- 您现在的位置：买卖IC网 > PDF目录5315 > MAX6397TATA+T (Maxim Integrated Products)IC SW OVERVOLT PROT 8-TDFN PDF资料下载
参数资料
| 型号： | MAX6397TATA+T |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 10/18页 |
| 文件大小： | 0K |
| 描述： | IC SW OVERVOLT PROT 8-TDFN |
| 其它有关文件： | Automotive Product Guide |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 2,500 |
| 电压 - 工作： | 72V |
| 技术： | 混合技术 |
| 功率（瓦特）： | 1.45W |
| 电路数： | 1 |
| 应用： | 通用 |
| 封装/外壳： | 8-WDFN 裸露焊盘 |
| 供应商设备封装： | 8-TDFN-EP（3x3） |
| 包装： | 带卷 (TR) |
Overvoltage Protection Switch/Limiter
Controllers Operate Up to 72V
C OUT
V PEAK
GATE
V BATT
IN
MAX6397
OUT
R1
t RISE > 5ms
MAX6398 SET
V BATT
GND
R2
100ms
200ms
300ms
400ms
Figure 4. Overvoltage Limiter Protection Switch Configuration
As the transient begins decreasing, OUT fall time will
depend on the MOSFET’s GATE charge, the internal
charge-pump current, the output load, and the tank
capacitor at OUT.
For fast-rising transients and very large-sized MOSFETs,
add an additional external bypass capacitor from GATE
to GND to reduce the effect of the fast-rising voltages at
IN. The external capacitor acts as a voltage-divider
working against the MOSFETs’ drain-to-gate capaci-
tance. For a 6000pF C gd , a 0.1μF capacitor at GATE will
reduce the impact of the fast-rising V IN input.
Caution must be exercised when operating the
MAX6397/MAX6398 in voltage-limiting mode for long
durations. If the V IN is a DC voltage greater than the
MOSFET’s maximum gate voltage, the FET will dissipate
power continuously. To prevent damage to the external
MOSFET, proper heatsinking should be implemented.
Applications Information
Load Dump
Most automotive applications run off a multicell, 12V
Figure 5. Load Dump Voltage Profile
characteristics of the charging system (Figure 5).
These transients are capable of destroying semicon-
ductors on the first ‘fault event.’
Setting Overvoltage Thresholds
SET provides an accurate means to set the overvoltage
level for the MAX6397/MAX6398. Use a resistor-divider to
set the desired overvoltage condition (Figure 6). SET has
a rising 1.215V threshold with a 5% falling hysteresis.
Begin by selecting the total end-to-end resistance,
R TOTAL = R1 + R2. Choose R TOTAL to yield a total cur-
rent equivalent to a minimum 100 x I SET (SET’s input
bias current) at the desired overvoltage threshold.
For example:
With an overvoltage threshold set to 20V:
R TOTAL < 20V/(100 x I SET )
where I SET is SET’s 50nA input bias current.
R TOTAL < 4M ?
Use the following formula to calculate R2:
lead-acid battery with a nominal voltage that swings
between 9V and 16V (depending on load current,
charging status, temperature, battery age, etc.). The
R 2 = V TH ×
R TOTAL
V OV
battery voltage is distributed throughout the automobile
and is locally regulated down to voltages required by
the different system modules. Load dump occurs when
the alternator is charging the battery and the battery
becomes disconnected. Power in the alternator (essen-
tially an inductor) flows into the distributed power sys-
tem and elevates the voltage seen at each module. The
voltage spikes have rise times typically greater than
5ms and decays within several hundred milliseconds
but can extend out to 1s or more depending on the
where V TH is the 1.215V SET rising threshold and V OV
is the overvoltage threshold.
R2 = 243k ? , use a 240k ? standard resistor.
R TOTAL = R2 + R1, where R1 = 3.76M ? .
Use a 3.79M ? standard resistor.
A lower value for total resistance dissipates more
power but provides slightly better accuracy.
10
______________________________________________________________________________________
相关PDF资料 |
PDF描述 |
|---|---|
| MAX6397YATA+T | IC SW OVERVOLT PROT 8-TDFN |
| MAX6397ZATA+T | IC SW OVERVOLT PROT 8-TDFN |
| MAX6398ATT+T | IC SW OVERVOLT PROT 6-TDFN |
| 150260-2020-RB | CONN 60POS 2MM SOCKET STR PC SMD |
| MAX6399ATA+T | IC SW OVERVOLT PROT 8-TDFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX6397TA-TTA-T | 制造商:Maxim Integrated Products 功能描述:- Tape and Reel |
| MAX6397VATA | 制造商:Maxim Integrated Products 功能描述:OVERVOLTAGE PROTECTION SWITCH/LIMIT - Rail/Tube |
| MAX6397VATA+ | 制造商:Maxim Integrated Products 功能描述:VOLT SUPERVISOR CNTRLR 1.215V 8TDFN EP - Rail/Tube |
| MAX6397VATA+T | 功能描述:监控电路 Over Volt Protection Switch/Limiter RoHS:否 制造商:STMicroelectronics 监测电压数: 监测电压: 欠电压阈值: 过电压阈值: 输出类型:Active Low, Open Drain 人工复位:Resettable 监视器:No Watchdog 电池备用开关:No Backup 上电复位延迟（典型值）:10 s 电源电压-最大:5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:UDFN-6 封装:Reel |
| MAX6397VATA-T | 功能描述:监控电路 RoHS:否 制造商:STMicroelectronics 监测电压数: 监测电压: 欠电压阈值: 过电压阈值: 输出类型:Active Low, Open Drain 人工复位:Resettable 监视器:No Watchdog 电池备用开关:No Backup 上电复位延迟（典型值）:10 s 电源电压-最大:5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:UDFN-6 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。