- 您现在的位置：买卖IC网 > PDF目录8575 > MAX9505ETE+T (Maxim Integrated Products)IC VIDEO AMP W/FILTER 16-TQFN PDF资料下载
参数资料
| 型号： | MAX9505ETE+T |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 2/16页 |
| 文件大小： | 0K |
| 描述： | IC VIDEO AMP W/FILTER 16-TQFN |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 1 |
| 系列： | DirectDrive® |
| 应用： | 滤波器 |
| 电路数： | 1 |
| 电流 - 电源： | 12mA |
| 电流 - 输出 / 通道： | 50mA |
| 电压 - 电源，单路/双路(±)： | 2.7 V ~ 3.6 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-WFQFN 裸露焊盘 |
| 供应商设备封装： | 16-TQFN-EP（3x3） |
| 包装： | 标准包装 |
| 产品目录页面： | 1392 (CN2011-ZH PDF) |
| 其它名称： | MAX9505ETE+TDKR |
MAX9505
DirectDrive Video Amplifier with
Reconstruction Filter and Analog Switch
10
______________________________________________________________________________________
Video Amplifier
Typically, the black level of the video signal created by
the video DAC is around 300mV. The MAX9505 shifts
the black level to ground at the output. Therefore, the
active video is above ground, and sync is below
ground. The amplifier needs a negative supply for its
output stage to remain in its linear region when driving
sync below ground.
The MAX9505 has an integrated charge pump and linear
regulator to create a low-noise negative supply from the
positive supply voltage. The charge pump inverts the
positive supply to create a raw negative voltage that is
then fed into the linear regulator, which outputs -2V. The
linear regulator filters out the charge-pump noise.
Comparison Between DirectDrive Output
and AC-Coupled Output
The actual level of the video signal varies less with a
DirectDrive output than an AC-coupled output. The
video signal average can change greatly depending
upon the picture content. With an AC-coupled output,
the average will change according to the time constant
formed by the series capacitor and series resistance
(usually 150
). For example, Figure 3 shows an AC-
coupled video signal alternating between a completely
black screen and a completely white screen. Notice the
excursion of the video signal as the screen changes.
With the DirectDrive amplifier, the black level is held at
ground. The video signal is constrained between
-0.3V to +0.7V. Figure 4 shows the video signal from a
DirectDrive amplifier with the same input signal as the
AC-coupled system.
Analog Switch
The MAX9505 features an internal 4.4
(max) analog
normally open switch that interfaces with a 4-pole multi-
media jack in which one of the poles can be set to a
video input, a video output, or a microphone input. The
switch has three modes of operation: open, normal
switch, and extended range switch. In normal switch
mode, the analog range is from 0V to VDD. In extended-
range switch mode, the analog range is from -2V to
VDD. Logic inputs MODE1 and MODE0 control the ana-
log switch operating modes (Table 1).
Video Reconstruction Filter
Before the video signal from the DAC can be amplified,
it must be lowpass filtered to smooth the steps and to
reduce the spikes created whenever the DAC output
changes value. In the frequency domain, the steps and
spikes cause images of the video signal to appear at
multiples of the sampling clock. The MAX9505 contains
a six-pole Butterworth lowpass filter. The passband
extends to 5.5MHz, and the minimum attenuation is
35dB at 27MHz.
Operating Modes
The MAX9505 uses two logic inputs to set the device
into one of the following modes: 1) shutdown mode, 2)
extended-range switch mode, 3) video output mode,
and 4) normal switch mode.
In video output mode, the video circuitry is on, the
charge pump is on, and the analog switch is open. In
normal switch mode, the analog switch is closed, and
the video circuitry and charge pump are off. In the
extended-range switch mode, the charge pump is on
and the analog switch is closed. Shutdown mode
reduces the supply current to 10nA typically (see Table
1 and Typical Application Circuits).
INPUT
500mV/div
OUTPUT
500mV/div
2ms/div
0V
Figure 3. AC-Coupled Output
INPUT
500mV/div
OUTPUT
500mV/div
2ms/div
0V
Figure 4. DirectDrive Output
相关PDF资料 |
PDF描述 |
|---|---|
| LTC1597-1ACG | IC D/A CONV 16BIT PAR 28-SSOP |
| LTC1597ACG | IC D/A CONV 16BIT PAR 28-SSOP |
| MAX9586AZK+T | IC AMP VIDEO FILTER TSOT23-5 |
| AD7837AR | IC DAC 12BIT DUAL MULT 24-SOIC |
| VE-B6W-MY-B1 | CONVERTER MOD DC/DC 5.5V 50W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX9507ATE+ | 功能描述:视频放大器 1.8V DirectDrive Video Filter Amp RoHS:否 制造商:ON Semiconductor 通道数量:4 电源类型: 工作电源电压:3.3 V, 5 V 电源电流: 最小工作温度: 最大工作温度: 封装 / 箱体:TSSOP-14 封装:Reel |
| MAX9507ATE+T | 功能描述:视频放大器 1.8V DirectDrive Video Filter Amp RoHS:否 制造商:ON Semiconductor 通道数量:4 电源类型: 工作电源电压:3.3 V, 5 V 电源电流: 最小工作温度: 最大工作温度: 封装 / 箱体:TSSOP-14 封装:Reel |
| MAX9507EVCMAXQU+ | 功能描述:放大器 IC 开发工具 MAX9507 Eval Kit RoHS:否 制造商:International Rectifier 产品:Demonstration Boards 类型:Power Amplifiers 工具用于评估:IR4302 工作电源电压:13 V to 23 V |
| MAX9507EVKIT | 功能描述:视频放大器 RoHS:否 制造商:ON Semiconductor 通道数量:4 电源类型: 工作电源电压:3.3 V, 5 V 电源电流: 最小工作温度: 最大工作温度: 封装 / 箱体:TSSOP-14 封装:Reel |
| MAX9507EVKIT+ | 功能描述:放大器 IC 开发工具 MAX9507 Eval Kit RoHS:否 制造商:International Rectifier 产品:Demonstration Boards 类型:Power Amplifiers 工具用于评估:IR4302 工作电源电压:13 V to 23 V |
发布紧急采购，3分钟左右您将得到回复。