- 您现在的位置：买卖IC网 > PDF目录385532 > MAX488 (Maxim Integrated Products, Inc.) Low-Power, Slew-Rate-Limited RS-485Transceivers(250kbps,全双工, RS-485收发器) PDF资料下载
参数资料
| 型号： | MAX488 |
| 厂商： | Maxim Integrated Products, Inc. |
| 英文描述： | Low-Power, Slew-Rate-Limited RS-485Transceivers(250kbps,全双工, RS-485收发器) |
| 中文描述： | 低功耗、限摆率、RS-485/RS-422收发器 |
| 文件页数： | 11/16页 |
| 文件大小： | 205K |
| 代理商： | MAX488 |
Low-Power S hutdown Mode
(MAX 481/MAX 483/MAX 487)
A low-power shutdown mode is initiated by bringing
down unless both the driver and receiver are disabled.
In shutdown, the devices typically draw only 0.1μA of
supply current.
–—and DE may be driven simultaneously; the parts are
guaranteed not to enter shutdown if –—is high and DE
is low for less than 50ns. If the inputs are in this state
for at least 600ns, the parts are guaranteed to enter
shutdown.
For the MAX481, MAX483, and MAX487, the t
ZH
and
t
ZL
enable times assume the part was not in the low-
power shutdown state (the MAX485/MAX488–MAX491
and MAX1487 can not be shut down). The t
ZH(SHDN)
and t
ZL(SHDN)
enable times assume the parts were shut
down (see Electrical Characteristics).
It takes the drivers and receivers longer to become
enabled from the low-power shutdown state
(t
ZH(SHDN
), t
ZL(SHDN)
) than from the operating mode
(t
ZH
, t
ZL
DE inputs equal a logical 0,1 or 1,1 or 0, 0.)
Driver Output Protec tion
Excessive output current and power dissipation caused
by faults or by bus contention are prevented by two
mechanisms. A foldback current limit on the output
stage provides immediate protection against short cir-
cuits over the whole common-mode voltage range (see
Typical Operating Characteristics). In addition, a ther-
mal shutdown circuit forces the driver outputs into a
high-impedance state if the die temperature rises
excessively.
Propagation Delay
Many digital encoding schemes depend on the differ-
ence between the driver and receiver propagation
delay times. Typical propagation delays are shown in
Figures 15–18 using Figure 14’s test circuit.
The difference in receiver delay times, |t
PLH
- t
PHL
| is
typically under 13ns for the MAX481, MAX485,
MAX490, MAX491, and MAX1487 and is typically less
than 100ns for the MAX483 and MAX487–MAX489.
The driver skew times are typically 5ns (10ns max) for
the MAX481, MAX485, MAX490, MAX491, and
MAX1487, and are typically 100ns (800ns max) for the
MAX483 and MAX487–MAX489.
M
Low-Power, S lew-Rate-Limited
RS -485/RS -422 Transc eivers
______________________________________________________________________________________
11
10dB/div
0Hz
5MHz
500kHz/div
10dB/div
0Hz
5MHz
500kHz/div
Figure 12. Driver Output Waveform and FFT Plot of MAX481/
MAX485/MAX490/MAX491/MAX1487 Transmitting a 150kHz
Signal
Figure 13. Driver Output Waveform and FFT Plot of MAX483/
MAX487–MAX489 Transmitting a 150kHz Signal
相关PDF资料 |
PDF描述 |
|---|---|
| MAX492 | Dual, Micropower, Single-Supply Rail-to-Rail Op Amps(输入失调电压500μV,单电源满量程运放) |
| MAX494 | Quad, Micropower, Single-Supply Rail-to-Rail Op Amps(输入失调电压500μV,单电源满量程运放) |
| MAX5003 | High-Voltage PWM Power-Supply Controller |
| MAX5003CEE | High-Voltage PWM Power-Supply Controller |
| MAX5003CSE | High-Voltage PWM Power-Supply Controller |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX4880ETB | 制造商:Maxim Integrated Products 功能描述:OVERVOLTAGE PROTECTION CONTROLLER W - Rail/Tube |
| MAX4880ETB-T | 功能描述:电源开关 IC - 配电 RoHS:否 制造商:Exar 输出端数量:1 开启电阻（最大值）:85 mOhms 开启时间（最大值）:400 us 关闭时间（最大值）:20 us 工作电源电压:3.2 V to 6.5 V 电源电流（最大值）: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOT-23-5 |
| MAX4881ETB | 制造商:Maxim Integrated Products 功能描述:OVERVOLTAGE PROTECTION CONTROLLERS - Rail/Tube |
| MAX4881ETB-T | 制造商:Maxim Integrated Products 功能描述:OVERVOLTAGE PROTECTION CONTROLLERS WITH CURRE - Tape and Reel |
| MAX4882ETB | 制造商:Maxim Integrated Products 功能描述:OVERVOLTAGE PROTECTION CONTROLLERS - Rail/Tube |
发布紧急采购，3分钟左右您将得到回复。