参数资料
型号: MAX8715EUA+
厂商: Maxim Integrated Products
文件页数: 9/14页
文件大小: 0K
描述: IC REG BOOST ADJ 0.8A 8UMAX
标准包装: 50
类型: 升压(升压)
输出类型: 可调式
输出数: 1
输出电压: 2.6 V ~ 12 V
输入电压: 2.6 V ~ 5.5 V
PWM 型: 电流模式
频率 - 开关: 640kHz, 1.22MHz
电流 - 输出: 1.8A
同步整流器:
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 8-TSSOP,8-MSOP(0.118",3.00mm 宽)
包装: 管件
供应商设备封装: 8-uMAX
Low-Noise Step-Up DC-DC Converters
SHDN
SKIP
COMPARATOR
4 μ A
IN
BIAS
COMP
SKIP
SOFT-
START
SS
ERROR
FB
1.24V
AMPLIFIER
ERROR
COMPARATOR
CONTROL
AND DRIVER
N
LX
LOGIC
CLOCK
GND
FREQ
OSCILLATOR
SLOPE
COMPEN-
SATION
Σ
CURRENT
SENSE
5 μ A
MAX1790
MAX8715
Figure 2. Functional Diagram
Output-Current Capability
The output-current capability of the MAX1790/MAX8715
is a function of current limit, input voltage, operating fre-
quency, and inductor value. Because of the slope com-
pensation used to stabilize the feedback loop, the duty
cycle affects the current limit. The output-current capa-
bility is governed by the following equation:
I OUT(MAX) = [I LIM x (1.26 - 0.4 x Duty) -
0.5 x Duty x V IN / (f OSC x L)] x η x V IN / V OUT
where:
I LIM = current limit specified at 65% (see the Electrical
Characteristics )
Duty = duty cycle = (V OUT - V IN + V DIODE ) /
(V OUT - I LIM x R ON + V DIODE )
V DIODE = catch diode forward voltage at I LIM
η = conversion efficiency, 85% nominal
Soft-Start
The MAX1790/MAX8715 can be programmed for soft-
start upon power-up with an external capacitor. When the
shutdown pin is taken high, the soft-start capacitor (C SS )
is immediately charged to 0.5V. Then the capacitor is
charged at a constant current of 4μA (typ). During this
time, the SS voltage directly controls the peak inductor
current, allowing 0A at V SS = 0.5V to the full current limit
at V SS = 1.5V. The maximum load current is available
after the soft-start cycle is completed. When the shut-
down pin is taken low, the soft-start capacitor is
discharged to ground.
Frequency Selection
The MAX1790/MAX8715s ’ frequency can be user
selected to operate at either 640kHz or 1.2MHz.
Connect FREQ to GND for 640kHz operation. For a
1.2MHz switching frequency, connect FREQ to IN. This
allows the use of small, minimum-height external com-
ponents while maintaining low output noise. FREQ has
an internal pulldown, allowing the user the option of
leaving FREQ unconnected for 640kHz operation.
Shutdown
The MAX1790/MAX8715 are shut down to reduce the
supply current to 0.1μA when SHDN is low. In this
mode, the internal reference, error amplifier, compara-
tors, and biasing circuitry turn off while the n-channel
MOSFET is turned off. The boost converter’s output is
connected to IN by the external inductor and catch
diode.
Applications Information
Boost DC-DC converters using the MAX1790/MAX8715
can be designed by performing simple calculations for
a first iteration. All designs should be prototyped and
tested prior to production. Table 1 provides a list of
_______________________________________________________________________________________
9
相关PDF资料
PDF描述
LQW15AN4N1D00D INDUCTOR
LQW15AN43NJ00D INDUCTOR
GCC31DRTI CONN EDGECARD 62POS DIP .100 SLD
LQW15AN40NJ00D INDUCTOR
ECC50DCST CONN EDGECARD 100PS DIP .100 SLD
相关代理商/技术参数
参数描述
MAX8715EUA+ 功能描述:直流/直流开关转换器 Low-Noise Step-Up DC/DC Converter RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT
MAX8715EUA+T 功能描述:直流/直流开关转换器 Low-Noise Step-Up DC/DC Converter RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT
MAX8715EUA-T 功能描述:直流/直流开关转换器 RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT
MAX8716ETG 功能描述:接口 - 专用 RoHS:否 制造商:Texas Instruments 产品类型:1080p60 Image Sensor Receiver 工作电源电压:1.8 V 电源电流:89 mA 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:BGA-59
MAX8716ETG+ 功能描述:接口 - 专用 RoHS:否 制造商:Texas Instruments 产品类型:1080p60 Image Sensor Receiver 工作电源电压:1.8 V 电源电流:89 mA 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:BGA-59