参数资料
| 型号： | MAX474CPA |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 3/13页 |
| 文件大小： | 0K |
| 描述： | IC OPAMP DUAL 10MHZ 8-DIP |
| 标准包装： | 50 |
| 放大器类型： | 通用 |
| 电路数： | 2 |
| 输出类型： | 满摆幅 |
| 转换速率： | 17 V/µs |
| 增益带宽积： | 12MHz |
| 电流 - 输入偏压： | 80nA |
| 电压 - 输入偏移： | 700µV |
| 电流 - 电源： | 2mA |
| 电压 - 电源，单路/双路(±)： | 2.7 V ~ 5.25 V，±1.35 V ~ 2.625 V |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 通孔 |
| 封装/外壳： | 8-DIP（0.300"，7.62mm） |
| 供应商设备封装： | 8-PDIP |
| 包装： | 管件 |
MAX473/MAX474/MAX475
The MAX473/MAX474/MAX475 have excellent phase
margin (the difference between 180° and the unity-gain
phase angle). It is typically 63° with a load of 10k
in
parallel with 20pF. Generally, higher phase margins
indicate greater stability.
Capacitive loads form an RC network with the op amp’s
output resistance, causing additional phase shift that
reduces the phase margin. Figure 3 shows the
MAX473/MAX474/MAX475 output response when dri-
ving a 390pF load in parallel with 10k
.
When driving large capacitive loads, add an output iso-
lation resistor, as shown in Figure 4. This resistor
improves the phase margin by isolating the load
capacitance from the amplifier output. Figure 5 shows
the MAX473/MAX474/MAX475 driving a capacitive load
of 1000pF using the circuit of Figure 4.
Feedback Resistors
The feedback resistors appear as a resistance network
to the op amp’s feedback input (Figure 2). This resis-
tance, combined with the op amp’s input and stray
capacitance (total input capacitance), forms a pole that
adds unwanted phase shift when either the total input
capacitance or feedback resistance is too large. For
example, using the noninverting configuration with a
gain of 10, if the total capacitance at the negative input
is 10pF and the effective resistance (R1
|| R2) is 9k,
this RC network introduces a pole at fo = 1.8MHz. At
input frequencies above fo, the pole introduces addi-
tional phase shift, which reduces the overall bandwidth
and adversely affects stability. Choose feedback resis-
tors small enough so they do not adversely affect the
op amp’s operation at the frequencies of interest.
Overdriving the Outputs
The output voltage swing for specified operation is from
(VEE + 0.3V) to (VCC - 0.5V) (see Electrical Characteristics).
Exercising the outputs beyond these limits drives the out-
put transistors toward saturation, resulting in bandwidth
degradation, response-time increase, and gain decrease
(which affects linearity). Operation in this region causes a
slight distortion in the output waveform, but does not
adversely affect the op amp.
Single/Dual/Quad, 10MHz
Single-Supply Op Amps
10
______________________________________________________________________________________
MAX473
VEE
NULL
2k
NULL
1
4
8
VIN
VOUT
R1
R2
R3
R3 = R2
R1
VIN
VOUT
R3
R2
R1
R3 = R2
R1
Figure 1. Offset Null Circuit
Figure 2a. Reducing Offset Error Due to Bias Current:
Inverting Configuration
Figure 2b. Reducing Offset Error Due to Bias Current:
Noninverting Configuration
相关PDF资料 |
PDF描述 |
|---|---|
| RMCF2010JT6K20 | RES 6.2K OHM 5% 3/4W 2010 SMD |
| VJ13PC0480KBA | VARISTOR TVS 48VDC 250A 1210 |
| 1-87985-2 | CONN RCPT 12POS .156 TIN |
| MAX473CPA | IC OPAMP SINGLE 10MHZ 8-DIP |
| 0459841273 | CONN RCPT R/A 10PWR 36SGL 1.57MM |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX474CPA+ | 功能描述:运算放大器 - 运放 RoHS:否 制造商:STMicroelectronics 通道数量:4 共模抑制比（最小值）:63 dB 输入补偿电压:1 mV 输入偏流（最大值）:10 pA 工作电源电压:2.7 V to 5.5 V 安装风格:SMD/SMT 封装 / 箱体:QFN-16 转换速度:0.89 V/us 关闭:No 输出电流:55 mA 最大工作温度:+ 125 C 封装:Reel |
| MAX474CSA | 功能描述:运算放大器 - 运放 RoHS:否 制造商:STMicroelectronics 通道数量:4 共模抑制比（最小值）:63 dB 输入补偿电压:1 mV 输入偏流（最大值）:10 pA 工作电源电压:2.7 V to 5.5 V 安装风格:SMD/SMT 封装 / 箱体:QFN-16 转换速度:0.89 V/us 关闭:No 输出电流:55 mA 最大工作温度:+ 125 C 封装:Reel |
| MAX474CSA+ | 功能描述:运算放大器 - 运放 RoHS:否 制造商:STMicroelectronics 通道数量:4 共模抑制比（最小值）:63 dB 输入补偿电压:1 mV 输入偏流（最大值）:10 pA 工作电源电压:2.7 V to 5.5 V 安装风格:SMD/SMT 封装 / 箱体:QFN-16 转换速度:0.89 V/us 关闭:No 输出电流:55 mA 最大工作温度:+ 125 C 封装:Reel |
| MAX474CSA+T | 功能描述:运算放大器 - 运放 RoHS:否 制造商:STMicroelectronics 通道数量:4 共模抑制比（最小值）:63 dB 输入补偿电压:1 mV 输入偏流（最大值）:10 pA 工作电源电压:2.7 V to 5.5 V 安装风格:SMD/SMT 封装 / 箱体:QFN-16 转换速度:0.89 V/us 关闭:No 输出电流:55 mA 最大工作温度:+ 125 C 封装:Reel |
| MAX474CSA-T | 功能描述:运算放大器 - 运放 RoHS:否 制造商:STMicroelectronics 通道数量:4 共模抑制比（最小值）:63 dB 输入补偿电压:1 mV 输入偏流（最大值）:10 pA 工作电源电压:2.7 V to 5.5 V 安装风格:SMD/SMT 封装 / 箱体:QFN-16 转换速度:0.89 V/us 关闭:No 输出电流:55 mA 最大工作温度:+ 125 C 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。