- 您现在的位置：买卖IC网 > PDF目录10180 > MAX4299EUE+T (Maxim Integrated Products)IC STEREO DRVR W/AMP 16-TSSOP PDF资料下载
参数资料
| 型号： | MAX4299EUE+T |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 14/14页 |
| 文件大小： | 0K |
| 描述： | IC STEREO DRVR W/AMP 16-TSSOP |
| 标准包装： | 2,500 |
| 类型： | PSRR 立体声驱动器 |
| 应用： | 台式音频，MP3，USB |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 16-TSSOP |
| 包装： | 带卷 (TR) |
MAX4298/MAX4299
Ultra-High PSRR Stereo Drivers +
Microphone Amp + 100mA Linear Regulator
_______________________________________________________________________________________
9
Regulator (MAX4299)
The MAX4299 also has an additional 100mA low-
dropout (LDO) regulator to provide clean analog power
for other sensitive analog circuitry on the PC board,
such as a typical PC99 audio codec or microphone
biasing. It is designed to provide good AC line regula-
tion. The nominal output voltage of REG is 3.3V, and is
adjustable between 1.2V and 4.5V by connecting a
resistor-divider from REG to GND. Connect FB to the
junction of the resistor-divider. The input impedance at
FB is typically 7k
, which should be considered in out-
put voltage calculations. REG should be bypassed to
GND with at least 10F.
Applications Information
Capacitor Selection and
Regulator Stability
Normally, use a 10F capacitor on REG (MAX4299 only)
and a 1F capacitor on CBYPASS. Larger capacitor val-
ues and lower ESRs provide better supply-noise rejec-
tion and line-transient response. Reduce noise and
improve load-transient response, stability, and power-
supply rejection by using larger capacitors. For stable
operation over the full temperature range and load cur-
rents up to 100mA, a minimum of 10F (REG) and 1F
(CBYPASS) is recommended.
Use a 1F bypass capacitor on BIAS to ensure a fully
clickless/popless power-up sequence. Smaller capacitor
values may be used here to decrease the power-up
time, but may cause the power-up transient to become
audible. Larger bypass capacitors are not necessary to
reduce noise and/or improve AC power-supply rejection.
SVCC is the standby power supply. If using an external
diode for charging, a 220F reservoir capacitor on
SVCC provides standby power for the clickless power-
down sequence. Smaller capacitors here may cause an
audible output transient on power-down; 220F or high-
er provides enough energy when CBIAS = 1F. For larg-
er values of CBIAS, increase the reservoir capacitor
accordingly.
Mic Biasing (MAX4299)
Common microphone elements require resistive biasing
to power their internal circuitry. A 2k
resistor is typical-
ly used, and the microphone is AC-coupled to the
microphone amplifier. If the microphone element allows
low-voltage operation, biasing to the REG output pro-
vides excellent power-supply rejection.
Power Supply and Bypassing
The excellent PSRR of the MAX4298/MAX4299 allows
them to operate from noisy power supplies. In most
applications, a 0.1F capacitor from VCC to GND is suf-
ficient. This bypass capacitor should be placed close
to the VCC pin.
Layout
Good layout improves performance by decreasing the
amount of stray capacitance and noise at the power
amplifier’s inputs and output. To decrease stray capaci-
tance, minimize PC board trace lengths and resistor
leads, and place external components as close to the
pins as possible.
Power Dissipation
The first equation below indicates the maximum power
dissipation point for a package that has two power
amplifiers operating at identical known supply voltages
and loads with sine wave inputs:
PIC(DISS) = (VCC)
2 / (
π2RL) [W]
For example, with a 5V power supply and a load of 16
,
the maximum power dissipation of the amplifiers alone
is 317mW.
The additional power dissipation due to the 100mA reg-
ulator operating at maximum current is nominally
170mW, but will increase if the output is reduced exter-
nally from its nominal 3.3V. The regulator power con-
sumption is given by:
PREG = (VCC - VREG) x 100mA [W]
To avoid thermal shutdown the sum of the regulator and
amplifier power dissipation must not exceed the absolute
maximum power-dissipation rating of the package.
Short-Circuit Protection and
Thermal Shutdown
The MAX4298/MAX4299 have short-circuit current pro-
tection on all outputs. They also have a thermal shut-
down function designed to protect the chip from junction
temperatures in excess of +150°C that may arise from
temporary short circuits or operation beyond the power
dissipation limit of the package. The driver amplifier out-
puts limit at around ±220mA, the regulator at 150mA,
and the microphone amplifier at +1.5mA/-12mA.
USB Applications
Universal serial bus (USB) interfaces are an increasingly
popular method of interfacing medium-speed (up to
12Mbps) PC peripherals. One of the great benefits of
the USB interface is the inclusion of a +5V supply. While
this supply works well for a mouse or keyboard, its sus-
ceptibility for noise pickup can be unsuitable for high-
fidelity audio applications. The MAX4298/MAX4299s’
excellent PSRR make them ideal candidates for USB
applications due to their insensitivity to the supply noise.
Of particular interest is an Internet-Protocol (IP) phone.
This PC peripheral uses the local internet service
provider as a free long-distance phone. The MAX4299,
with its integral microphone amp, headphone driver,
and linear regulator, can be a key element in the imple-
mentation of an IP phone that interfaces to the PC
through the USB.
相关PDF资料 |
PDF描述 |
|---|---|
| VE-27J-MY | CONVERTER MOD DC/DC 36V 50W |
| ADM3307EARUZ-REEL | IC TXRX RS-232 5:3 2.7V 28TSSOP |
| VE-B3L-MW-F2 | CONVERTER MOD DC/DC 28V 100W |
| D7F | CONN RCPT FEMALE 7PIN NICKEL |
| VE-B3L-MW-F1 | CONVERTER MOD DC/DC 28V 100W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX4299EVKIT | 制造商:Maxim Integrated Products 功能描述: |
| MAX4299EWP | 功能描述:音频放大器 Integrated Circuits (ICs) RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
| MAX4299EWP+ | 功能描述:音频放大器 Integrated Circuits (ICs) RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
| MAX4299EWP+T | 功能描述:音频放大器 Integrated Circuits (ICs) RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
| MAX4299EWP-T | 功能描述:音频放大器 RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。