- 您现在的位置：买卖IC网 > PDF目录2157 > MAX4069AUB+T (Maxim Integrated Products)IC AMP CURRENT SENSE 10-UMAX PDF资料下载
参数资料
| 型号： | MAX4069AUB+T |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 4/18页 |
| 文件大小： | 0K |
| 描述： | IC AMP CURRENT SENSE 10-UMAX |
| 其它有关文件： | Automotive Product Guide |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 2,500 |
| 放大器类型： | 电流检测 |
| 电路数： | 1 |
| -3db带宽： | 100kHz |
| 电流 - 输入偏压： | 2.4µA |
| 电压 - 输入偏移： | 80µV |
| 电流 - 电源： | 100µA |
| 电压 - 电源，单路/双路(±)： | 2.7 V ~ 24 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-TFSOP，10-MSOP（0.118"，3.00mm 宽） |
| 供应商设备封装： | 10-µMAX |
| 包装： | 带卷 (TR) |
Bidirectional, High-Side, Current-Sense
Amplifiers with Reference
core, as in metal-film or wire-wound resistors, they are
a straight band of metal and are available in values
under 1Ω.
Peak Current:
The maximum current through RSENSE
must be limited to:
IPEAK = 0.3V / (RSENSE + RTRACE)
where RTRACE is the total stray resistance from RS+
and RS- to RSENSE. To prevent forwarding the back-to-
back diodes between the differential input, the absolute
maximum of the differential input voltage is 0.3V.
Dynamic Range Considerations
Although the MAX4069–MAX4072 have fully symmetri-
cal, bidirectional, VSENSE input capability, the output-
voltage range is usually higher from REF to VCC and
lower from REF to GND (unless the supply voltage is at
the lowest end of the operating range). Therefore, the
user must consider the dynamic range of current moni-
tored in both directions and choose the supply voltage
and the reference voltage (REFOUT or REFIN) to make
sure the output swing above and below REF is ade-
quate to handle the swings without clipping or running
out of headroom.
Shutdown Mode
When SHDN is low, the MAX4069–MAX4072 are shut
down and consume only 10A. In shutdown mode,
OUT is high impedance and turns off. Connect SHDN
to VCC for normal operation.
Power-Supply Bypassing
and Grounding
The MAX4069–MAX4072 do not require special
bypassing and respond quickly to transient changes in
line current. You can place a large capacitor at the RS-
terminal (or “load” side) to decouple the load and,
thereby, reduce the current transients. These capaci-
tors are not required for operation or stability and their
use does not degrade performance.
The MAX4069–MAX4072 have been designed as a high-
side current monitor to ease the task of grounding any
battery charger, thermistor, etc., that may be a part of
the battery pack. Grounding these devices requires no
special precautions; follow the same cautionary steps
that apply to the system as a whole. High-current sys-
tems can experience large voltage drops across a
ground plane, and this drop may add to or subtract from
VOUT. Using differential measurement between VOUT
and REF prevents this problem. For highest current-mea-
surement accuracy, use a single-point star ground.
On thin QFN packages, there is an exposed paddle that
does not carry any current, but should also be connect-
ed to the ground plane for rated power dissipation.
FULL-SCALE
CURRENT
(A)
CURRENT-SENSE
RESISTOR (m
Ω)
GAIN
(V/V)
VSENSE
(mV)
FULL-SCALE OUTPUT
VOLTAGE WITH RESPECT
TO REF (V)
0.075
50
75
3.75
0.05
1000
100
50
5.0
0.75
50
75
3.75
0.5
100
50
5.0
3.75
50
75
3.75
2.5
20
100
50
5.0
7.5
50
75
3.75
5.0
10
100
50
5.0
15.0
50
75
3.75
10.0
5
100
50
5.0
Table 1. Recommended Component Values
MAX4069–MAX4072
12
Maxim Integrated
相关PDF资料 |
PDF描述 |
|---|---|
| MAX4073HAUT+T | IC AMP CURRENT SENSE SOT23-6 |
| MAX4075BNEUA+T | IC OPAMP DUAL GAIN R/R 8UMAX |
| MAX4080TAUA/V+T | IC AMP CURRENT SENSE 8UMAX |
| MAX4092ASA+ | IC OP AMP DUAL R-R 8-SOIC |
| MAX4117ESA+T | IC AMP CURRENT FB LP 8-SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX4069-MAX4072 | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Bidirectional, High-Side, Current-Sense Amplifiers with Reference |
| MAX406A | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:1.2レA Max, Single/Dual/Quad, Single-Supply Op Amps |
| MAX406AC/D | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:1.2レA Max, Single/Dual/Quad, Single-Supply Op Amps |
| MAX406ACPA | 功能描述:运算放大器 - 运放 RoHS:否 制造商:STMicroelectronics 通道数量:4 共模抑制比（最小值）:63 dB 输入补偿电压:1 mV 输入偏流（最大值）:10 pA 工作电源电压:2.7 V to 5.5 V 安装风格:SMD/SMT 封装 / 箱体:QFN-16 转换速度:0.89 V/us 关闭:No 输出电流:55 mA 最大工作温度:+ 125 C 封装:Reel |
| MAX406ACPA+ | 功能描述:运算放大器 - 运放 RoHS:否 制造商:STMicroelectronics 通道数量:4 共模抑制比（最小值）:63 dB 输入补偿电压:1 mV 输入偏流（最大值）:10 pA 工作电源电压:2.7 V to 5.5 V 安装风格:SMD/SMT 封装 / 箱体:QFN-16 转换速度:0.89 V/us 关闭:No 输出电流:55 mA 最大工作温度:+ 125 C 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。