- 您现在的位置：买卖IC网 > PDF目录18736 > MAX2839ETN+ (Maxim Integrated)IC TXRX MIMO 2.3-2.7GHZ 56TQFN PDF资料下载
参数资料
| 型号： | MAX2839ETN+ |
| 厂商： | Maxim Integrated |
| 文件页数： | 1/26页 |
| 文件大小： | 0K |
| 描述： | IC TXRX MIMO 2.3-2.7GHZ 56TQFN |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 37 |
| 频率： | 2.3GHz ~ 2.7GHz |
| 调制或协议： | 802.16，802.11b/g |
| 应用： | MIMO，WLAN |
| 功率 - 输出： | 0dBm |
| 电源电压： | 2.7 V ~ 3.6 V |
| 电流 - 接收： | 117mA |
| 电流 - 传输： | 140mA |
| 数据接口： | PCB，表面贴装 |
| 天线连接器： | PCB，表面贴装 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 56-WFQFN 裸露焊盘 |
| 包装： | 托盘 |
19-3218; Rev 1; 3/08
2.3GHz to 2.7GHz MIMO Wireless Broadband
RF Transceiver
General Description
The MAX2839 direct conversion, zero-IF, RF transceiver
is designed specifically for 2GHz 802.16e MIMO mobile
WiMAX systems. The device incorporates one transmit-
ter and two receivers, with >40dB isolation between
each receiver. The MAX2839 completely integrates all
circuitry required to implement the RF transceiver func-
tion, providing RF to baseband receive path, and base-
band to RF transmit path, VCO, frequency synthesizer,
crystal oscillator, and baseband/control interface. The
device includes a fast-settling sigma-delta RF synthe-
sizer with smaller than 40Hz frequency steps and a
crystal oscillator that allows the use of a low-cost crystal
in place of a TCXO. The transceiver IC also integrates
circuits for on-chip DC-offset cancellation, I/Q error,
and carrier leakage detection circuits. An internal trans-
mit to receive loopback mode allows for receiver I/Q
imbalance calibration. The local oscillator I/Q quadra-
ture phase error can be digitally corrected in approxi-
mately 0.125° steps. Only an RF bandpass filter (BPF),
crystal, RF switch, PA, and a small number of passive
components are needed to form a complete wireless
broadband RF radio solution.
The MAX2839 completely eliminates the need for an
external SAW filter by implementing on-chip program-
mable monolithic filters for both the receiver and trans-
mitter, for all 2GHz and 802.16e profiles and WIBRO.
The baseband filters along with the Rx and Tx signal
paths are optimized to meet the stringent noise figure
and linearity specifications. The device supports up to
2048 FFT OFDM and implements programmable chan-
nel filters for 3.5MHz to 20MHz RF channel bandwidths.
The transceiver requires only 2μs Tx-Rx switching time.
The IC is available in a small 56-pin TQFN package
measuring 8mm x 8mm x 0.8mm.
Applications
802.16e Mobile WiMAX? Systems
Korean WIBRO Systems
Features
? 2.3GHz to 2.7GHz Wideband Operation
? Dual Receivers for MIMO, Single Transmitter
? Complete RF Transceiver, PA Driver, and Crystal
Oscillator
2.3dB Rx Noise Figure on Each Receiver
-35dB Rx EVM for 64QAM Signal
0dBm Linear OFDM Transmit Power (64QAM)
-70dBr Tx Spectral Emission Mask
-35dBc LO Leakage
Automatic Rx DC Offset Correction
Monolithic Low-Noise VCO with -39dBc
Integrated Phase Noise
Programmable Rx I/Q Lowpass Channel Filters
Programmable Tx I/Q Lowpass Anti-Aliasing
Filters
Sigma-Delta Fractional-N PLL with < 40Hz Step
62dB Tx Gain Control Range with 1dB Step
Size, Digitally Controlled
95dB Rx Gain Control Range with 1dB Step
Size, Digitally Controlled
60dB Analog RSSI Instantaneous Dynamic
Range
4-Wire SPI? Digital Interface
I/Q Analog Baseband Interface
Digital Tx/Rx Mode Control
Digitally Tuned Crystal Oscillator
On-Chip Digital Temperature Sensor Readout
? +2.7V to +3.6V Transceiver Supply
? Low-Power Shutdown Current
? Small, 56-Pin TQFN Package (8mm x 8mm x
0.8mm)
Ordering Information
Proprietary Wireless Broadband Systems
PART
TEMP RANGE
PIN-
PACKAGE
PKG
CODE
802.11g or n WLAN with MRC or MIMO Down Link
MAX2839ETN+TD -40°C to +85°C 56 TQFN-EP*
T5688+2
+Denotes a lead-free package.
T = Tape and reel.
*EP = Exposed paddle.
D = Dry pack.
WiMAX is a trademark of the WiMAX Forum.
SPI is a trademark of Motorola, Inc.
Pin Configuration and Block Diagram/Typical Operating
Circuit appear at end of data sheet.
________________________________________________________________ Maxim Integrated Products
For pricing, delivery, and ordering information, please contact Maxim Direct at 1-888-629-4642,
or visit Maxim’s website at www.maxim-ic.com.
1
相关PDF资料 |
PDF描述 |
|---|---|
| 3-582340-0 | TEST PROBE ASSY 2LEGS GOLD |
| MAX2838ETM+ | IC TXRX RF BROADBAND 48-TQFN |
| MAX2839ETN+T | IC TXRX MIMO 2.3-2.7GHZ 56TQFN |
| ASOF3S3-010.0M | OSC OCXO 10.0000MHZ 3.3V SMD |
| B82802A0030A320 | TRANSFORMER FLYBACK 36-60V SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX2839ETN+ | 功能描述:射频收发器 2.3-2.7GHz Wireless Broadband RF Txr RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray |
| MAX2839ETN+D | 功能描述:射频收发器 RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray |
| MAX2839ETN+T | 功能描述:射频收发器 2.3-2.7GHz Wireless Broadband RF Txr RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray |
| MAX2839ETN+TD | 功能描述:射频收发器 RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray |
| MAX2839EVKIT+ | 功能描述:WiFi/802.11开发工具 MAX2839 Eval Kit RoHS:否 制造商:Roving Networks 产品:Evaluation Boards 工具用于评估:RN-171 支持协议:802.11 b/g 频率:2.4 GHz 接口类型:UART 工作电源电压:2 V to 16 V |
发布紧急采购，3分钟左右您将得到回复。