- 您现在的位置：买卖IC网 > PDF目录18728 > MAX4473EUA (Maxim Integrated)IC AMP PA PWR GSM CONTROL 8-MSOP PDF资料下载
参数资料
| 型号： | MAX4473EUA |
| 厂商： | Maxim Integrated |
| 文件页数： | 6/9页 |
| 文件大小： | 0K |
| 描述： | IC AMP PA PWR GSM CONTROL 8-MSOP |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 50 |
| RF 型： | GSM |
| 封装/外壳： | 8-TSSOP，8-MSOP（0.118"，3.00mm 宽） |
| 供应商设备封装： | 8-uMAX |
| 包装： | 管件 |
Low-Cost, Low-Voltage, PA Power Control
Amplifier for GSM Applications
Applications Information
Gain Resistor Selection
(RG1, RG2, RG3)
For proper operation, do not make the value of external
gain resistors RG1 and RG2 larger than twice the value
of RG3. In most practical applications, choose RG1
smaller than RG3 to limit the voltage drop over RG1
and R SENSE . A large voltage drop over R SENSE sub-
stantially reduces the voltage applied to the PA, thus
reducing PA output power. Set RG2 equal to RG1 to
compensate for the input bias currents of A3.
Recommended values for RG3 are between 1k Ω and
10k Ω .
Sense Resistor Selection (R SENSE )
Choose R SENSE based on the following criteria:
? Voltage Loss: A high R SENSE value causes the
power-source voltage to degrade through IR loss.
For minimal voltage loss, use low R SENSE values.
_________________________Test Circuit
R SENSE
? Accuracy: A high R SENSE value allows lower cur-
rents to be measured more accurately because input
offset voltages become less significant when the
sense voltage is larger. For best performance, select
R SENSE to provide approximately 100mV of sense
voltage for the full-scale current in each application.
? Efficiency and Power Dissipation: At high current
levels, the I 2 R losses in R SENSE are significant. Take
this into consideration when choosing the resistor
value and its power dissipation (wattage) rating.
Also, the sense resistor ’s value may drift if it is
allowed to heat up excessively.
Pin Configuration
TOP VIEW
V CC
0.1 μ F
RG1
1k Ω
1%
100 Ω
0.1%
RG2
1k Ω
1%
V CC
SR1
SR2
SR1
1
8
V CC
SR2
2
7
OUT
PC
MAX4473
OUT
C L
2N3904
SHDN
3
MAX4473
6
SR3
SHDN
GND
SR3
RG3
2.5k Ω
R L
10k Ω
300pF
R E
750 Ω
PC 4
μ MAX/SO
5
GND
1%
Chip Information
TRANSISTOR COUNT: 348
6
_______________________________________________________________________________________
相关PDF资料 |
PDF描述 |
|---|---|
| MAX4473ESA | IC AMP PA PWR GSM CONTROL 8-SOIC |
| KC2520B12.0000C10E00 | OSCILLATOR 12.0000MHZ SMD |
| 7X-1.8432MBB-T | OSC 1.8432 MHZ 3.3V SMD |
| GLCC01C | SWITCH TOP ROLLR PLNGR SNAP SPDT |
| 7X-14.31818MBB-T | OSC 14.31818 MHZ 3.3V SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX4473EUA+ | 功能描述:功率放大器 PA Power Control Amp for GSM Aps RoHS:否 制造商:TriQuint Semiconductor 封装 / 箱体: 工作电源电压:28 V 电源电流:2.5 A 工作温度范围: 封装: |
| MAX4473EUA+T | 功能描述:射频放大器 PA Power Control Amp for GSM Aps RoHS:否 制造商:Skyworks Solutions, Inc. 类型:Low Noise Amplifier 工作频率:2.3 GHz to 2.8 GHz P1dB:18.5 dBm 输出截获点:37.5 dBm 功率增益类型:32 dB 噪声系数:0.85 dB 工作电源电压:5 V 电源电流:125 mA 测试频率:2.6 GHz 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:QFN-16 封装:Reel |
| MAX4473EUA-T | 功能描述:射频放大器 PA Power Control Amp for GSM Aps RoHS:否 制造商:Skyworks Solutions, Inc. 类型:Low Noise Amplifier 工作频率:2.3 GHz to 2.8 GHz P1dB:18.5 dBm 输出截获点:37.5 dBm 功率增益类型:32 dB 噪声系数:0.85 dB 工作电源电压:5 V 电源电流:125 mA 测试频率:2.6 GHz 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:QFN-16 封装:Reel |
| MAX4474EKA | 制造商:Maxim Integrated Products 功能描述:SINGLE/DUAL +1.8V/750NA SC70 RAI - Cut Tape Product |
| MAX4474EKA+ | 制造商:Maxim Integrated Products 功能描述: 制造商:Maxim Integrated Products 功能描述:OP AMP DUAL GP R-R O/P 5.5V 8PIN SOT-23 - Rail/Tube |
发布紧急采购，3分钟左右您将得到回复。