- 您现在的位置：买卖IC网 > PDF目录67801 > MAX6651EEE+ (MAXIM INTEGRATED PRODUCTS INC) Fan-Speed Regulators and Monitors with SMBus™/I<sup>2</sup>C-Compatible Interface PDF资料下载
参数资料
| 型号： | MAX6651EEE+ |
| 厂商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分类： | 运动控制电子 |
| 英文描述： | Fan-Speed Regulators and Monitors with SMBus™/I<sup>2</sup>C-Compatible Interface |
| 中文描述： | BRUSHLESS DC MOTOR CONTROLLER, 0.1 A, PDSO16 |
| 封装： | QSOP-16 |
| 文件页数： | 2/25页 |
| 文件大小： | 235K |
| 代理商： | MAX6651EEE+ |
across the fan until the desired speed is reached. Open-
loop operation allows the C to regulate fan speed direct-
ly. The C reads the fan speed from the Tach-
ometer-Count Register. Based on the tachometer
count, the C decides if the fan speed requires adjust-
ment, and changes the voltage across the fan by writ-
ing an 8-bit word to the DAC Register. Full-on mode
applies the maximum voltage across the fan, forcing it
to spin at full speed. Configuring GPIO1 (see the
General-Purpose Input/Output section) as an active-low
input provides additional hardware control that fully
turns on the fan and overrides all software commands.
General-Purpose Input/Output
The GPIO pins connect to the drain of the internal N-
channel MOSFET and pullup resistor (Figure 5). When
the N-channel MOSFET is off (Table 5), the pullup resis-
tor provides a logic-level high output. However, with the
MOSFET off, the GPIO may serve as an input pin and
its state is read from the GPIO Status Register (Table
6). The MAX6650/MAX6651 power up with the MOSFET
off, so input signals may be safely connected to the
GPIO pins. When using the GPIO pin as a general-pur-
pose output, change the output by writing to the GPIO
Definition Register.
GPIO0 may be configured as an ALERT output that will
go low whenever a fault-condition is detected (see the
Alarm-Enable and Status Registers section). GPIO1
may be configured as a FULL ON input to allow hard-
ware control to fully turn on the fan in case of software
or C failure. GPIO2 (MAX6651 only) may be config-
ured as an internal clock output or as an external clock
input to allow synchronization of multiple devices.
Alarm-Enable and Status Registers
The alarms are enabled only when the appropriate bits of
the Alarm-Enable Register are set (Table 7). The maxi-
mum and minimum output level alarms function only
when the device is configured to operate in the closed-
loop mode (see the
Configuration-Byte Register section).
The Alarm Status Register allows the system to deter-
mine which alarm caused the alert output (Table 8).
The set-alarm and alert outputs clear after reading the
MAX6650/MAX6651
Fan-Speed Regulators and Monitors
with SMBus/I2C-Compatible Interface
10
______________________________________________________________________________________
Table 4. Configuration Byte Register
Figure 5. General-Purpose Input/Output Structure
MAX6650
MAX6651
100k
Ω
GPIO
STATUS
REGISTER
VCC
3.0V TO 5.5V
VCC
CBYPASS
GPIO_
GND
GPIO
DEFINITION
REGISTER
BIT
NAME
POR (DEFAULT)
STATE
FUNCTION
5 to 4
7 (MSB) to 6
—
0
Always 0
Operating Mode:
00 = Software full-on (default)
01 = Software off (shutdown)
10 = Closed-loop operation
11 = Open-loop operation
00
MODE
3
5/12V
1
Fan/Tachometer Voltage:
0 = 5V
1 = 12V (default)
2 to 0 (LSB)
SCALE
010
Prescaler Division:
000 = Divide by 1
001 = Divide by 2
010 = Divide by 4 (default)
011 = Divide by 8
100 = Divide by 16
相关PDF资料 |
PDF描述 |
|---|---|
| MAX6652AUB+ | Temperature Sensor and System Monitor in a 10-Pin µMAX |
| MAX6652AUB+T | Temperature Sensor and System Monitor in a 10-Pin µMAX |
| MAX6654MEE+ | 1°C Accurate Remote/Local Temperature Sensor with SMBus Serial Interface |
| MAX6654YMEE+ | 1°C Accurate Remote/Local Temperature Sensor with SMBus Serial Interface |
| MAX6655MEE+ | Dual Remote/Local Temperature Sensors and Four-Channel Voltage Monitors |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX6651EEE+ | 功能描述:马达/运动/点火控制器和驱动器 Fan-Speed Regulator & Monitor RoHS:否 制造商:STMicroelectronics 产品:Stepper Motor Controllers / Drivers 类型:2 Phase Stepper Motor Driver 工作电源电压:8 V to 45 V 电源电流:0.5 mA 工作温度:- 25 C to + 125 C 安装风格:SMD/SMT 封装 / 箱体:HTSSOP-28 封装:Tube |
| MAX6651EEE+T | 功能描述:马达/运动/点火控制器和驱动器 Fan-Speed Regulator & Monitor RoHS:否 制造商:STMicroelectronics 产品:Stepper Motor Controllers / Drivers 类型:2 Phase Stepper Motor Driver 工作电源电压:8 V to 45 V 电源电流:0.5 mA 工作温度:- 25 C to + 125 C 安装风格:SMD/SMT 封装 / 箱体:HTSSOP-28 封装:Tube |
| MAX6651EEE+TG074 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述: |
| MAX6651EEE-T | 功能描述:马达/运动/点火控制器和驱动器 RoHS:否 制造商:STMicroelectronics 产品:Stepper Motor Controllers / Drivers 类型:2 Phase Stepper Motor Driver 工作电源电压:8 V to 45 V 电源电流:0.5 mA 工作温度:- 25 C to + 125 C 安装风格:SMD/SMT 封装 / 箱体:HTSSOP-28 封装:Tube |
| MAX6651EVCMAXQU | 功能描述:电源管理模块 MAX6651 Evaluation Kit/Evaluation System RoHS:否 制造商:ROHM Semiconductor 产品:AC-DC Converters 最大输入电压:264 VAC 开关频率: 输出电压:10 V to 28.8 V 输出电流:350mA 负载调节: 最大工作温度:+ 60 C 尺寸:100 mm x 16 mm x 17 mm |
发布紧急采购，3分钟左右您将得到回复。