LED DVR 4CH CTLR/DISC QFN |
| MAX16813ATP+T | 功能描述:LED照明驱动器 Integrated 4Ch HB LED Driver RoHS:否 制造商:Maxim Integrated 输入电压: 工作频率: 最大电源电流: 输出电流: 最大工作温度: 安装风格: 封装 / 箱体: |
发布紧急采购，3分钟左右您将得到回复。