- 您现在的位置：买卖IC网 > PDF目录385532 > MAX515 (Maxim Integrated Products, Inc.) 5V, Low-Power, Voltage-Output, Serial 10-Bit DACs(单通道,电压输出,串行,10位D/A转换器) PDF资料下载
参数资料
| 型号： | MAX515 |
| 厂商： | Maxim Integrated Products, Inc. |
| 英文描述： | 5V, Low-Power, Voltage-Output, Serial 10-Bit DACs(单通道,电压输出,串行,10位D/A转换器) |
| 中文描述： | 5V、低功耗、电压输出、串行10位DAC |
| 文件页数： | 10/16页 |
| 文件大小： | 175K |
| 代理商： | MAX515 |
M
Daisy-Chaining Devic es
The serial output, DOUT, allows cascading of two or more
DACs. The data at DIN appears at DOUT, delayed by 16
clock cycles plus one clock width. For low power, DOUT is
a CMOS output that does not require an external pull-up
resistor. DOUT does
not
go into a high-impedance state
when CS is high. DOUT changes on SCLK’s falling edge
when CS is low. When CS is high, DOUT remains in the
state of the last data bit.
Any number of MAX504/MAX515 DACs can be daisy-
chained by connecting the DOUT of one device to the DIN
of the next device in the chain. For proper timing, ensure
that t
CSS0
(CS low to SCLK high) is greater than t
DV
+ t
DS
.
Unipolar Configuration
The MAX504 is configured for a gain of 1 (0V to V
REFIN
unipolar output) by connecting BIPOFF and RFB to VOUT
(Figure 6). The converter operates from either single or
dual supplies in this configuration. See Table 1 for the
DAC-latch contents (input) vs. the analog VOUT (output).
In this range, 1LSB = V
REFIN
(2
-10
), where V
REF
is the
voltage on REFIN.
A gain of 2 (0V to 2V
REFIN
unipolar output) is set up by
connecting BIPOFF to AGND and RFB to VOUT (Figure
7). Table 2 shows the DAC-latch contents vs. VOUT. The
MAX504 operates from either single or dual supplies in
this mode. In this range,
1LSB = (2)(V
REFIN
)(2
-10
) = (V
REFIN
)(2
-9
).
The MAX515 is internally configured for unipolar gain of
2 operation.
Bipolar Configuration
A bipolar range is set up by connecting BIPOFF to
REFIN and RFB to VOUT, and operating from dual
(±5V) supplies (Figure 8). Table 3 shows the DAC-latch
contents (input) vs. VOUT (output). In this range,
1LSB = V
REFIN
(2
-9
).
Four-Quadrant Multiplic ation
The MAX504 can be used as a four-quadrant multiplier
by connecting BIPOFF to REFIN and RFB to VOUT, and
using (1) an offset binary digital code, (2) bipolar power
supplies, and (3) a bipolar analog input at REFIN within
the range V
SS
+ 2V to V
DD
- 2V, as shown in Figure 9.
In general, a 10-bit DAC’s output is (D)(V
REFIN)
(G),
where “G” is the gain (1 or 2) and “D” is the binary rep-
resentation of the digital input divided by 2
10
or 1,024.
This formula is precise for unipolar operation. However,
for bipolar, offset binary operation, the MSB is really a
polarity bit. No resolution is lost because the number of
steps is the same. The output voltage, however, has
been shifted from a range of, for example, 0V to 4.096V
(G = 2) to a range of -2.048V to +2.048V.
Keep in mind that when using the DAC as a four-quad-
rant multiplier, the scale is skewed. Negative full scale
is -V
REFIN
, while positive full scale is +V
REFIN
- 1LSB.
5V, Low-Power, Voltage-Output,
S erial 10-Bit DACs
10
______________________________________________________________________________________
MAX504
CONNECT BIPOFF
TOVOUT FOR G=1,
TOAGND FOR G=2,
OR TOREFIN FOR
BIPOLAR GAIN
INVERTED
R-2R DAC
DIN
DOUT SCLK
CS
CLR
2.048V
REFIN
REFOUT
AGNDDGND
V
DD
V
SS
0.1
μ
F
33
μ
F
0.1
μ
F
2R
2R
BIPOFF
RFB
VOUT
+5V
0V to -5V
MAX515
INVERTED
R-2R DAC
DIN
DOUT
SCLK
CS
REFIN
AGND
V
DD
VOUT
MAX515
ONLY
0.1
μ
F
2R
2R
+5V
Figure 3a. MAX504 Typical Operating Circuit
Figure 3b. MAX515 Typical Operating Circuit
相关PDF资料 |
PDF描述 |
|---|---|
| MAX518 | 2-Wire Serial 8-Bit DACs with Rail-to-Rail Outputs(单通道,串行,电压输出,8位D/A转换器) |
| MAX5195EGM | 14-Bit, 260Msps High-Dynamic Performance DAC |
| MAX520 | Quad/Octal, 2-Wire Serial 8-Bit DACs with Rail-to-Rail Outputs(四通道,串行,电压输出,8位DAC) |
| MAX5223EKA-T | Low - Power, Dual, 8 - Bit, Voltage Output Serial DAC in 8 - Pin SOT23 |
| MAX528 | Ocral 8 Bits DAC with Output Buffer(八通道,8位,电压输出,串行DAC) |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX5150 | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Low-Power, Dual, 13-Bit Voltage-Output DACs with Serial Interface |
| MAX5150ACEE | 功能描述:数模转换器- DAC RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| MAX5150ACEE+ | 功能描述:数模转换器- DAC 13-Bit 2Ch Precision DAC RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| MAX5150ACEE+T | 功能描述:数模转换器- DAC 13-Bit 2Ch Precision DAC RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| MAX5150ACEE-T | 功能描述:数模转换器- DAC RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。