- 您现在的位置：买卖IC网 > PDF目录10268 > MAX9758ETJ+ (Maxim Integrated Products)IC AMP AUDIO PWR 2.3W AB 32TQFN PDF资料下载
参数资料
| 型号： | MAX9758ETJ+ |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 5/31页 |
| 文件大小： | 0K |
| 描述： | IC AMP AUDIO PWR 2.3W AB 32TQFN |
| 标准包装： | 60 |
| 系列： | DirectDrive® |
| 类型： | AB 类 |
| 输出类型： | 2-通道（立体声）带立体声耳机 |
| 在某负载时最大输出功率 x 通道数量： | 2.3W x 2 @ 3 欧姆; 130mW x 2 @ 16 欧姆 |
| 电源电压： | 4.5 V ~ 5.5 V |
| 特点： | 消除爆音，短路保护和热保护，关机，音量控制 |
| 安装类型： | 表面贴装 |
| 供应商设备封装： | 32-TQFN-EP（5x5） |
| 封装/外壳： | 32-WFQFN 裸露焊盘 |
| 包装： | 管件 |
第1页第2页第3页第4页当前第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页
MAX9756/MAX9757/MAX9758
2.3W Stereo Speaker Amplifiers and DirectDrive
Headphone Amplifiers with Automatic Level Control
______________________________________________________________________________________
13
Detailed Description
The MAX9756/MAX9757/MAX9758 combine dual, 2W
BTL stereo audio power amplifiers with a DirectDrive
headphone amplifier in a single device. The stereo
power amplifiers deliver up to 2.3W per channel into a
3Ω speaker from a 5V supply and the stereo head-
phone amplifiers deliver up to 130mW per channel into
a 16Ω headphone from a 5V supply.
The MAX9756/MAX9757 feature ALC that automatically
controls output power to the speaker, preventing loud-
speaker, overload and provides optimized dynamic
range.
The MAX9756/MAX9757/MAX9758 feature 31-step ana-
log volume control and a BEEP input. The amplifier
gain is pin programmable. These devices feature click-
and-pop suppression, eliminating the need for discrete
muting circuitry. Speaker and headphone outputs have
short-circuit and thermal protection.
The MAX9756/MAX9758s’ internal LDO features
Maxim’s Dual Mode feedback. The LDO output volt-
age is either fixed at 4.65V (SET = GND), or adjusted
between 1.23V and 5V using a resistive divider at SET.
The LDO delivers up to 150mA of continuous current,
and can be enabled independently from the audio
amplifiers. Short-circuit and thermal-overload protec-
tion are provided for the LDO.
All devices feature a single-supply voltage, a shut-
down mode, logic-selectable gain, and a headphone
sense input. Industry-leading click-and-pop suppres-
sion eliminates audible transients during power and
shutdown cycles.
Each signal path consists of an input amplifier that sets
the signal-path gain and feeds both the speaker and
headphone amplifiers (Figure 1). The speaker amplifier
uses a BTL architecture, doubling the voltage drive to
the speakers and eliminating the need for DC-blocking
capacitors. The output consists of two signals, identical
in magnitude, but 180° out of phase.
The headphone amplifiers use Maxim’s DirectDrive
architecture that eliminates the bulky output DC-blocking
capacitors required by traditional headphone amplifiers.
A charge pump inverts the positive supply (CPVDD), cre-
ating a negative supply (CPVSS). The headphone ampli-
fiers operate from these bipolar supplies with their
outputs biased about GND (Figure 2).
The amplifiers have almost twice the supply range
compared to other single-supply amplifiers, nearly qua-
drupling the available output power. The benefit of the
GND bias is that the amplifier outputs do not have a DC
component (typically VDD/2). This eliminates the large
DC-blocking capacitors required with conventional
headphone amplifiers, conserving board space and
system cost while improving frequency response.
OUT_+
OUT_-
VOLUME
CONTROL
BIAS
IN_
VOL
BIAS
HP_
GND
ALC
Figure 1. MAX9756/MAX9757 Signal Path
+VDD
-VDD
GND
CONVENTIONAL DRIVER-BIASING SCHEME
DirectDrive BIASING SCHEME
VDD/2
VDD
GND
VOUT
Figure 2. Traditional Headphone Amplifier Output Waveform
vs. DirectDrive Headphone Amplifier Output Waveform
Dual Mode is a trademark of Maxim Integrated Products, Inc.
相关PDF资料 |
PDF描述 |
|---|---|
| MS27656T13F8PC | CONN RCPT 8POS WALL MNT W/PINS |
| MAX9770ETI+ | IC AMP AUDIO 1.2W MONO D 28TQFN |
| MAX9757ETJ+ | IC AMP AUDIO PWR 2.3W AB 32TQFN |
| MAX9750BETI+ | IC AMP AUDIO PWR 2.6W AB 28TQFN |
| MS27656E13F8PC | CONN RCPT 8POS WALL MNT W/PINS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX9758ETJ+ | 功能描述:音频放大器 Integrated Circuits (ICs) RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
| MAX9758ETJ+T | 功能描述:音频放大器 Integrated Circuits (ICs) RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
| MAX9759ETE+ | 功能描述:音频放大器 3.2W Low-EMI Class D Amplifier RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
| MAX9759ETE+T | 功能描述:音频放大器 3.2W Low-EMI Class D Amplifier RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
| MAX9759EUE+ | 制造商:Maxim Integrated Products 功能描述:- Rail/Tube |
发布紧急采购，3分钟左右您将得到回复。