- 您现在的位置：买卖IC网 > PDF目录1842 > MAX5053BEUA+ (Maxim Integrated Products)IC REG CTRLR BST ISO PWM 8-UMAX PDF资料下载
参数资料
| 型号： | MAX5053BEUA+ |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 11/13页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BST ISO PWM 8-UMAX |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 50 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 290kHz |
| 占空比： | 76% |
| 电源电压： | 10.8 V ~ 24 V |
| 降压： | 无 |
| 升压： | 是 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 8-TSSOP，8-MSOP（0.118"，3.00mm 宽） |
| 包装： | 管件 |
Current-Mode PWM Controllers with an Error
Amplifier for Isolated/Nonisolated Power Supplies
R CS = CS
Current Limit
The current-sense resistor (R CS ), connected between
the source of the MOSFET and ground, sets the current
limit. The CS input has a voltage-trip level (V CS ) of
291mV. Use the following equation to calculate the
value of R CS :
V
I PRI
Where I PRI is the peak current in the primary that flows
through the MOSFET.
When the voltage produced by this current (through the
current-sense resistor) exceeds the current-limit com-
parator threshold, the MOSFET driver (NDRV) quickly
terminates the current ON-cycle, typically within 60ns.
In most cases, a small RC filter is required to filter out
the leading-edge spike on the sense waveform. Set the
corner frequency at a few megahertz.
Applications Information
Primary Regulated, Isolated
Telecom Power Supply
Figure 5 shows a complete design of a dual-output power
supply with a telecom voltage range of 36V to 72V. An
important aspect of this power supply is its primary-side
regulation. This regulation, through the tertiary winding,
also acts as bias winding for the MAX5052.
In the circuit of Figure 5, cross-regulation has been
improved (tertiary and 5V outputs) by using chip induc-
tors, L1 and L2, and R7||R2. R7||R2 presents enough
loading on the tertiary winding output to allow ±5% load
regulation on the 5V output over a load current range
from 150mA to 1.5A.
Layout Recommendations
All printed circuit board traces carrying switching cur-
rents must be kept as short as possible, and the cur-
rent loops they form must be minimized. The pins of the
μMAX package have been placed to allow easy inter-
facing to the external MOSFET.
For universal AC input design, all applicable safety reg-
ulations must be followed. Offline power supplies may
require UL, VDE, and other similar agency approvals.
These agencies can be contacted for the latest layout
and component rules.
Typically there are two sources of noise emission in a
switching power supply: high di/dt loops and high dv/dt
surfaces. For example, traces that carry the drain cur-
rent often form high di/dt loops. Similarly, the heatsink
of the MOSFET presents a dv/dt source, thus the sur-
face area of the heatsink must be minimized as much
as possible.
To achieve best performance, a star ground connection
is recommended to avoid ground loops. For example,
the ground returns for the power-line input filter, power
MOSFET switch, and sense resistor should be routed
separately through wide copper traces to meet at a sin-
gle-system ground connection.
Chip Information
TRANSISTOR COUNT: 1449
PROCESS: BiCMOS
5V OUTPUT LOAD REGULATION
12V
L1
D1
15V
6.0
5.8
5.6
R2
Q1
C4
5.4
V IN
NDRV
R5
5.2
5.0
4.8
C1
C2
C3
V CC MAX5053
COMP
CS
GND
R1
R6
4.6
4.4
4.2
4.0
FB
UVLO/EN
R3
0.15
0.35
0.55
0.75
0.95
1.15
1.35
0V
I OUT (A)
Figure 7. Output Voltage Regulation for the Figure 5 Circuit
Figure 8. 12V to 15V Out Boost Regulator
______________________________________________________________________________________
11
相关PDF资料 |
PDF描述 |
|---|---|
| MAX5059AUI+ | IC DRVR SYNC RECT 28-TSSOP |
| MAX5060ATI+ | IC REG CTRLR BUCK PWM CM 28-TQFN |
| MAX5065EAI+ | IC REG CTRLR BUCK PWM CM 28-SSOP |
| MAX5066AUI+T | IC REG CTRLR BUCK PWM CM 28TSSOP |
| MAX5068DAUE+ | IC REG CTRLR FLYBK ISO 16-TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX5053BEUA+ | 功能描述:电流型 PWM 控制器 w/Error Amplifier RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| MAX5053BEUA+T | 功能描述:电流型 PWM 控制器 w/Error Amplifier RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| MAX5053BEUA-T | 功能描述:电流型 PWM 控制器 w/Error Amplifier RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| MAX5054 | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:4A, 20ns, Dual MOSFET Drivers |
| MAX5054_10 | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:4A, 20ns, Dual MOSFET Drivers |
发布紧急采购，3分钟左右您将得到回复。