- 您现在的位置：买卖IC网 > PDF目录10205 > MAX4399CTK+ (Maxim Integrated Products)IC SW A/V SCART CON 68-TQFN PDF资料下载
参数资料
| 型号： | MAX4399CTK+ |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 4/33页 |
| 文件大小： | 0K |
| 描述： | IC SW A/V SCART CON 68-TQFN |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 30 |
| 类型： | 开关 |
| 应用： | 接收器，机顶盒，电视 |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 68-TQFN 裸露焊盘 |
| 供应商设备封装： | 68-TQFN-EP（10x10） |
| 包装： | 管件 |
第1页第2页第3页当前第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页
MAX4399
from the Y and C signals to drive the legacy
RF_CVBS_OUT output. The circuit is shown as a sum-
ming point with bias in Figure 2. The MAX4399 sums Y
and C to get CVBS, and the bias provides the DC levels
for offsetting the chroma signal. Again, loop-through is
not possible with S-VHS because the chroma SCART
pin is used for both input and output.
The MAX4399 supports the CVBS format, with inputs
from the VCR, MPEG decoder, TV, and auxiliary device.
Full loop-through is possible to all devices except the
MPEG decoder because the SCART connector has
separate input and output pins for the CVBS format.
Slow Switching
The MAX4399 supports the tri-level slow switching of
IEC 933-1, Amendment 1, which selects the aspect ratio
for the display device. Under I2C-compatible control,
the MAX4399 sets the slow-switching output levels. Table
1 shows the valid output levels of the slow-switching
signal and the corresponding operating modes of the
display device.
The slow-switching SCART pins are bidirectional. The
MAX4399 can set the slow-switch output drivers to high-
impedance mode to receive signals. When enabled,
INTERRUPT_OUT becomes high impedance if the
voltage level changes on TV_SS, VCR_SS, or AUX_SS.
The VCR or MPEG decoder outputs a fast-switching
signal to the display device. The fast-switching signal
can also be set to a constant high or low through the 2-
wire interface. The pass-through delay from VCR to TV
or MPEG decoder to TV matches that of the RGB sig-
nals facilitating proper OSD insertion.
Video Outputs
The DC level at the video outputs is controlled so cou-
pling capacitors are not required, and all of the video
outputs are capable of driving a 150
, back-terminated
coax load directly with respect to ground. Since some
televisions and VCRs use the horizontal sync height for
automatic gain control, the MAX4399 accurately repro-
duces the sync height to within
±2%.
Y/C Mixer and Trap Filter
The MAX4399 includes an on-chip mixer to produce
CVBS from Y and C. The Y signal input to the mixer has
an external trap filter connection, TRAP, to eliminate the
color subcarrier frequency (4.43MHz), preventing
cross-mixing of the subcarriers in the mixer. TRAP is
internally biased at 0.5V. Connect a series RLC filter to
G_VID, or leave TRAP unconnected if not used.
SCART Audio Switching
Audio Inputs
The audio block has four stereo audio inputs from the TV,
VCR, and AUX SCART connectors, plus the MPEG
decoder. Additionally, the MAX4399 provides a satellite
tone input. Each input has a 100k
resistor connected to
an internally generated voltage equal to 0.5 x V_AUD.
There are three main sections—the TV channel, the VCR
channel, and the AUX channel.
Audio Outputs
Each channel has a stereo output and the TV channel
has an additional phono output and a mono output. The
phono outputs always follow the TV audio input selec-
tion. The mono output, a mix of the TV right and left
channels, drives the channel 3/4 RF modulator. The
three stereo outputs can be configured to normal
mode, swap mode, mono, both channels to right input,
and both channels to left input. The latter two modes
are useful if the left audio channel carries one language
and the right audio channel carries another language.
The phono output is ideal for connection to a hi-fi, and
carries the same signals as the TV output when
switched to normal mode.
The mono mixer, a resistor summer, attenuates the
amplitude of each of the two signals by 6dB. The 3dB
gain block, which follows the mono mixer (Figures 3
and 4), is a compromise between a 0dB gain block and
a 6dB gain block. If the left and right audio channels
were completely uncorrelated, then a 6dB gain block
could be used. If the left and right channels were com-
pletely correlated, then a 0dB block would have to be
used. In reality, most stereo audio channels are partial-
ly correlated and hence a 3dB gain block was used.
Audio/Video Switch for Three SCART
Connectors
12
______________________________________________________________________________________
SLOW-SWITCHING
SIGNAL VOLTAGE (V)
MODE
0 to 2
Display device uses an internal
source such as a built-in tuner to
provide a video signal
4.5 to 7
Display device uses a video signal
from the SCART connector and sets
the display to 16:9 aspect ratio
9.5 to 12.6
Display device uses a signal from a
SCART connector and sets the
display to 4:3 aspect ratio
Table 1. Slow Switch Modes
相关PDF资料 |
PDF描述 |
|---|---|
| 97-3108B-22-22S | CONN PLUG 4POS RT ANG W/SKT |
| PT06A-12-3P | CONN PLUG 3POS W/PINS SOLDER |
| MS27484T12F98SD | CONN PLUG 10POS STRAIGHT W/SCKT |
| PX0731/P | CONN PLUG 3POS W/PINS BLACK |
| VE-24Z-IU-S | CONVERTER MOD DC/DC 2V 80W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX4399CTK+ | 功能描述:视频开关 IC Audio/Video Switch for 3 SCART Con RoHS:否 制造商:Texas Instruments 开关数量:4 开启电阻（最大值）:12 Ohms 传播延迟时间: 开启时间（最大值）: 关闭时间（最大值）: 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:WQFN-42 封装:Reel |
| MAX4399CTK+D | 功能描述:视频开关 IC Audio/Video Switch for 3 SCART Con RoHS:否 制造商:Texas Instruments 开关数量:4 开启电阻（最大值）:12 Ohms 传播延迟时间: 开启时间（最大值）: 关闭时间（最大值）: 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:WQFN-42 封装:Reel |
| MAX4399CTK+T | 功能描述:视频开关 IC Audio/Video Switch for 3 SCART Con RoHS:否 制造商:Texas Instruments 开关数量:4 开启电阻（最大值）:12 Ohms 传播延迟时间: 开启时间（最大值）: 关闭时间（最大值）: 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:WQFN-42 封装:Reel |
| MAX4399CTK+TD | 功能描述:视频开关 IC Audio/Video Switch for 3 SCART Con RoHS:否 制造商:Texas Instruments 开关数量:4 开启电阻（最大值）:12 Ohms 传播延迟时间: 开启时间（最大值）: 关闭时间（最大值）: 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:WQFN-42 封装:Reel |
| MAX4399CTK-D | 功能描述:视频开关 IC RoHS:否 制造商:Texas Instruments 开关数量:4 开启电阻（最大值）:12 Ohms 传播延迟时间: 开启时间（最大值）: 关闭时间（最大值）: 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:WQFN-42 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。