- 您现在的位置：买卖IC网 > PDF目录15514 > MAX5020CSA+ (Maxim Integrated Products)IC REG CTRLR FLYBK ISO PWM 8SOIC PDF资料下载
参数资料
| 型号： | MAX5020CSA+ |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 6/14页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR FLYBK ISO PWM 8SOIC |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 100 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 302kHz |
| 占空比： | 50% |
| 电源电压： | 13 V ~ 110 V |
| 降压： | 无 |
| 升压： | 无 |
| 回扫： | 是 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 是 |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 包装： | 管件 |
Current-Mode PWM Controllers with Integrated
Startup Circuit
Pin Description
PIN
1
2
3
4
5
6
7
8
NAME
V+
V DD
FB
SS_ SHDN
CS
GND
NDRV
V CC
FUNCTION
High-Voltage Startup Input. Connect directly to an input voltage between 18V to 110V. Connects
internally to a high-voltage linear regulator that generates V CC during startup.
V DD is the Input of the Linear Regulator that Generates V CC . For supply voltages less than 36V, V DD
and V+ can both be connected to the supply. For supply voltages greater than 36V, V DD receives
its power from the tertiary winding of the transformer and accepts voltages from 13V to 36V. Bypass
to GND with a 4.7μF capacitor.
Input of the Fixed-Gain Inverting Amplifier. Connect a voltage-divider from the regulated output to
this pin. The noninverting input of the amplifier is referenced to 2.4V.
Soft-Start Timing Capacitor Connection. Ramp time to full current limit is approximately 0.45ms/nF.
This pin is also the reference voltage output. Bypass with a minimum 10nF capacitor to GND. The
device goes into shutdown when SS_ SHDN is pulled below 0.25V.
Current Sense Input. Turns power switch off if V CS rises above 465mV for cycle-by-cycle current
limiting. CS is also the feedback for the current-mode controller. CS is connected to the PWM
comparator through a leading-edge blanking circuit.
Ground
Gate Drive. Drives a high-voltage external N-channel power MOSFET.
Regulated IC Supply. Provides power for the entire IC. V CC is regulated from V DD during normal
operation and from V+ during startup. Bypass V CC with a 10 μ F tantalum capacitor in parallel with
0.1μF ceramic capacitor to GND.
Detailed Description
Use the MAX5019/MAX5020 PWM current-mode con-
trollers to design flyback- or forward-mode power sup-
plies. Current-mode operation simplifies control-loop
design while enhancing loop stability. An internal high-
voltage startup regulator allows the device to connect
directly to the input supply without an external startup
resistor. Current from the internal regulator starts the
controller. Once the tertiary winding voltage is estab-
lished the internal regulator is switched off and bias
current for running the IC is derived from the tertiary
winding. The internal oscillator is set to 275kHz and
trimmed to ±10%. This permits the use of small mag-
netic components to minimize board space. Both the
MAX5019 and MAX5020 can be used in power sup-
plies providing multiple output voltages. A functional
diagram of the IC is shown in Figure 1. Typical applica-
tions circuits for forward and flyback topologies are
shown in Figure 2 and Figure 3, respectively. For isolat-
ed flyback power supplies use the circuit of Figure 4.
Current-Mode Control
The MAX5019/MAX5020 offer current-mode control
operation with added features such as leading-edge
blanking with dual internal path that only blanks the
sensed current signal applied to the input of the PWM
comparator. The current limit comparator monitors the
CS pin at all times and provides cycle-by-cycle current
limit without being blanked. The leading-edge blanking
of the CS signal prevents the PWM comparator from
prematurely terminating the on cycle. The CS signal
contains a leading-edge spike that is the result of the
MOSFET gate charge current, capacitive and diode
reverse recovery current of the power circuit. Since this
leading-edge spike is normally lower than the current
limit comparator threshold, current limiting is not
blanked and cycle-by-cycle current limiting is provided
under all conditions.
Use the MAX5019 in discontinuous flyback applications
where wide line voltage and load current variation is
expected. Use the MAX5020 for single transistor for-
ward converters where the maximum duty cycle must
be limited to less than 50%.
Under certain conditions it may be advantageous to
use a forward converter with greater than 50% duty
cycle. For those cases use the MAX5019. The large
duty cycle results in much lower operating primary
RMS currents through the MOSFET switch and in most
cases a smaller output filter inductor. The major disad-
6
_______________________________________________________________________________________
相关PDF资料 |
PDF描述 |
|---|---|
| MAX1745EUB+ | IC REG CTRLR BUCK PWM 10-UMAX |
| MAX1761EEE+ | IC REG CTRLR BUCK PWM CM 16-QSOP |
| MAX5015ESA+ | IC REG CTRLR ISO PWM CM 8-SOIC |
| MAX5094BASA+ | IC REG CTRLR FLYBK DIV ISO 8SOIC |
| MAX1771ESA+ | IC REG CTRLR BST PWM 8-SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX5020CSA+ | 功能描述:电流型 PWM 控制器 w/Integrated Startup RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| MAX5020CSA+T | 功能描述:电流型 PWM 控制器 w/Integrated Startup RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| MAX5020CSA-T | 功能描述:电流型 PWM 控制器 w/Integrated Startup RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| MAX5020ESA | 功能描述:电流型 PWM 控制器 w/Integrated Startup RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| MAX5020ESA+ | 功能描述:电流型 PWM 控制器 w/Integrated Startup RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
发布紧急采购，3分钟左右您将得到回复。