- 您现在的位置：买卖IC网 > PDF目录3541 > MAX4450EUK+T (Maxim Integrated Products)IC OP AMP R-R SGL 210MHZ SOT23-5 PDF资料下载
参数资料
| 型号： | MAX4450EUK+T |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 14/15页 |
| 文件大小： | 0K |
| 描述： | IC OP AMP R-R SGL 210MHZ SOT23-5 |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 1 |
| 放大器类型： | 电压反馈 |
| 电路数： | 1 |
| 输出类型： | 满摆幅 |
| 转换速率： | 485 V/µs |
| -3db带宽： | 210MHz |
| 电流 - 输入偏压： | 6.5µA |
| 电压 - 输入偏移： | 4000µV |
| 电流 - 电源： | 6.5mA |
| 电流 - 输出 / 通道： | 70mA |
| 电压 - 电源，单路/双路(±)： | 4.5 V ~ 11 V，±2.25 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | SC-74A，SOT-753 |
| 供应商设备封装： | SOT-23-5 |
| 包装： | 标准包装 |
| 产品目录页面： | 1390 (CN2011-ZH PDF) |
| 其它名称： | MAX4450EUK+TDKR |
Note: RL = RO + RTO; RTIN and RTO are calculated for 50
Ω applications. For 75Ω systems, RTO = 75Ω; calculate RTIN from the
following equation:
0.1F capacitor as close to the pin as possible. If operat-
ing with dual supplies, bypass each supply with a 0.1F
capacitor.
Maxim recommends using microstrip and stripline tech-
niques to obtain full bandwidth. To ensure that the PC
board does not degrade the amplifier’s performance,
design it for a frequency greater than 1GHz. Pay care-
ful attention to inputs and outputs to avoid large para-
sitic capacitance. Whether or not you use a constant-
impedance board, observe the following design guide-
lines:
Don’t use wire-wrap boards; they are too inductive.
Don’t use IC sockets; they increase parasitic capaci-
tance and inductance.
Use surface-mount instead of through-hole compo-
nents for better high-frequency performance.
Use a PC board with at least two layers; it should be
as free from voids as possible.
Keep signal lines as short and as straight as possi-
ble. Do not make 90° turns; round all corners.
Rail-to-Rail Outputs,
Ground-Sensing Input
The input common-mode range extends from
(VEE - 200mV) to (VCC - 2.25V) with excellent common-
mode rejection. Beyond this range, the amplifier output
is a nonlinear function of the input, but does not under-
go phase reversal or latchup.
The output swings to within 55mV of either power-
supply rail with a 2k
Ω load. The input ground sensing
and the rail-to-rail output substantially increase the
dynamic range. With a symmetric input in a single +5V
application, the input can swing 2.95VP-P and the out-
put can swing 4.9VP-P with minimal distortion.
Output Capacitive Loading and Stability
The MAX4450/MAX4451 are optimized for AC perfor-
mance. They are not designed to drive highly reactive
loads, which decrease phase margin and may produce
excessive ringing and oscillation. Figure 2 shows a cir-
cuit that eliminates this problem. Figure 3 is a graph of
the optimal isolation resistor (RS) vs. capacitive load.
Figure 4 shows how a capacitive load causes exces-
sive peaking of the amplifier’s frequency response if
the capacitor is not isolated from the amplifier by a
resistor. A small isolation resistor (usually 20
Ω to 30Ω)
placed before the reactive load prevents ringing and
oscillation. At higher capacitive loads, AC performance
is controlled by the interaction of the load capacitance
and the isolation resistor. Figure 5 shows the effect of a
27
Ω isolation resistor on closed-loop response.
Coaxial cable and other transmission lines are easily
driven when properly terminated at both ends with their
characteristic impedance. Driving back-terminated
transmission lines essentially eliminates the line’s
capacitance.
Table 1. Recommended Component Values
MAX4450/MAX4451
Ultra-Small, Low-Cost, 210MHz, Single-Supply
Op Amps with Rail-to-Rail Outputs
8
_______________________________________________________________________________________
-25
+25
-10
+10
-5
+5
-2
+2
-1
+1
49.9
10
∞
0
50
1200
GAIN (V/V)
49.9
5
49.9
—
20
500
49.9
15
∞
0
50
500
49.9
11
49.9
—
56
500
49.9
25
100
0
100
500
49.9
25
49.9
—
124
500
49.9
50
62
0
250
500
49.9
95
49.9
—
500
49.9
RTO (
Ω)
100
210
Small-Signal -3dB Bandwidth (MHz)
56
49.9
RTIN (
Ω)
0
—
RS (
Ω)
COMPONENT
500
∞
RG (
Ω)
500
24
RF (
Ω)
R
=
75
1-
75
R
TIN
G
Ω
相关PDF资料 |
PDF描述 |
|---|---|
| 102620-6 | CONN HEADER 20POS DUAL R/A GOLD |
| TSW-116-17-G-D | CONN HEADER 32POS .100" DL GOLD |
| SMBJ45AHE3/52 | TVS UNIDIR 600W 45V 5% SMB |
| SMBJ43AHE3/52 | TVS UNIDIR 600W 43V 5% SMB |
| AD8099ARD-REEL | IC OPAMP VF ULN ULDIST 8SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX4450EVKIT | 功能描述:放大器 IC 开发工具 Evaluation Kit for the MAX4450 RoHS:否 制造商:International Rectifier 产品:Demonstration Boards 类型:Power Amplifiers 工具用于评估:IR4302 工作电源电压:13 V to 23 V |
| MAX4450EXK | 制造商:Maxim Integrated Products 功能描述:5 PIN COUNT SC70 PACKAGE TYPE - Cut Tape Product |
| MAX4450EXK+ | 制造商:Maxim Integrated Products 功能描述:OP AMP SGL VOLT FDBK R-R O/P 5.5V/11V 5PIN SC-70 - Rail/Tube |
| MAX4450EXK+T | 功能描述:高速运算放大器 210MHz Single-Supply w/Rail-Rail Output RoHS:否 制造商:Texas Instruments 通道数量:1 电压增益 dB:116 dB 输入补偿电压:0.5 mV 转换速度:55 V/us 工作电源电压:36 V 电源电流:7.5 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube |
| MAX4450EXK-T | 功能描述:运算放大器 - 运放 RoHS:否 制造商:STMicroelectronics 通道数量:4 共模抑制比（最小值）:63 dB 输入补偿电压:1 mV 输入偏流（最大值）:10 pA 工作电源电压:2.7 V to 5.5 V 安装风格:SMD/SMT 封装 / 箱体:QFN-16 转换速度:0.89 V/us 关闭:No 输出电流:55 mA 最大工作温度:+ 125 C 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。