- 您现在的位置：买卖IC网 > PDF目录11810 > MAX3109ETJ+T (Maxim Integrated Products)IC UART PDF资料下载
参数资料
| 型号： | MAX3109ETJ+T |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 20/66页 |
| 文件大小： | 0K |
| 描述： | IC UART |
| 产品培训模块： | Obsolescence Mitigation Program |
| 标准包装： | 2,500 |
| 系列： | * |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页当前第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页
Dual Serial UART with 128-Word FIFOs
MAX3109
27
Maxim Integrated
Shutdown Mode
Drive the RST input to logic-low to enter shutdown mode.
Shutdown mode consumes less than 1FA. In shutdown
mode, all the MAX3109 circuitry is completely off. This
includes the I2C/SPI interface, the registers, the FIFOs,
and the clocking circuitry.
When the RST input transitions from low to high, the
MAX3109 exits shutdown mode and a hardware reset
is initiated. The chip initialization is complete when the
I2C/SPI controller is able to read out known register con-
tents from the MAX3109. This could, for example, be the
DIVLSB register.
The MAX3109 needs to be reprogrammed following a
shutdown.
Power-Up and IRQ
The IRQ output only operates when all supplies are
active. IRQ operates as a hardware active-low interrupt
output; IRQ is asserted when an interrupt is pending. An
IRQ interrupt is only possible during normal operation
if at least one of the interrupt enable bits in the IRQEn
register is set.
In polled mode, any register with a known reset value
can be polled to check whether the MAX3109 is ready for
operation. If the controller gets a valid response from the
polled register, then the MAX3109 is ready for operation.
Interrupt Structure
Figure 16 shows the structure of the interrupt. There are
four interrupt source registers: ISR, LSR, STSInt, and
SpclCharInt. The interrupt sources are divided into top-
level and low-level interrupts. The top-level interrupts
typically occur more often and can be read out by the
host controller directly through ISR. The low-level inter-
rupts typically occur less often and their specific source
can be read out by the host controller through LSR,
STSInt, or SpclCharInt. The three LSBs of ISR point to
the low-level interrupt registers that contain the details of
the interrupt source.
Interrupt Enabling
Every interrupt bit of the four interrupt registers can be
enabled or masked through an associated interrupt
enable register bit. These are the IRQEn, LSRIntEn,
SpclChrIntEn, and STSIntEn registers. By default, all
interrupts are masked.
Interrupt Clearing
When an interrupt is pending (i.e., IRQ is asserted) and
ISR is read, both the ISR bits are cleared and the IRQ
output is deasserted. Low-level interrupt information
does not reassert IRQ for the same interrupt, but remains
stored in the low-level interrupt registers until each is
separately cleared. SpclCharInt and STSInt are clear-
on-read (COR). The LSR bits are only cleared when the
source of the interrupt is removed, not when LSR is read.
Figure 16. Simplified Interrupt Structure
0
IRQ1 IRQ0
GlobalIRQ
8
7
6
5
4
3
2
1
0
ISR
7
6
5
4
3
2
1
0
ISR
8
[1]
IRQ
[0]
LOW-LEVEL INTERRUPTS
TOP-LEVEL INTERRUPTS
7
6
5
4
3
2
1
0
SpclCharInt
8
7
6
5
4
3
2
1
0
STSInt
8
7
6
5
4
3
2
1
0
LSR
8
相关PDF资料 |
PDF描述 |
|---|---|
| MS27484T14A15S | CONN PLUG 15POS STRAIGHT W/SCKT |
| 1812PC224MAT3A | CAP CER 0.22UF 250V 20% X7R 1812 |
| VI-J5L-IW-F2 | CONVERTER MOD DC/DC 28V 100W |
| VI-J5L-IW-F1 | CONVERTER MOD DC/DC 28V 100W |
| MS27468E17F8P | CONN RCPT 8POS JAM NUT W/PINS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX310C/D | 功能描述:多路器开关 IC RoHS:否 制造商:Texas Instruments 通道数量:1 开关数量:4 开启电阻（最大值）:7 Ohms 开启时间（最大值）: 关闭时间（最大值）: 传播延迟时间:0.25 ns 工作电源电压:2.3 V to 3.6 V 工作电源电流: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:UQFN-16 |
| MAX310CPE | 功能描述:多路器开关 IC RoHS:否 制造商:Texas Instruments 通道数量:1 开关数量:4 开启电阻（最大值）:7 Ohms 开启时间（最大值）: 关闭时间（最大值）: 传播延迟时间:0.25 ns 工作电源电压:2.3 V to 3.6 V 工作电源电流: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:UQFN-16 |
| MAX310CPE+ | 功能描述:多路器开关 IC 8:1 Unbuffered RF Video MUX RoHS:否 制造商:Texas Instruments 通道数量:1 开关数量:4 开启电阻（最大值）:7 Ohms 开启时间（最大值）: 关闭时间（最大值）: 传播延迟时间:0.25 ns 工作电源电压:2.3 V to 3.6 V 工作电源电流: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:UQFN-16 |
| MAX310CWN | 功能描述:多路器开关 IC RoHS:否 制造商:Texas Instruments 通道数量:1 开关数量:4 开启电阻（最大值）:7 Ohms 开启时间（最大值）: 关闭时间（最大值）: 传播延迟时间:0.25 ns 工作电源电压:2.3 V to 3.6 V 工作电源电流: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:UQFN-16 |
| MAX310CWN+ | 功能描述:多路器开关 IC 8:1 Unbuffered RF Video MUX RoHS:否 制造商:Texas Instruments 通道数量:1 开关数量:4 开启电阻（最大值）:7 Ohms 开启时间（最大值）: 关闭时间（最大值）: 传播延迟时间:0.25 ns 工作电源电压:2.3 V to 3.6 V 工作电源电流: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:UQFN-16 |
发布紧急采购，3分钟左右您将得到回复。