- 您现在的位置：买卖IC网 > PDF目录18736 > MAX2511EEI+ (Maxim Integrated)IC TXRX IF W/RSSI&LIMIT 28-QSOP PDF资料下载
参数资料
| 型号： | MAX2511EEI+ |
| 厂商： | Maxim Integrated |
| 文件页数： | 4/16页 |
| 文件大小： | 0K |
| 描述： | IC TXRX IF W/RSSI&LIMIT 28-QSOP |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 50 |
| 频率： | 200MHz ~ 440MHz |
| 功率 - 输出： | -2dBm |
| 电源电压： | 2.7 V ~ 5.5 V |
| 电流 - 接收： | 24mA |
| 电流 - 传输： | 26mA |
| 数据接口： | PCB，表面贴装 |
| 天线连接器： | PCB，表面贴装 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 28-QSOP |
| 包装： | 管件 |
Low-Voltage IF Transceiver
with Limiter and RSSI
AC ELECTRICAL CHARACTERISTICS (continued)
(MAX2511 test fixture, V CC = +3.0V, RXEN = TXEN = low, 0.01μF across CZ and CZ , MIXOUT tied to VREF through 165 ? resistor,
TXIN, TXIN tied to VREF through 50 ? resistor, TXOUT and TXOUT loaded with 100 ? differential, GC open, LIMOUT, LIMOUT loaded
with 2k ? differential, TANK and TANK driven with -2.5dBm from a 100 ? source; OSCOUT AC-terminated with 50 ? , 330pF at RSSI
pin, 0.1μF at VREF pin, Rx inputs and Tx outputs differentially coupled, P RXIN, RXIN = -28dBm (200 ? system), f RXIN, RXIN = 425MHz,
f LO = 435.7MHz, f TXIN, TXIN = 10.7MHz, T A = +25°C, unless otherwise noted.)
PARAMETER
CONDITIONS
MIN
TYP
MAX
UNITS
TRANSMITTER (TXEN = high, V TXIN and V TXIN = 100mVp-p differential)
V GC = 0.5V, T A = +25°C
-44
Output Power
V GC = open, T A = +25°C
V GC = 2.0V, T A = +25°C
-5
-19
-2
dBm
V GC = 2.0V, T A = -40°C to +85°C (Note 1)
-6
Image Rejection
LO Rejection
34
40
25
30
dBc
dBc
Output 1dB Compression Point
Output IM3 Level
V GC = 2.0V
0.5V < V GC < 1.87V
-40dBm < P OUT < -10dBm (Note 10)
V GC = 2.0V
2
-40
-35
dBm
dBc
Note 1: Guaranteed by design and characterization.
Note 2: Driving RXIN or RXIN with a power level greater than the 1dB compression level forces the input stage out of its linear
range, causing harmonic and intermodulation distortion. The RSSI output increases monotonically with increasing input
levels beyond the mixer’s 1dB compression level.
Note 3: Assuming the supply voltage has been applied, this includes settling of the limiter offset correction and the Rx or Tx bias
stabilization time. Guaranteed by design.
Note 4: LIMOUT, LIMOUT loaded with 2k ? differential. With no load, the output swing is approximately twice as large.
Note 5: The RSSI maximum intercept is the maximum input power (over a statistical sample of parts) at which the RSSI output is 0V.
This point is extrapolated from the linear portion of the RSSI voltage versus limiter input power. This specification and the
RSSI slope define the ideal behavior of the RSSI function (the slope and intercept of a straight line), while the RSSI relative
error specification defines the deviations from this line. See the RSSI Output Voltage vs. Limiter Input Power graph in the
Typical Operating Characteristics.
Note 6: The RSSI relative error is the deviation from the best-fitting straight line of RSSI output voltage versus limiter input power.
A 0dB relative error is exactly on this line. The limiter input power range for this test is -75dBm to +5dBm from 50 ? . See the
RSSI Relative Error graph in the Typical Operating Characteristics .
Note 7: Operation outside this frequency range is possible but has not been characterized. At lower frequencies, it might be
necessary to overdrive the oscillator with an external signal source.
Note 8: If a larger output level is required, a higher value of load resistance (up to 100 ? ) may be used.
Note 9: This assumes that the supply voltage has been applied, and includes the settling time of V REF , using the Typical
Operating Circuit.
Note 10: Using two tones at 10.7MHz and 10.8MHz, 50mVp-p per tone at TXIN, TXIN . See Typical Operating Characteristics.
4
_______________________________________________________________________________________
相关PDF资料 |
PDF描述 |
|---|---|
| MAX9947ETE+T | TXRX AISG INTEGRATED 16TQFN |
| MAX2511EEI+T | IC TXRX IF W/RSSI&LIMIT 28-QSOP |
| IXFX15N100 | MOSFET N-CH 1KV 15A PLUS247 |
| B82802A0055A325 | TRANSFORMER FLYBACK 36-60V SMD |
| MAX2510EEI+T | IC TXRX IF W/RSSI&MODLTR 28-QSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX2511EEI+ | 功能描述:射频收发器 IF Txr w/Limitr RSSI RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray |
| MAX2511EEI+T | 功能描述:射频收发器 IF Txr w/Limitr RSSI RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray |
| MAX2511EEI-T | 功能描述:射频收发器 IF Txr w/Limitr RSSI RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray |
| MAX2511EVKIT | 功能描述:射频开发工具 MAX2511 Eval Kit RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| MAX2514AWLX#G42 | 制造商:Maxim Integrated Products 功能描述: |
发布紧急采购，3分钟左右您将得到回复。