参数资料
型号: MAX2369EGM+D
厂商: Maxim Integrated
文件页数: 13/16页
文件大小: 229K
描述: IC TRANSMITTER QUAD 48QFN-EP
标准包装: 43
频率: 120MHz ~ 235MHz
应用: 手机,GAIT 手持话机,LAN,PCS,TDMA,WAN,WLL
功率 - 输出: 5.8dBm ~ 12dBm
电流 - 传输: 6.5mA ~ 155mA
数据接口: PCB,表面贴装
天线连接器: PCB,表面贴装
电源电压: 2.7 V ~ 5.5 V
工作温度: -40°C ~ 85°C
封装/外壳: 48-QFN 裸露焊盘
包装: 管件
Complete Dual-Band
Quadrature Transmitter
______________________________________________________________________________________   13
BIT NAME
FUNCTION
IF_PLL_SHDN
1
0 shuts down the IF PLL. This mode is used with an external IF VCO and IF PLL.
UNUSED
1
Set to 0 for normal operation.
UNUSED
0
Set to 0 for normal operation.
ICP
00
A 2-bit register sets the IF charge-pump current as follows:
00 = 200礎
01 = 260礎
10 = 400礎
11 = 530礎
VCO_BYPASS
0
1 bypasses IF VCO and enables a buffered input for external VCO use.
BUF_DIV
0
1 selects ? on IFLO port; 0 bypasses the divider.
IQ_LEVEL
1
1 selects 200mV
RMS
input mode; 0 selects 100mV
RMS
input mode.
UNUSED
00
Not used. Leave in the power-up/initialized state.
15
14
13
9, 8
10
11
12
7, 6
IF_PD_POL
1
5
IF phase-detector polarity; 1 selects positive polarity (increasing tuning voltage
on the VCO produces increasing frequency); 0 selects negative polarity
(increasing tuning voltage on the VCO produces decreasing frequency).
UNUSED
111
4, 3 ,2
Not used. Leave in the power-up/initialized state.
LD_MODE
1
0
Determines output mode for LOCK detector pin as follows:
0 = test mode, LD_MODE cannot be 0 for normal operation
1 = IF PLL lock detector
POWER-UP
STATE
BIT
LOCATION
(0 = LSB)
Table 4. Configuration Register (CONFIG)
Electromagnetic
Compliance Considerations
Two major concepts should be employed to produce a
noise-free and EMC-compliant transmitter: minimize cir-
cular current-loop area to reduce H-field radiation and
minimize voltage drops to reduce E-field radiation. To
minimize the circular current-loop area, bypass as
close to the part as possible and use the distributed
capacitance of a ground plane. To minimize voltage
drops, make V
CC
traces short and wide, and make RF
traces short.
The don't care bits in the registers should be zero in
order to minimize electromagnetic radiation due to
unnecessary bit banging. RC filtering can also be used
to slow the clock edges on the 3-wire interface, reduc-
ing high-frequency spectral content. RC filtering also
provides for transient protection against IEC802 testing
by shunting high frequencies to ground, while the
series resistance attenuates the transients for error-free
operation. The same applies to the override pins
(SHDN, TXGATE).
When floating the override pins, bypass to ground with
the capacitors as close to the part as possible.
High-frequency bypass capacitors are required close
to the pins with a dedicated via to ground. The 48-pin
QFN-EP package provides minimal inductance ground
by using an exposed paddle under the part. Provide at
least five low-inductance vias under the paddle to
ground to minimize ground inductance. Use a solid
ground plane wherever possible. Any cutout in the
ground plane may act as slot radiator and reduce its
shield effectiveness.
Keep the RF LO traces as short as possible to reduce
LO radiation and susceptibility to interference.
UNUSED
1
1
Set to 0 for normal operation.
相关PDF资料
PDF描述
AH373-WG-7 IC HALL SENSOR 1PH CMOS SC59-3
D75AS-020.0M OSC TCXO 20.000 MHZ 3.3V SMD
B-12-8 CORD PATCH BANANA PLUG 12" GRAY
B-12-7 CORD PATCH BANANA PLUG 12" VIOLT
AH1802-SNG-7 IC HALL SWITCH MCRPWR 6-DFN
相关代理商/技术参数
参数描述
MAX2369EGM-TD 功能描述:射频发射器 RoHS:否 制造商:Micrel 类型:ASK Transmitter 封装 / 箱体:SOT-23-6 工作频率:300 MHz to 450 MHz 封装:Reel
MAX2369EGM-TDG069 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述:
MAX236C/D 功能描述:RS-232接口集成电路 +5V Pwrd 4 RS-232 Xmttrs and 3 RS-232 Rcvrs w/ Pwr Shtdwn & Rcvr RoHS:否 制造商:Exar 数据速率:52 Mbps 工作电源电压:5 V 电源电流:300 mA 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体:LQFP-100 封装:
MAX236C/D DIE 制造商:Maxim Integrated Products 功能描述:
MAX236C/D+ 功能描述:RS-232接口集成电路 RoHS:否 制造商:Exar 数据速率:52 Mbps 工作电源电压:5 V 电源电流:300 mA 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体:LQFP-100 封装: