![](http://datasheet.mmic.net.cn/30000/MB89215PFV_datasheet_2367216/MB89215PFV_3.png)
MB89210 Series
3
s
s PRODUCT LINEUP
* : The minimum operating voltage varies with the operating frequency, the function and the connected ICE.
Note : Unless otherwise stated, clock periods and conversion times are for 10 MHz operation with the internal clock
operating at maximum speed.
Part number
MB89215
MB89F217
MB89P215
MB89PV210
Parameter
Type
For mass products
(Mask ROM
product)
Flash products
(Flash ROM
product)
One-time product
(for small-scale
production)
Piggy back/
Evaluation product
(for development)
ROM capacity
16 Kbyte
(Built-in ROM)
32 Kbyte
(Built-in Flash
memory)
16 Kbyte
(Built-in PROM)
32 Kbyte
(External EPROM)
RAM capacity
512 byte
1 Kbyte
512 byte
2 Kbyte
CPU functions
Number of basic instructions
: 136
Instruction bit length
: 8 bits
Instruction length
: 1 to 3 bytes
Data bit length
: 1, 8, and 16 bits
Minimum instruction execution time : 0.32
s to 5.12 s (at 12.5 MHz)
Interruption processing time
: 2.88
s to 46.08 s (at 12.5 MHz)
Ports
General purpose I/O port
× 21 (also usable as resources) General purpose input port
× 1
21-bit time base timer
21 bits
Interrupt cycle : at 10 MHz (0.82 ms,3.3 ms,26.2 ms,419.4 ms)
Watchdog timer
Reset generation cycle : at 10 MHz (Min 419.4 ms)
8-bit PWM timer
8-bit interval timer operation (supports square wave output, operating clock period :
0.4
s to 25.6 s)
8-bit resolution PWM operation (conversion period : 102.4
s to 26.84 s )
8/16-bit capture timer
counter
8-bit capture timer/counter
× 1 channel + 8-bit timer
or 16-bit capture timer/counter
× 1 channel
Capable of event count operation and square wave output using external clock input
with 8-bit timer 0 or 16-bit counter
LIN-UART
Full duplex, Synchronous/asynchronous transfer (with start/stop bit), Capable of
setting over 30,000 different baud rates using a 15-bit reload counter
Support for the LIN protocol, slave nodes, and LIN synch break/sync field detection
8-bit serial I/O
8-bit length, Selectable LSB first or MSB first
Transfer clock (0.8
s external, 0.8 s, 3.2 s, 12.8 s internal)
12-bit PPG timer
Output requency : Selectable pulth width and cycle (Cycle : 1.6
s to 419.3 ms )
External interrupt
circuit
3-channel (interrupt vector, request flag, requesr output acceptance)
Edge selectable (selectable rising, falling or both edge)
Can be use for recovery from stop or sleep mode (edge detection also available in
stop mode).
A/D converter
10-bit accurasy
× 8-channel
A/D conversion function (conversion time : 15.2
s/10 MHz)
Continuous activation by an 8-/16-bit timer/counter output or time base timer output
capable.
Standby mode
Sleep mode and Stop mode
Operating voltage *
3.5 V to 5.5 V
CR(built-in) oscillator
Yes
No
Peripheral
functions