- 您现在的位置：买卖IC网 > PDF目录9759 > MAX214EWI+ (Maxim Integrated Products)IC TXRX RS-232 PROG 28-SOIC PDF资料下载
参数资料
| 型号： | MAX214EWI+ |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 11/12页 |
| 文件大小： | 0K |
| 描述： | IC TXRX RS-232 PROG 28-SOIC |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 25 |
| 类型： | 收发器 |
| 驱动器/接收器数： | 3/5 |
| 规程： | RS232 |
| 电源电压： | 4.5 V ~ 5.5 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-SOIC（0.295"，7.50mm 宽） |
| 供应商设备封装： | 28-SOIC W |
| 包装： | 管件 |
| 产品目录页面： | 1400 (CN2011-ZH PDF) |
MAX214
Programmable DTE/DCE,
+5V RS-232 Transceiver
8
_______________________________________________________________________________________
which improves noise margins. The polarity of each
receiver’s input threshold is shown in Tables 1a and 1b.
In normal operating mode, receiver inputs are internally
connected to ground with 5k
resistors. So uncon-
nected receivers with positive input thresholds have
high outputs, and those with negative input thresholds
have low outputs.
When shut down, all receivers have positive thresholds.
This allows the receiver inputs to respond to
TTL-/CMOS-logic levels, as well as RS-232 levels. The
guaranteed 0.8V input threshold ensures that receivers
shorted to ground will have a logic 1 output. Also, the
300k
input resistance to ground ensures that a receiv-
er with its input left open will also have a logic 1 output.
The receiver’s 0.5V of hysteresis provides clean output
transitions, even with slow rise-time and fall-time sig-
nals with moderate amounts of noise and ringing. The
receivers have no hysteresis in shutdown mode.
HI-Z Control
The receiver inputs are terminated with 5k
resistors, to
comply with the requirements of EIA/TIA-232E.
However, these internal resistors can be disconnected
by taking the HI-Z control pin to a logic high. This
makes all of the MAX214’s receiver inputs high imped-
ance, and facilitates the transmission of RS-232 data
from a single transmitter to multiple receivers. In this
case, all but one of the receiving ICs should be put into
the high input-impedance state.
Shutdown Control
In shutdown mode, the charge pumps are turned off,
V+ is pulled down to VCC, V- is pulled to ground, and
the transmitter outputs are disabled. This reduces sup-
ply current typically to 4A.
The time required to exit
shutdown is about 250s, as shown in Figure 3.
Receivers
Receiver outputs never go into a high-impedance state;
they are always active, even in shutdown mode (see
Table 2). These awake-in-shutdown receivers are use-
ful for monitoring external activity (for example, on RI),
while maintaining minimal power consumption.
Receivers in shutdown mode are slower (20kbps) than
when not shut down (116kbps), and lack the hysteresis
present in normal operation.
Drivers
The driver outputs are high impedance in shutdown
mode, even when back-driven with voltages up
to ±15V.
__________Applications Information
Capacitor Selection
The type of capacitor (C1 to C4) used is not critical for
proper operation. The MAX214 requires 1F capaci-
tors, although in all cases capacitors of up to 10F
can be used without harm. Ceramic dielectrics are
suggested for the 1F capacitors.
Table 2. Control Pin Configurations
CONTROL INPUTS
SHUTDOWN
HI-Z
DTE/DCE
RTA, RTB, RTC, RDTC
RRE
0
Receive Mode/5k
Receive Mode/5k
0
1
Transmit Mode
Receive Mode/5k
0
1
0
Receive Mode/HI-Z
0
1
Transmit Mode
Receive Mode/HI-Z
1
0
Slow Receive/HI-Z
1
0
1
Disabled/HI-Z
Slow Receive/HI-Z
1
0
Slow Receive/HI-Z
1
Disabled/HI-Z
Slow Receive/HI-Z
RS-232 PINS
TRA, TRB, TRC
Transmit Mode
Receive Mode/5k
Transmit Mode
Receive Mode/HI-Z
Disabled/HI-Z
Slow Receive/HI-Z
Disabled/HI-Z
Slow Receive/HI-Z
相关PDF资料 |
PDF描述 |
|---|---|
| HI5767/2IA | CONV A/D 10BIT 20MSPS 28-SOIC |
| VI-242-MX-F4 | CONVERTER MOD DC/DC 15V 75W |
| V375C12M150B2 | CONVERTER MOD DC/DC 12V 150W |
| MS27497E14B18PA | CONN RCPT 18POS WALL MNT W/PINS |
| MC100EP16MNR4G | IC RCVR/DRVR 5V DIFF ECL 8-DFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX214EWI+ | 功能描述:RS-232接口集成电路 Prog DTE/DCE 5V RS232 Transceiver RoHS:否 制造商:Exar 数据速率:52 Mbps 工作电源电压:5 V 电源电流:300 mA 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体:LQFP-100 封装: |
| MAX214EWI+T | 功能描述:RS-232接口集成电路 Prog DTE/DCE 5V RS232 Transceiver RoHS:否 制造商:Exar 数据速率:52 Mbps 工作电源电压:5 V 电源电流:300 mA 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体:LQFP-100 封装: |
| MAX214EWI-T | 功能描述:RS-232接口集成电路 RoHS:否 制造商:Exar 数据速率:52 Mbps 工作电源电压:5 V 电源电流:300 mA 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体:LQFP-100 封装: |
| MAX2150 | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Evaluation Kit |
| MAX2150_06 | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Wideband I/Q Modulator with Sigma-Delta Fractional-N Synthesizer |
发布紧急采购，3分钟左右您将得到回复。