- 您现在的位置：买卖IC网 > Datasheet目录473 > MAX2839EVKIT+ (Maxim Integrated)KIT EVAL FOR MAX2839 Datasheet资料下载
参数资料
| 型号： | MAX2839EVKIT+ |
| 厂商： | Maxim Integrated |
| 文件页数： | 9/26页 |
| 文件大小： | 0K |
| 描述： | KIT EVAL FOR MAX2839 |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 1 |
| 类型： | 收发器，802.11g/n，802.16 |
| 频率： | 2.3GHz ~ 2.7GHz |
| 适用于相关产品： | MAX2839 |
| 已供物品： | 板 |
2.3GHz to 2.7GHz MIMO Wireless Broadband
RF Transceiver
AC ELECTRICAL CHARACTERISTICS TABLE—TIMING (continued)
(MAX2839 Evaluation Kit, V CC_ = 2.8V, f LO = 2.5GHz, f REF = 40MHz, CS = high, SCLK = DIN = low, 3dB PLL noise bandwidth =
120kHz, and T A = +25°C, unless otherwise noted.) (Note 1)
PARAMETER
SYMBOL
CONDITIONS
MIN
TYP
MAX
UNITS
LOAD Falling Edge Setup Time
LOAD Falling Edge Hold Time
LOAD Rise and Fall Time
B7:B0 stable to LOAD falling edge
LOAD falling edge to B7:B0 stable
Between 10% and 90% of static levels
10
10
100
ns
ns
ns
4-WIRE SERIAL PARALLEL INTERFACE TIMING (see Figure 1)
SCLK Rising Edge to CS Falling
Edge Wait Time
Falling Edge of CS to Rising
Edge of First SCLK Time
DIN to SCLK Setup Time
DIN to SCLK Hold Time
SCLK Pulse-Width High
SCLK Pulse-Width Low
t CSO
t CSS
t DS
t DH
t CH
t CL
6
6
6
6
6
6
ns
ns
ns
ns
ns
ns
Last Rising Edge of SCLK to
Rising Edge of CS or Clock to
t CSH
6
ns
Load Enable Setup Time
CS High Pulse Width
t CSW
20
ns
Time Between Rising Edge of CS
and the Next Rising Edge of
t CS1
6
ns
SCLK
Clock Frequency
Rise Time
Fall Time
SCLK Falling Edge to Valid DOUT
f CLK
t R
t F
t D
0.1/f CLK
0.1/f CLK
12.5
45
MHz
ns
ns
ns
Note 1: Min/max limits are production tested at T A = +85°C. Min/max limits at T A = -40°C and T A = +25°C are guaranteed by
design and characterization. The power-on register settings are not production tested. Load register setting 500ns after
V CC is applied.
Note 2: Two tones at +20MHz and +39MHz offset with -35dBm/tone. Measure IM3 at 1MHz.
Note 3: Gain adjusted over max gain and max gain -3dB. Optimally matched over given 200MHz band.
Note 4: Tx mode supply current is specified for 64 QAM while achieving the Tx output spectrum mask shown in the Typical Operating
Characteristics. The supply current can be reduced for 16 QAM signal by adjusting the Tx bias settings through the SPI.
_______________________________________________________________________________________
9
相关PDF资料 |
PDF描述 |
|---|---|
| MAX2851ITK+ | TRANSMITTER MIMO 5GHZ 5CH 68TQFN |
| MAX2852ITK+ | IC RECEIVER DFS 5GHZ 68TQFN |
| MAX2870EVKIT# | EVAL KIT MAX2870 |
| MAX2904EVKIT | EVAL KIT |
| MAX3524EVKIT | EVAL KIT MAX3524 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX2839EVKIT+ | 功能描述:WiFi/802.11开发工具 MAX2839 Eval Kit RoHS:否 制造商:Roving Networks 产品:Evaluation Boards 工具用于评估:RN-171 支持协议:802.11 b/g 频率:2.4 GHz 接口类型:UART 工作电源电压:2 V to 16 V |
| MAX283X-RD0089 | 制造商:Maxim Integrated Products 功能描述:INTERFACE BOARD - Bulk |
| MAX2842ETN+ | 制造商:Maxim Integrated Products 功能描述:3.3-3.9GHZ MIMO WIMAX RF TRANSCEIVER - Rail/Tube |
| MAX2842ETN+T | 制造商:Maxim Integrated Products 功能描述:3.3-3.9GHZ MIMO WIMAX RF TRANSCEIVER - Tape and Reel |
| MAX2850EVKIT+ | 制造商:Maxim Integrated Products 功能描述:EVKIT FOR MAX2850 - Boxed Product (Development Kits) |
发布紧急采购，3分钟左右您将得到回复。