- 您现在的位置：买卖IC网 > PDF目录13530 > MAX16907RAUE/V+T (Maxim Integrated Products)IC REG BUCK SYNC ADJ 3A 16TSSOP PDF资料下载
参数资料
| 型号： | MAX16907RAUE/V+T |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 12/17页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 3A 16TSSOP |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 两者兼有 |
| 输出数： | 1 |
| 输出电压： | 5V，1 V ~ 10 V |
| 输入电压： | 3.5 V ~ 36 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 1MHz ~ 2.2MHz |
| 电流 - 输出： | 3A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | * |
| 封装/外壳： | * |
| 包装： | * |
| 供应商设备封装： | * |
MAX16907
36V, 2.2MHz Step-Down Converter
with Low Operating Current
Skip Mode/Standby Mode
During light-load operation, I INDUCTOR P 185mA, the
device enters skip mode operation. Skip mode turns off
the majority of circuitry and allows the output to drop
below regulation voltage before the switch is turned on
again. The lower the load current, the longer it takes for
the regulator to initiate a new cycle. Because the con-
verter skips unnecessary cycles and turns off the majority
of circuitry, the converter efficiency increases. When the
high-side FET stops switching for more than 50 F s, most
of the internal circuitry, including LDO, draws power from
V OUT (for V OUT = 3V to 5.5V), allowing current consump-
tion from the battery to drop to only 30 F A.
Spread Spectrum
The IC has an internal spread-spectrum option to optimize
EMI performance. This is factory set and the S-version of
the IC should be ordered. For spread-spectrum-enabled
ICs, the operating frequency is varied ± 6% up from the
V OUT
2.2MHz base frequency. The modulation signal is a tri-
angular wave with a period of 400 μ s. Therefore, fOSC
ramps up 6% in 200 μ s and then ramps down 6% and
back to 2.2MHz in 200 μ s. The cycle repeats. The 400 μ s
modulation period is fixed for other fOSC freqnecy. The
internal spread spectrum is disabled if the IC is synced
to an external clock. However, the IC accepts an external
spread-spectrum clock.
Overtemperature Protection
Thermal-overload protection limits the total power dissipa-
tion in the device. When the junction temperature exceeds
+175 N C (typ), an internal thermal sensor shuts down
the internal bias regulator and the step-down converter,
allowing the IC to cool. The thermal sensor turns on the IC
again after the junction temperature cools by 15 N C.
Applications Information
Setting the Output Voltage
Connect FB to BIAS for a fixed 5V output voltage. To set
the output to other voltages between 1V and 10V, con-
? ? V OUT ?
V FB ?
MAX16907
FB
R FB1
R FB2
nect a resistive divider from output (OUT) to FB to GND
following equation:
?
R FB1
= R FB2 ? ? ? ? 1 ?
? ?
? ? ?
where V FB = 1V (see the Electrical Characteristics table).
Figure 1. Adjustable Output-Voltage Setting
Internal Oscillator
The switching frequency, f SW , is set by a resistor (R FOSC )
connected from FOSC to GND. See Figure 2 to select the
3.0
2.5
2.0
1.5
1.0
SWITCHING FREQUENCY vs. R FOSC
correct R FOSC value for the desired switching frequency.
For example, a 2.2MHz switching frequency is set with
R FOSC = 12k I . Higher frequencies allow designs with
lower inductor values and less output capacitance.
Consequently, peak currents and I 2 R losses are lower
at higher switching frequencies, but core losses, gate
charge currents, and switching losses increase.
Inductor Selection
Three key inductor parameters must be specified for
0.5
0
12
V IN = 14V
I LOAD = 1.5A
15
18
21
24
operation with the device: inductance value (L), inductor
saturation current (I SAT ), and DC resistance (R DCR ). To
select inductance value, the ratio of inductor peak-to-
peak AC current to DC average current (LIR) must be
R FOSC (k I )
Figure 2. Switching Frequency vs. R FOSC
Maxim Integrated
selected first. A good compromise between size and loss
is a 30% peak-to-peak ripple current to average-current
ratio (LIR = 0.3). The switching frequency, input voltage,
12
相关PDF资料 |
PDF描述 |
|---|---|
| VE-2TT-EX-F3 | CONVERTER MOD DC/DC 6.5V 75W |
| RSM24DRUN | CONN EDGECARD 48POS DIP .156 SLD |
| SCPS6430-R12 | INDUCTOR SMD 0.120UH 18A 1MHZ |
| VE-2TT-EX-F2 | CONVERTER MOD DC/DC 6.5V 75W |
| MAX16907SATE/V+T | IC REG BUCK SYNC ADJ 3A 16TQFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX16907SATE/V+ | 功能描述:直流/直流开关转换器 36V 2.2MHz Step Down Converter RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| MAX16907SATE/V+T | 功能描述:直流/直流开关转换器 36V 2.2MHz Step-Down Converter RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| MAX16907SATE+ | 制造商:Maxim Integrated Products 功能描述:- Rail/Tube |
| MAX16907SATE+T | 制造商:Maxim Integrated Products 功能描述:- Tape and Reel |
| MAX16907SAUE/V+ | 功能描述:直流/直流开关转换器 36V 2.2MHz Step-Down Converter RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
发布紧急采购，3分钟左右您将得到回复。