参数资料
| 型号： | MAX4193CSA+T |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 8/14页 |
| 文件大小： | 0K |
| 描述： | IC REG BOOST 525MA 8SOIC |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 2,500 |
| 类型： | 升压（升压） |
| 输出数： | 1 |
| 输入电压： | 2 V ~ 16.5 V |
| 频率 - 开关： | 25kHz |
| 电流 - 输出： | 525mA |
| 同步整流器： | 无 |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 8-SOIC |
CMOS Micropower Step-Up
Switching Regulator
V ESR PK x ESR = ? IN ? xESR ( Voltsp ? p )
? V ?
? 2 Lf ?
Filter Capacitor
The output-voltage ripple has two components, with
approximately 90 degrees phase difference between
them. One component is created by the change in the
capacitor’s stored charge with each output pulse. The
other ripple component is the product of the capacitor’s
charge/discharge current and its effective series resis-
tance (ESR). With low-cost aluminum electrolytic
capacitors, the ESR-produced ripple is generally larger
than that caused by the change in charge.
= I
where V IN is the coil input voltage, L is its inductance, f
is the oscillator frequency, and ESR is the equivalent
series resistance of the filter capacitor.
The output ripple resulting from the change in charge
on the filter capacitor is:
When large values (>50k Ω ) are used for the voltage-
setting resistors, R1 and R2 of Figure 1, stray capaci-
tance at the V FB input can add a lag to the feedback
response, destabilizing the regulator, increasing low-
frequency ripple, and lowering efficiency. This can
often be avoided by minimizing the stray capacitance
at the V FB node. It can also be remedied by adding a
lead compensation capacitor of 100pF to 10nF in paral-
lel with R1 in Figure 1.
DC-DC Converter Configurations
DC-DC converters come in three basic topologies:
buck, boost, and buck-boost (Figure 2). The MAX630 is
usually operated in the positive-voltage boost circuit,
where the output voltage is greater than the input.
The boost circuit is used where the input voltage is
always less than the desired output and the buck circuit
is used where the input is greater than the output. The
buck-boost circuit inverts, and can be used with, input
where , Q = t DIS x PEAK
V dQ =
Q
C
I
2
BOOST CONVERTER
and , I PEAK = t CHG x
V IN
L
+
V dQ =
V IN ( t CHG )( t DIS )
2 LC
V BATT
S 1
CONTROL
SECTION
V OUT > V BATT
where t CHG and t DIS are the charge and discharge
times for the inductor (1/2f can be used for nominal cal-
culations).
Oscillator Capacitor, C X
BUCK CONVERTER
-
The oscillator capacitor, C X , is a noncritical ceramic or
silver mica capacitor. C X can also be calculated by:
S 1
+
? C INT INT ? 5 pF , see text )
C X =
2 . 14 X 10 ? 6
f
( C
V BATT
CONTROL
SECTION
V OUT < V BATT
where f is the desired operating frequency in Hertz, and
C INT is the sum of the stray capacitance on the C X pin
and the internal capacitance of the package. The internal
capacitance is typically 1pF for the plastic package and
3pF for the CERDIP package. Typical stray capacitances
BUCK-BOOST CONVERTER
-
are about 3pF for normal PC board layouts, but will be
significantly higher if a socket is used.
S 1
-
Bypassing and Compensation
Since the inductor-charging current can be relatively
V BATT
CONTROL
SECTION
|V OUT | < OR > V BATT
large, high currents can flow through the ground con-
nection of the MAX630/MAX4193. To prevent unwanted
feedback, the impedance of the ground path must be
as low as possible, and supply bypassing should be
used for the device.
Figure 2. DC-DC Converter Configurations
+
8
_______________________________________________________________________________________
相关PDF资料 |
PDF描述 |
|---|---|
| MAX4806CTN+T | IC DGTL PULSER DUAL 56TQFN |
| MAX4820ETP+T | IC RELAY DRIVER 8CHAN 20-TQFN |
| MAX4823ETP+T | IC RELAY DRIVER 8CHAN 20-TQFN |
| MAX4832ETT33C+T | IC REG LDO 3.3V .1A 6TDFN |
| MAX4836ETT30C+T | IC REG LDO 3V .5A 6TDFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX4193CTV | 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述: |
| MAX4193EJA | 功能描述:直流/直流开关调节器 RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| MAX4193EPA | 功能描述:直流/直流开关调节器 CMOS uPower Step Up Switching Reg RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| MAX4193EPA+ | 功能描述:直流/直流开关调节器 CMOS uPower Step Up Switching Reg RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| MAX4193ESA | 功能描述:直流/直流开关调节器 CMOS uPower Step Up Switching Reg RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
发布紧急采购，3分钟左右您将得到回复。