参数资料
型号: MAX868EUB+T
厂商: Maxim Integrated Products
文件页数: 6/12页
文件大小: 0K
描述: IC REG MULTI CONFIG ADJ 10UMAX
产品培训模块: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
标准包装: 2,500
类型: 切换式电容器(充电泵),倍增器,反相
输出类型: 可调式
输出数: 1
输出电压: -3.6 V ~ -11 V
输入电压: 1.8 V ~ 5.5 V
频率 - 开关: 270kHz ~ 630kHz
电流 - 输出: 30mA
同步整流器:
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 10-TFSOP,10-MSOP(0.118",3.00mm 宽)
包装: 带卷 (TR)
供应商设备封装: 10-µMAX
Regulated, Adjustable -2x
Inverting Charge Pump
(a)
(a)
C2+
IN
C2+
IN
C2-
C2-
C1+
C1+
V OUT
C1-
V OUT
C OUT
C1-
C OUT
(b)
C2+
C2-
(b)
IN
C1+
C2+
V OUT
C OUT
C1+
C1-
V OUT
GND
C1-
C2-
C OUT
Figure 2. a) In charge phase, the left-hand switches are
closed and the right-hand switches are open, charging the fly-
ing capacitors (C1 and C2) while the output capacitor (C OUT )
services the load. b) The equivalent circuit of the charge phase
of operation.
__________________Design Procedure
Setting the Output Voltage
Set the output voltage using two external resistors, R1
and R2, as shown in Figure 4. Since the input bias cur-
rent at FB has a 50nA maximum, large resistor values in
the feedback loop do not significantly degrade accura-
cy. Begin by selecting R2 in the 100k ? to 500k ? range,
and calculate R1 using the following equation:
Figure 3. a) In discharge phase, the left-hand switches are
open and the right-hand switches are closed, transferring
energy from the flying capacitors (C1 and C2) to the output
capacitor (C OUT ). b) The equivalent circuit of the discharge
phase of operation.
When the MAX868 is powered by an unregulated sup-
ply, such as when operating directly from a battery, use
any available positive reference voltage in the system.
Note that due to the MAX868’s doubling and inverting
charge-pump action, the output voltage is limited to
-2 x V IN .
Alternatively, to configure the MAX868 as a simple,
unregulated doubler-inverter (V OUT = -2 x V IN ), con-
nect FB to IN. In this configuration, the MAX868 runs at
R 1 = R 2 x
| V OUT |
V REF
its maximum oscillator frequency, operating as a con-
ventional, open-loop charge pump.
If multiple oscillator cycles are required to regulate the
where V OUT is the desired output voltage, and V REF is
any available regulated positive voltage. When the
MAX868 is powered by a regulated voltage, V IN can be
used as the reference for setting the output voltage.
output, reduce the values for R1 and R2, or parallel a
small capacitor (C C ) across R1 to compensate the
feedback loop and ensure stability. Choose the lowest
capacitor value that ensures stability; values up to 47pF
are adequate for most applications.
6
_______________________________________________________________________________________
相关PDF资料
PDF描述
MAX869LEEE+T IC SW P-CH HIGH SIDE 16-QSOP
MAX8704EUB+ IC REG LDO 1.5V/1.2V/ADJ 10-UMAX
MAX8707ETL+ IC CNTRLR MULTIPHASE 40TQFN
MAX8709BETI+T IC CNTRLR CCFL HI EFF 28-TQFN
MAX8719ETA+T IC REG LINEAR LP HV 8-TDFN
相关代理商/技术参数
参数描述
MAX868MUB/PR 制造商:Maxim Integrated Products 功能描述:- Rail/Tube
MAX86900EFD+ 制造商:Maxim Integrated Products 功能描述:FIRST GEN BIO SENSOR WITH RED AND IR LED INTEGRATED IN OESIP - Rail/Tube 制造商:Maxim Integrated Products 功能描述:SENSOR RED/IR LED OESIP
MAX86900EFD+T 制造商:Maxim Integrated Products 功能描述:FIRST GEN BIO SENSOR WITH RED AND IR LED INTEGRATED IN OESIP - Tape and Reel 制造商:Maxim Integrated Products 功能描述:SENSOR RED/IR LED OESIP
MAX86900EVSYS# 制造商:Maxim Integrated Products 功能描述:EVAL KIT FOR MAX86900
MAX8691YETL+ 制造商:Maxim Integrated Products 功能描述:THE MAXIM MAX8691YETL+ IS A HIGH-SIDE MOSFET DRIVER. - Rail/Tube 制造商:Maxim Integrated Products 功能描述:The Maxim MAX8691YETL+ is a High-Side MOSFET Driver.