参数资料
型号: MAX7490EEE+
厂商: Maxim Integrated Products
文件页数: 18/18页
文件大小: 0K
描述: IC FILTER SW CAP DUAL 16-QSOP
产品培训模块: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
标准包装: 100
滤波器类型: 通用开关电容器
频率 - 截止或中心: 40kHz
滤波器数: 2
滤波器阶数: 2nd
电源电压: 4.5 V ~ 5.5 V
安装类型: 表面贴装
封装/外壳: 16-SSOP(0.154",3.90mm 宽)
供应商设备封装: 16-QSOP
包装: 管件
产品目录页面: 1424 (CN2011-ZH PDF)
MAX7490/MAX7491
Dual Universal Switched-Capacitor Filters
_______________________________________________________________________________________
9
2nd-Order Filter Stage
The MAX7490/MAX7491 are dual biquad filters. The
biquad topology allows the use of standard filter tables
and equations to implement simultaneous lowpass,
bandpass, and notch or highpass filters. Topologies
such as Butterworth, Chebyshev, Bessel, elliptic, as
well as custom algorithms are possible.
Internal Common Voltage
The COM pin sets the common-mode input voltage and
is internally biased to VDD/2 with a resistor-divider. The
resistors used are typically 250kΩ for the MAX7490,
and typically 80kΩ for the MAX7491. The common-
mode voltage is easily overdriven by an external volt-
age supply if desired. Bypass COM to the analog
ground with at least a 0.1F capacitor.
Inverting Inputs
Locate resistors that are connected to INV_ as close as
possible to INV_ to reduce stray capacitance and noise
pickup. INV_ are inverting inputs to continuous-time op
amps, and behave like a virtual ground. There is no
sampling energy present on these inputs.
Outputs
Each switched-capacitor section, together with two to
four external resistors, can generate all standard 2nd-
order functions: bandpass, lowpass, highpass, and
notch (band-reject) functions. Three of these functions
are simultaneously available. The maximum signal
swing is limited by the power-supply voltages used.
The amplifiers’ outputs in the MAX7490/MAX7491 are
able to swing to within approximately 0.2V of either
supply.
Driving coaxial cable, large capacitive loads, or total
resistive loads less than 10kΩ will degrade the total
harmonic distortion (THD) performance. Note that the
effective resistive load at the output must include both
the feedback resistors and any external load resistors.
Low-Power Shutdown Mode
The MAX7490/MAX7491 have a shutdown mode that is
activated by driving SHDN low. In shutdown mode, the
filter supply current reduces to < 1A (max), and the fil-
ter outputs become high impedance. The COM input
also becomes high impedance during shutdown. For
normal operation, drive SHDN high or connect to VDD.
__________Applications Information
Designing with the MAX7490/MAX7491 begins by
selecting the mode that best fits the desired circuit
requirements. Table 1 lists the available modes and
their relative advantages and disadvantages. Table 2
lists the different nomenclature used in the explanations
that follow.
Σ
NA/HPA (3)
SHDN
VDD (8)
GND (7)
CLK (9)
EXTCLK (10)
INVB (13)
COM (11)
R
INVA (4)
(6)
SA (5)
BPA (2)
LPA (1)
+
-
Σ
NB/HPB (14)
SB (12)
BPB (15)
LPB (16)
+
-
Figure 1. Block Diagram
相关PDF资料
PDF描述
MAX292CSA+ IC FILTER LOWPASS 8-SOIC
MAX291CPA+ IC FILTER LOWPASS 8-DIP
MAX295CSA+ IC FILTER LOWPASS 8-SOIC
MAX291CSA+ IC FILTER LOWPASS 8-SOIC
MAX7425EUA+ IC FILTER LOWPASS 5TH 8UMAX
相关代理商/技术参数
参数描述
MAX7490EEE+ 功能描述:有源滤波器 Dual Universal Switched-Cap RoHS:否 制造商:Maxim Integrated 通道数量:1 截止频率:150 KHz 电源电压-最大:11 V 电源电压-最小:4.74 V 最大工作温度:+ 85 C 安装风格:Through Hole 封装 / 箱体:PDIP N 封装:Tube
MAX7490EEE+T 功能描述:有源滤波器 Dual Universal Switched-Cap RoHS:否 制造商:Maxim Integrated 通道数量:1 截止频率:150 KHz 电源电压-最大:11 V 电源电压-最小:4.74 V 最大工作温度:+ 85 C 安装风格:Through Hole 封装 / 箱体:PDIP N 封装:Tube
MAX7490EEE-T 功能描述:有源滤波器 RoHS:否 制造商:Maxim Integrated 通道数量:1 截止频率:150 KHz 电源电压-最大:11 V 电源电压-最小:4.74 V 最大工作温度:+ 85 C 安装风格:Through Hole 封装 / 箱体:PDIP N 封装:Tube
MAX7491CEE 功能描述:有源滤波器 RoHS:否 制造商:Maxim Integrated 通道数量:1 截止频率:150 KHz 电源电压-最大:11 V 电源电压-最小:4.74 V 最大工作温度:+ 85 C 安装风格:Through Hole 封装 / 箱体:PDIP N 封装:Tube
MAX7491CEE+ 功能描述:有源滤波器 Dual Universal Switched-Cap RoHS:否 制造商:Maxim Integrated 通道数量:1 截止频率:150 KHz 电源电压-最大:11 V 电源电压-最小:4.74 V 最大工作温度:+ 85 C 安装风格:Through Hole 封装 / 箱体:PDIP N 封装:Tube