- 您现在的位置：买卖IC网 > PDF目录1839 > MAX1714AEEP+T (Maxim Integrated Products)IC REG CTRLR BUCK PWM CM 20-QSOP PDF资料下载
参数资料
| 型号： | MAX1714AEEP+T |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 20/24页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 20-QSOP |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 2,500 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 600kHz |
| 占空比： | 100% |
| 电源电压： | 4.5 V ~ 5.5 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 20-SSOP（0.154"，3.90mm 宽） |
| 包装： | 带卷 (TR) |
High-Speed Step-Down Controller
for Notebook Computers
capacitors close to the CPU. Resistance values higher
than 5m ? just improve the stability (which can be
observed by examining the load-transient response
characteristic as shown in the Typical Operating
Characteristics ). Avoid adding excess PC board trace
resistance, as there’s an efficiency penalty; 5m ? is suffi-
cient for a 7A circuit.
Fixed Output Voltages
The MAX1714’s Dual Mode? operation allows the selec-
tion of common voltages without requiring external com-
ponents (Figure 8). Connect FB to AGND for a fixed
+2.5V output or to V CC for a +3.3V output, or connect FB
directly to OUT for a fixed +1.0V output.
Setting V OUT with a Resistor-Divider
R ESR ≥
1
2FC OUT
The output voltage can be adjusted with a resistor-
divider if desired (Figure 9). The equation for adjusting
the output voltage is:
V SOAR determines the minimum output capacitance
requirement. In this example, the switching frequency
has been increased to 600kHz and the inductor value
?
V OUT = V FB ? 1 +
?
R1 ?
?
R2 ?
has been reduced to 0.5μH (compared to 300kHz and
1.5μH for the standard 8A circuit) in order to minimize the
energy transferred from inductor to capacitor during
load-step recovery. The overshoot must be calculated to
avoid tripping the OVP latch. The efficiency penalty for
operating at 600kHz is about 2% to 3%, depending on
the input voltage.
An optional 1k ? resistor is placed in series with OUT.
This resistor attenuates high-frequency noise in some
boards, which can cause double pulsing.
OUT
where V FB is 1.0V.
2-Stage (5V Powered) Notebook CPU
Buck Regulator
The most efficient and overall cost-effective solution for
stepping down a high-voltage battery to a very low out-
put voltage is to use a single-stage buck regulator that’s
powered directly from the battery. However, there may
be situations where the battery bus can’t be routed near
the CPU, or where space constraints dictate the smallest
possible local DC-DC converter. In such cases, the 5V
powered circuit of Figure 10 may be appropriate. The
reduced input voltage allows a higher switching frequen-
cy and a much smaller inductor value.
PC Board Layout Guidelines
Careful PC board layout is critical to achieving low
switching losses and clean, stable operation. The switch-
TO ERROR AMP
FIXED
2.5V
MAX1714
ing power stage requires particular attention (Figure 11).
If possible, mount all of the power components on the
top side of the board with their ground terminals flush
against one another. Follow these guidelines for good PC
FIXED
3.3V
2V
FB
board layout:
? Keep the high-current paths short, especially at the
ground terminals. This practice is essential for stable,
jitter-free operation.
? Connect AGND and PGND together close to the IC.
For the MAX1714B, these grounds are connected
internally to the GND pin. Carefully follow the ground-
ing instructions under step 4 of the Layout Procedure .
? Keep the power traces and load connections short.
This practice is essential for high efficiency. Using
thick copper PC boards (2 oz vs. 1 oz) can enhance
full-load efficiency by 1% or more. Correctly routing
PC board traces is a difficult task that must be
Figure 8. Feedback Mux
0.2V
approached in terms of fractions of centimeters,
Dual Mode is a trademark of Maxim Integrated Products.
20
______________________________________________________________________________________
相关PDF资料 |
PDF描述 |
|---|---|
| MAX1715EEI | IC REG CTRLR BUCK PWM 28-QSOP |
| MAX1716EEG+ | IC REG CTRLR BUCK PWM CM 24-QSOP |
| MAX1717EEG+ | IC REG CTRLR BUCK PWM CM 24-QSOP |
| MAX1720EUT | IC REG SWITCHD CAP INV ADJ 6TSOP |
| MAX1721EUT-T | IC REG SWITCHED CAP INV SOT23-6 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX1714AEEP-TG068 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述: |
| MAX1714AEVKIT | 功能描述:电流型 PWM 控制器 Evaluation Kit for the MAX1714A RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| MAX1714BEEE | 功能描述:电流型 PWM 控制器 RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| MAX1714BEEE+ | 功能描述:电流型 PWM 控制器 Step-Down Controller for Notebook RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| MAX1714BEEE+T | 功能描述:电流型 PWM 控制器 Step-Down Controller for Notebook RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
发布紧急采购，3分钟左右您将得到回复。