参数资料
型号: MAX608EPA+
厂商: Maxim Integrated Products
文件页数: 9/12页
文件大小: 0K
描述: IC REG CTRLR BST PWM 8-PDIP
产品培训模块: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
标准包装: 50
PWM 型: 控制器
输出数: 1
频率 - 最大: 300kHz
占空比: 85%
电源电压: 1.8 V ~ 16.5 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 85°C
封装/外壳: 8-DIP(0.300",7.62mm)
包装: 管件
5V or Adjustable, Low-Voltage,
Step-Up DC-DC Controller
2.0
1.5
1.0
V OUT = 3.3V
L = 22 μ H
R SENSE = 25m ?
R SENSE = 35m ?
R SENSE = 50m ?
3.5
3.0
2.5
2.0
1.5
V OUT = 5V
L = 22 μ H
R SENSE = 20m ?
R SENSE = 25m ?
R SENSE = 35m ?
0.5
0
R SENSE = 100m ?
1.0
0.5
0
R SENSE = 50m ?
R SENSE = 100m ?
2.0
2.5
3.0
3.5
2
3 4
5
INPUT VOLTAGE (V)
Figure 4a. Maximum Output Current vs. Input Voltage
(V OUT = 3.3V)
INPUT VOLTAGE (V)
Figure 4b. Maximum Output Current vs. Input Voltage
(V OUT = 5V)
3.5
3.0
2.5
2.0
1.5
1.0
0.5
0
V OUT = 12V
L = 22 μ H
R SENSE = 20m ?
R SENSE = 25m ?
R SENSE = 35m ?
R SENSE = 50m ?
R SENSE = 100m ?
3.5
3.0
2.5
2.0
1.5
1.0
0.5
0
V OUT = 15V
L = 22 μ H
R SENSE = 20m ?
R SENSE = 25m ?
R SENSE = 35m ?
R SENSE = 50m ?
R SENSE = 100m ?
2
4
6 8
10
12
2
4
6
8 10 12
14
16
L ≥ —————----—--
INPUT VOLTAGE (V)
Figure 4c. Maximum Output Current vs. Input Voltage
(V OUT = 12V)
current will ramp up to a high level before the current-lim-
it comparator can turn off the switch. The minimum on-time
for the switch (t ON (min)) is approximately 2μs; select an
inductor that allows the current to ramp up to I LIM .
The standard operating circuits use a 22μH inductor.
If a different inductance value is desired, select L such
that:
V IN (max) x 2μs
I LIM
Larger inductance values tend to increase the start-up
time slightly, while smaller inductance values allow the
coil current to ramp up to higher levels before the
switch turns off, increasing the ripple at light loads.
INPUT VOLTAGE (V)
Figure 4d. Maximum Output Current vs. Input Voltage
(V OUT = 15V)
Inductors with a ferrite core or equivalent are recom-
mended; powder iron cores are not recommended for
use with high switching frequencies. Make sure the
inductor’s saturation current rating (the current at which
the core begins to saturate and the inductance starts to
fall) exceeds the peak current rating set by R SENSE .
However, it is generally acceptable to bias the inductor
into saturation by approximately 20% (the point where
the inductance is 20% below the nominal value). For
highest efficiency, use a coil with low DC resistance,
preferably under 20m ? . To minimize radiated noise,
use a toroid, a pot core, or a shielded coil.
Table 1 lists inductor suppliers and specific recom-
mended inductors.
_______________________________________________________________________________________
9
相关PDF资料
PDF描述
MAX1651CSA+T IC REG CTRLR BUCK PWM 8-SOIC
MAX1649CSA+T IC REG CTRLR BUCK PWM 8-SOIC
ISL88013IH529Z-TK IC VOLTAGE MONITOR DUAL SOT23-5
MAX16955AUE/V+T IC REG CTRLR BUCK PWM CM 16TSSOP
MAX1771CSA+T IC REG CTRLR BST PWM 8-SOIC
相关代理商/技术参数
参数描述
MAX608EPA+ 功能描述:DC/DC 开关控制器 5V or Adjustable Step-Up DC/DC Ctlr RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK
MAX608ESA 功能描述:DC/DC 开关控制器 5V or Adjustable Step-Up DC/DC Ctlr RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK
MAX608ESA+ 功能描述:DC/DC 开关控制器 5V or Adjustable Step-Up DC/DC Ctlr RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK
MAX608ESA+T 功能描述:DC/DC 开关控制器 5V or Adjustable Step-Up DC/DC Ctlr RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK
MAX608ESA-T 功能描述:DC/DC 开关控制器 5V or Adjustable Step-Up DC/DC Ctlr RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK