- 您现在的位置：买卖IC网 > PDF目录9538 > MAX3386ECUP (Maxim Integrated Products)IC TXRX RS232 250KBPS 20-TSSOP PDF资料下载
参数资料
| 型号： | MAX3386ECUP |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 10/11页 |
| 文件大小： | 0K |
| 描述： | IC TXRX RS232 250KBPS 20-TSSOP |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 74 |
| 类型： | 收发器 |
| 驱动器/接收器数： | 3/2 |
| 规程： | RS232 |
| 电源电压： | 3 V ~ 5.5 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 20-TSSOP |
| 包装： | 管件 |
Machine Model
The Machine Model for ESD tests all pins using a
200pF storage capacitor and zero discharge resis-
tance. Its objective is to emulate the stress caused by
contact that occurs with handling and assembly during
manufacturing. All pins require this protection during
manufacturing, not just RS-232 inputs and outputs.
Therefore, after PC board assembly, the Machine
Model is less relevant to I/O ports.
__________Applications Information
Capacitor Selection
The capacitor type used for C1–C4 is not critical for
proper operation; polarized or nonpolarized capacitors
can be used. The charge pump requires 0.1F capacitors
for 3.3V operation. For other supply voltages, see
Table 2 for required capacitor values. Do not use values
smaller than those listed in Table 2. Increasing the
capacitor values (e.g., by a factor of 2) reduces ripple
on the transmitter outputs and slightly reduces power
consumption. C2, C3, and C4 can be increased without
changing C1’s value. However, do not increase C1
without also increasing the values of C2, C3, and C4 to
maintain the proper ratios (C1 to the other capacitors).
When using the minimum required capacitor values,
make sure the capacitor value does not degrade
excessively with temperature. If in doubt, use capacitors
with a larger nominal value. The capacitor’s equivalent
series resistance (ESR), which usually rises at low tem-
peratures, influences the amount of ripple on V+ and V-.
Power-Supply Decoupling
In most circumstances, a 0.1F bypass capacitor is
adequate. In applications that are sensitive to power-
supply noise, decouple VCC to ground with a capacitor of
the same value as charge-pump capacitor C1. Connect
bypass capacitors as close to the IC as possible.
Operation Down to 2.7V
Transmitter outputs will meet EIA/TIA-562 levels of
±3.7V with supply voltages as low as +2.7V.
Transmitter Outputs when
Exiting Shutdown
Figure 2 shows two transmitter outputs when exiting
shutdown mode. As they become active, the two
transmitter outputs are shown going to opposite RS-232
levels (one transmitter input is high; the other is low).
Each transmitter is loaded with 3k
in parallel with
2500pF. The transmitter outputs display no ringing or
undesirable transients as they come out of shutdown.
Note that the transmitters are enabled only when the
magnitude of V- exceeds approximately 3V.
MAX3386E
3.0V, ±25kV ESD-Protected RS-232
Transceiver for PDAs and Cell Phones
8
_______________________________________________________________________________________
CHARGE-CURRENT
LIMIT RESISTOR
DISCHARGE
RESISTANCE
STORAGE
CAPACITOR
Cs
150pF
RC
50M
to 100M
RD
330
HIGH-
VOLTAGE
DC
SOURCE
DEVICE
UNDER
TEST
Figure 4a. IEC 1000-4-2 ESD Test Model
tR = 0.7ns to 1ns
30ns
60ns
t
100%
90%
10%
I PEAK
I
Figure 4b. IEC 1000-4-2 ESD Generator Current Waveform
VCC
(V)
0.1
C2, C3, C4
(F)
3.0 to 3.6
0.33
0.047
1
0.22
3.0 to 5.5
4.5 to 5.5
C1
(F)
Table 2. Minimum Required Capacitor
Values
相关PDF资料 |
PDF描述 |
|---|---|
| V24A8M300B | CONVERTER MOD DC/DC 8V 300W |
| MS3450L18-8SW | CONN RCPT 8POS WALL MNT W/SCKT |
| MAX3385ECAP | IC TXRX LP RS232 250KBPS 20-SSOP |
| MS3450L18-8S | CONN RCPT 8POS WALL MNT W/SCKT |
| VE-2N0-IW-B1 | CONVERTER MOD DC/DC 5V 100W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX3386ECUP+ | 功能描述:RS-232接口集成电路 3V Transceiver for PDAs & Cells RoHS:否 制造商:Exar 数据速率:52 Mbps 工作电源电压:5 V 电源电流:300 mA 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体:LQFP-100 封装: |
| MAX3386ECUP+T | 功能描述:RS-232接口集成电路 3V Transceiver for PDAs & Cells RoHS:否 制造商:Exar 数据速率:52 Mbps 工作电源电压:5 V 电源电流:300 mA 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体:LQFP-100 封装: |
| MAX3386ECUP-T | 功能描述:RS-232接口集成电路 RoHS:否 制造商:Exar 数据速率:52 Mbps 工作电源电压:5 V 电源电流:300 mA 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体:LQFP-100 封装: |
| MAX3386EEUP | 功能描述:RS-232接口集成电路 RoHS:否 制造商:Exar 数据速率:52 Mbps 工作电源电压:5 V 电源电流:300 mA 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体:LQFP-100 封装: |
| MAX3386EEUP+ | 功能描述:RS-232接口集成电路 3V Transceiver for PDAs & Cells RoHS:否 制造商:Exar 数据速率:52 Mbps 工作电源电压:5 V 电源电流:300 mA 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体:LQFP-100 封装: |
发布紧急采购，3分钟左右您将得到回复。