- 您现在的位置：买卖IC网 > PDF目录18800 > MAX2904ETI+T (Maxim Integrated)IC TX 868MHZ 200MW 28TQFN PDF资料下载
参数资料
| 型号： | MAX2904ETI+T |
| 厂商： | Maxim Integrated |
| 文件页数： | 11/17页 |
| 文件大小： | 0K |
| 描述： | IC TX 868MHZ 200MW 28TQFN |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 2,500 |
| 频率： | 868MHz，915MHz |
| 应用： | ISM |
| 调制或协议： | ASK，BPSK |
| 功率 - 输出： | 20dBm |
| 电流 - 传输： | 200mA |
| 数据接口： | PCB，表面贴装 |
| 天线连接器： | PCB，表面贴装 |
| 电源电压： | 2.7 V ~ 4.5 V |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 28-WFQFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
MAX2900–MAX2904
200mW Single-Chip Transmitter ICs for
868MHz/915MHz ISM Bands
used on the EV kit board for +23dBm output power at
4.5V, and 22k Ω is also recommended for +20dBm out-
put power at +3.0V. For +17dBm at 3.0V, 36k Ω is rec-
ommended. The current consumption, efficiency, and
distortion in the amplification chain are affected by the
choice of the resistor RPWRSET, offering a lot of design
flexibility.
TO VREG
(2.1V)
TO INTERNAL
CONTROL
The RLPF pin sets the bandwidth of the modulation fil-
ter. The default filter bandwidth, obtained with a 68k Ω
resistor, is for 1.2Mchips/s. The bandwidth is increased
to accommodate 5Mchips/s by decreasing the resistor
value to about 26k Ω . The minimum value for the resistor
is 12k Ω , which generates the maximum filter band-
width. A higher value can be used in FM mode to set
up a slow ramp-up time for the PA.
Data Filter Characteristics
The data filter approximates a 3rd-order Butterworth fil-
ter. The 3dB cut-off frequency is adjusted through the
resistor on pin RLPF, which controls the first two poles
CIRCUIT
PIN
VASK
EXTERNAL
RESISTOR
of the filter (the last high-frequency pole is fixed and set
around 10MHz). The filter is adjustable in a range from
1.5V
>200k Ω
INTERNAL
CIRCUITS
BRIDGE
approximately 700kHz to 7MHz.
With the nominal setting (3dB cut off at 0.8MHz), the fil-
ter attenuation is 10dB at 3.6MHz. If used with a BPSK
at 1.22MHz, this provides about 30dB of modulation
rolloff at 3.6MHz. Hence, a significant channelization
Figure 2. PIN VASK Equivalent Circuit
The VASK pin is an input to the internal gain control cir-
cuitry. The gain control is greater than 30dB over the
full range of input voltages from 0 to VREG = 2.1V. This
input is used for ASK modulation. At 1V, a typical 15dB
attenuation is obtained from the peak power. When this
input is not used, connect VASK to VREG.
The RLPF input controls the modulation filter center fre-
quency.
TO INTERNAL
CONTROL
effect is obtained.
In the wideband setting (3dB cut off at 5MHz), the
attenuation at 30MHz is still 30dB, helping to pass the
FCC spurious emissions at 960MHz.
CIRCUIT
PIN RLPF
1.2V
100 Ω
INTERNAL
CIRCUITS
EXTERNAL
RESISTOR
Figure 3. PIN RLPF Equivalent Circuit
Maxim Integrated
11
相关PDF资料 |
PDF描述 |
|---|---|
| MAX2903ETI+T | IC TX 868MHZ 200MW 28TQFN |
| LP-12-1900 | XFRMR PWR 115/230V 6.3VAC 3.8A |
| MAX2900ETI+T | IC TX 915MHZ 200MW 28TQFN |
| LP-20-1200 | XFRMR PWR 115/230V 10VAC 2.4A |
| LP-30-800 | XFRMR PWR 115/230V 15VAC 1.6A |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX2904EVKIT | 功能描述:射频开发工具 MAX2900-04 Eval Kit RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| MAX291C/D | 功能描述:有源滤波器 DICE SALES DICE RoHS:否 制造商:Maxim Integrated 通道数量:1 截止频率:150 KHz 电源电压-最大:11 V 电源电压-最小:4.74 V 最大工作温度:+ 85 C 安装风格:Through Hole 封装 / 箱体:PDIP N 封装:Tube |
| MAX291CPA | 功能描述:有源滤波器 Integrated Circuits (ICs) RoHS:否 制造商:Maxim Integrated 通道数量:1 截止频率:150 KHz 电源电压-最大:11 V 电源电压-最小:4.74 V 最大工作温度:+ 85 C 安装风格:Through Hole 封装 / 箱体:PDIP N 封装:Tube |
| MAX291CPA+ | 功能描述:有源滤波器 8th-Order Lowpass Switched-Cap RoHS:否 制造商:Maxim Integrated 通道数量:1 截止频率:150 KHz 电源电压-最大:11 V 电源电压-最小:4.74 V 最大工作温度:+ 85 C 安装风格:Through Hole 封装 / 箱体:PDIP N 封装:Tube |
| MAX291CSA | 功能描述:有源滤波器 Integrated Circuits (ICs) RoHS:否 制造商:Maxim Integrated 通道数量:1 截止频率:150 KHz 电源电压-最大:11 V 电源电压-最小:4.74 V 最大工作温度:+ 85 C 安装风格:Through Hole 封装 / 箱体:PDIP N 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。