- 您现在的位置：买卖IC网 > PDF目录1839 > MAX1747EUP+ (Maxim Integrated Products)IC CHRG-PUMP TRPL TFTLCD 20TSSOP PDF资料下载
参数资料
| 型号： | MAX1747EUP+ |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 10/13页 |
| 文件大小： | 0K |
| 描述： | IC CHRG-PUMP TRPL TFTLCD 20TSSOP |
| 标准包装： | 74 |
| 应用： | 转换器，TFT，LCD |
| 输入电压： | 2.7 V ~ 4.5 V |
| 输出数： | 3 |
| 输出电压： | 可调 |
| 工作温度： | 0°C ~ 85°C |
| 安装类型： | * |
| 封装/外壳： | * |
| 供应商设备封装： | * |
| 包装： | * |
Triple Charge-Pump TFT LCD
DC-DC Converter
V SUPM = V IN
SUPM
2.7V TO 4.5V
OSC
C1
MAX1747
SUPN
V SUPP = 2.7V TO 13V
MAX1747
OUT
CXP
V OUT
C OUT
OSC
DRVN
C5
D3
D4
gm
CXN
FB
REF
CX
R1
R2
V REF
1.25V
FBN
REF
R6
R5
V NEG
C6
C INTG
INTG
V REF
C REF
GND
PGND
C REF
PGND
1.25V
GND
V NEG = -(R5/R6) ? V REF
V REF = 1.25V
V OUT = [1+ (R1/R2)] ? V REF
V REF = 1.25V
Figure 2. Main Charge-Pump Block Diagram
Negative Charge Pump
During the first half-cycle, the P-channel MOSFET turns
on, and flying capacitor C5 charges to V SUPN minus a
diode drop (Figure 3). During the second half-cycle,
the P-channel MOSFET turns off, and the N-channel
MOSFET turns on, level shifting C5. This connects C5 in
parallel with the reservoir capacitor, C6. If the voltage
across C6 minus a diode drop is lower than the voltage
across C5, current flows from C5 to C6 until the diode
(D4) turns off. The amount of charge transferred to the
output is controlled by the variable N-channel R ON .
Positive Charge Pump
During the first half-cycle, the N-channel MOSFET turns
on and charges the flying capacitor, C3 (Figure 4). This
initial charge is controlled by the variable N-channel
R ON . During the second half-cycle, the N-channel
MOSFET turns off, and the P-channel MOSFET turns
on, level shifting C3 by V SUPP volts. This connects C3
in parallel with the reservoir capacitor, C4. If the voltage
across C4 plus a diode drop (V POS + V DIODE ) is small-
er than the level-shifted flying capacitor voltage (V C3 +
V SUPP ), charge flows from C3 to C4 until the diode (D2)
turns off.
Frequency Selection and Shutdown
The shutdown pin ( SHDN ) on the MAX1747 performs a
dual function: it shuts down the device and determines
the oscillator frequency. The SHDN input looks like a
diode to ground and should be driven through a resis-
tor (Figure 5).
Figure 3. Negative Charge-Pump Block Diagram
Driving SHDN low forces all three MAX1747 converters
into shutdown mode. When disabled, the supply cur-
rent drops to 20μA (max) to maximize battery life, and
OUT is pulled to ground through an internal 10 ? resis-
tor. For the low-power charge pumps, the output
capacitance and load current determine the rate at
which each output voltage will decay. The device acti-
vates (see Power-up Sequencing ) once SHDN is for-
ward biased (minimum of 3μA of current). Do not leave
SHDN floating. For a typical application where shut-
down is used only to set the switching frequency, con-
nect SHDN to the input (V IN = 3.3V) with a 120k ?
resistor for a 1MHz switching frequency.
The bias current into SHDN , programmed with an exter-
nal resistor, determines the oscillator frequency (see
Typical Operating Characteristics ). To select the fre-
quency, calculate the external resistor value, R FREQ ,
using the following formula:
R FREQ = 45.5 (MHz / mA) ? (V ON – 0.7V) / f OSC
where R FREQ is in k ? and f OSC is in MHz. Program the
frequency in the 200kHz to 2MHz range. This frequen-
cy range corresponds to SHDN input currents between
3μA to 65μA. Proper operation of the oscillator is not
guaranteed beyond these limits. Forcing SHDN below
400mV disables the device.
Soft-Start
For the MAX1747, soft-start is achieved by controlling
the rise rate of the output voltage, regardless of output
capacitance or output load, and limited only by the out-
put impedance of the regulator (see Startup Waveforms
10
______________________________________________________________________________________
相关PDF资料 |
PDF描述 |
|---|---|
| MAX17480GTL+T | IC CTRLR SERIAL VID 40-TQFN |
| MAX17482GTL+ | IC CTLR PWM DUAL IMVP-6.5 40TQFN |
| MAX1748EUE+T | IC DC-DC CONV TRPL LCD 16-TSSOP |
| MAX17497AATE+T | IC OFF-LINE CONVERTER 16TQFN |
| MAX17498AATE+T | IC OFF-LINE CONVERTER 16TQFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX1747EUP+ | 功能描述:电荷泵 Triple Charge-Pump TFT LCD DC/DC Conv RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 输出电压:- 1.5 V to - 5.5 V, 3 V to 11 V 输出电流:100 mA 电源电流:1 mA 最大工作温度:+ 70 C 封装 / 箱体:SOIC-8 Narrow 封装:Tube |
| MAX1747EUP+T | 功能描述:电荷泵 Triple Charge-Pump TFT LCD DC/DC Conv RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 输出电压:- 1.5 V to - 5.5 V, 3 V to 11 V 输出电流:100 mA 电源电流:1 mA 最大工作温度:+ 70 C 封装 / 箱体:SOIC-8 Narrow 封装:Tube |
| MAX1747EUP-T | 功能描述:电荷泵 RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 输出电压:- 1.5 V to - 5.5 V, 3 V to 11 V 输出电流:100 mA 电源电流:1 mA 最大工作温度:+ 70 C 封装 / 箱体:SOIC-8 Narrow 封装:Tube |
| MAX1747EVKIT | 功能描述:电源管理IC开发工具 MAX1747 Eval Kit RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| MAX17480EVKIT+ | 功能描述:电源管理IC开发工具 MAX17480 Eval Kit RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
发布紧急采购，3分钟左右您将得到回复。