- 您现在的位置：买卖IC网 > PDF目录18740 > MAX4001EUA+ (Maxim Integrated)IC CNTRLR RF-DETECT 8-MSOP PDF资料下载
参数资料
| 型号： | MAX4001EUA+ |
| 厂商： | Maxim Integrated |
| 文件页数： | 14/19页 |
| 文件大小： | 0K |
| 描述： | IC CNTRLR RF-DETECT 8-MSOP |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 50 |
| 频率： | 2.5GHz |
| RF 型： | 手机，CDMA，GSM |
| 输入范围： | -35dBm ~ 10dBm |
| 电源电压： | 2.7 V ~ 5.5 V |
| 电流 - 电源： | 9.3mA |
| 包装： | 管件 |
| 封装/外壳： | 8-TSSOP，8-MSOP（0.118"，3.00mm 宽） |
2.5GHz 45dB RF-Detecting Controllers
and does not require external AC-coupling. Achieve
50 Ω input matching by connecting a 50 Ω resistor
between RFIN and ground. See the Typical Operating
Characteristics section for a plot of Input Impedance vs.
Frequency. See the Additional Input Coupling section
80
60
40
GAIN AND PHASE vs. FREQUENCY
MAX4000 fig03
GAIN
C F = 2000pF
180
135
90
for other coupling methods.
The MAX4000/MAX4001/MAX4002 log amps function
as both the detector and controller in power-control
loops. Use a directional coupler to couple a portion of
the PA’s output power to the log amp’s RF input. In
applications requiring dual-mode operation where there
20
0
-20
-40
-60
C F = 200pF
C F = 2000pF
C F = 200pF
45
0
-45
-90
-135
are two PAs and two directional couplers, passively
combine the outputs of the directional couplers before
applying to the log amp. Apply a set-point voltage to
SET from a controlling source (usually a DAC). OUT,
which drives the automatic gain-control pin of the PA,
-80
-100
10
100
1k
10k 100k
FREQUENCY (Hz)
PHASE
1M 10M 100M
-180
-225
corrects any inequality between the RF input level and
the corresponding set-point level. This is valid assum-
ing the gain control of the variable gain element is posi-
tive, such that increasing OUT voltage increases gain.
OUT voltage can range from 150mV to within 250mV of
the supply rail while sourcing 10mA. Use a suitable
load resistor between OUT and GND for PA control
inputs that source current. The Typical Operating
Characteristics section has a plot of the sourcing capa-
bilities and output swing of OUT.
SHDN and Power-On
The MAX4000/MAX4001/MAX4002 can be placed in
shutdown by pulling SHDN to ground. SHDN reduces
supply current to typically 13μA. A graph of SHDN
Response is included in the Typical Operating
Characteristics section. Connect SHDN and V CC
together for continuous on-operation.
Power Convention
Expressing power in dBm, decibels above 1mW, is the
most common convention in RF systems. Log amp
input levels specified in terms of power are a result of
following common convention. Note that input power
does not refer to power, but rather to input voltage rela-
tive to a 50 Ω impedance. Use of dBV, decibels with
respect to a 1V RMS sine wave, yields a less ambiguous
result. The dBV convention has its own pitfalls in that
log amp response is also dependent on waveform. A
complex input such as CDMA does not have the exact
same output response as the sinusoidal signal. The
MAX4000/MAX4001/MAX4002 performance specifica-
tions are in both dBV and dBm, with equivalent dBm
levels for a 50 Ω environment. To convert dBV values
into dBm in a 50 Ω network, add 13dB.
Figure 3. Gain and Phase vs. Frequency Graph
Filter Capacitor and Transient Response
In general, the choice of filter capacitor only partially
determines the time-domain response of a PA control
loop. However, some simple conventions can be
applied to affect transient response. A large filter
capacitor, C F , dominates time-domain response, but
the loop bandwidth remains a factor of the PA gain-
control range. The bandwidth is maximized at power
outputs near the center of the PA’s range, and mini-
mized at the low and high power levels, where the
slope of the gain-control curve is lowest.
A smaller valued C F results in an increased loop band-
width inversely proportional to the capacitor value.
Inherent phase lag in the PA’s control path, usually
caused by parasitics at the OUT pin, ultimately results
in the addition of complex poles in the AC loop equa-
tion. To avoid this secondary effect, experimentally
determine the lowest usable C F for the power amplifier
of interest. This requires full consideration to the intrica-
cies of the PA control function. The worst-case condi-
tion, where the PA output is smallest (gain function is
steepest), should be used because the PA control
function is typically nonlinear. An additional zero can
be added to improve loop dynamics by placing a resis-
tor in series with C F . See Figure 3 for the gain and
phase response for different C F values.
Additional Input Coupling
There are three common methods for input coupling:
broadband resistive, narrowband reactive, and series
attenuation. A broadband resistive match is implemented
by connecting a resistor to ground at RFIN as shown in
Figure 4a. A 50 Ω resistor (use other values for different
input impedances) in this configuration in parallel with the
input impedance of the MAX4000 presents an input
14
______________________________________________________________________________________
相关PDF资料 |
PDF描述 |
|---|---|
| GLCA04A1B | SWITCH SIDE-ROTRY W/ROLL SLO ACT |
| MPI-900-16 | XFRMR 8V 112.5A 900VA |
| MPI-900-12 | XFRMR 6V 150A 900VA |
| MPI-900-10 | XFRMR 5V 180A 900VA |
| XBP24-Z7SIT-004 | MODULE ZIGBEE-PRO W/RPSMA ANT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX4001EUA+ | 功能描述:射频检测器 2.5GHz 45dB RF Detecting Ctlr RoHS:否 制造商:Skyworks Solutions, Inc. 配置: 频率范围:650 MHz to 3 GHz 最大二极管电容: 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:SC-88 封装:Reel |
| MAX4001EUA+T | 功能描述:射频检测器 2.5GHz 45dB RF Detecting Ctlr RoHS:否 制造商:Skyworks Solutions, Inc. 配置: 频率范围:650 MHz to 3 GHz 最大二极管电容: 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:SC-88 封装:Reel |
| MAX4001EUA-T | 功能描述:射频检测器 2.5GHz 45dB RF Detecting Ctlr RoHS:否 制造商:Skyworks Solutions, Inc. 配置: 频率范围:650 MHz to 3 GHz 最大二极管电容: 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:SC-88 封装:Reel |
| MAX4001EVKIT | 功能描述:射频开发工具 2.5GHz 45dB RF Detecting Ctlr RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| MAX4002 | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:2.5GHz 45dB RF-Detecting Controllers |
发布紧急采购，3分钟左右您将得到回复。