参数资料
| 型号： | MC100EL1648MELG |
| 厂商： | ON Semiconductor |
| 文件页数： | 16/16页 |
| 文件大小： | 0K |
| 描述： | IC OSC VCO 1.1GHZ 14SOEIAJ |
| 标准包装： | 1 |
| 系列： | 100EL |
| 类型： | VCO |
| 频率： | 1.1GHz |
| 电源电压： | 4.2 V ~ 5.5 V |
| 电流 - 电源： | 19mA |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 14-SOIC（0.209"，5.30mm 宽） |
| 包装： | 剪切带 (CT) |
| 供应商设备封装： | SOEIAJ-14 |
| 安装类型： | 表面贴装 |
| 其它名称： | MC100EL1648MELGOSCT |
MC100EL1648
http://onsemi.com
9
VOLTAGE CONTROLLED MODE
The tank circuit configuration presented in Figure 11,
Voltage Controlled Varactor Mode, allows the VCO to be
tuned across the full operating voltage of the power supply.
Deriving from Figure 6, the tank capacitor, C, is replaced
with a varactor diode whose capacitance changes with the
voltage applied, thus changing the resonant frequency at
which the VCO tank operates as shown in Figure 3, tank
option #1. The capacitive component in Equation 1 also
needs to include the input capacitance of the device and
other circuit and parasitic elements.
Figure 11. Voltage Controlled Varactor Mode
50
70
90
110
130
150
170
190
02
46
8
10
FREQUENCY
(MHz)
Vin, INPUT VOLTAGE (V)
Figure 12. Plot 1. Dual Varactor MMBV609,
VIN vs. Frequency
C
L
4 (3)
VCC
3 (1)
2 (14)
VIN
FOUT
Tank #1
8 (10)
1 (12)
*
0.1 mF0.1 mF
5 (5)
6 (7) 7 (8)
VEE
0.1 mF 0.1 mF
0.01 mF
100 mF
**
1 KW
*Use high impedance probe (>1.0 MegW must be used).
**The 1200 W resistor and the scope termination imped-
ance constitute a 25:1 attenuator probe. Coax shall be
CT07050 or equivalent.
L = Micro Metal torroid #T2022, 8 turns #30
Enameled Copper wire (@ 40 nH)
C = MMBV609
8 pin (14 pin) lead package
When operating the oscillator in the voltage controlled
mode with Tank Circuit #1 (Figure 3), it should be noted that
the cathode of the varactor diode (D), pin 8 (for 8 lead
package) or pin 10 (for 14 lead package) should be biased at
least 1.4 V above VEE.
Typical
transfer
characteristics
employing
the
capacitance of the varactor diode (plus the input capacitance
of the device, about 6.0 pF typical) in the voltage controlled
mode is shown in Plot 1, Dual Varactor MMBV609 Vin vs.
accuracy of the measured frequency with the different
variable capacitance values. The 1.0 k
W resistor in Figure 11
is used to protect the varactor diode during testing. It is not
necessary as long as the dc input voltage does not cause the
diode to become forward biased. The tuning range of the
oscillator in the voltage controlled mode may be calculated
as follows:
f max
f min
+
CD(max) ) CS
CD(min) ) CS
Where
f min +
1
2p
L(CD(max) ) CS
Where
CS = Shunt Capacitance (input plus external
capacitance)
CD = Varactor Capacitance as a function of bias
voltage
Good RF and lowfrequency bypassing is necessary on
the device power supply pins. Capacitors on the AGC pin
and the input varactor trace should be used to bypass the
AGC point and the VCO input (varactor diode),
guaranteeing only dc levels at these points. For output
frequency operation between 1.0 MHz and 50 MHz, a 0.1
mF
capacitor is sufficient. At higher frequencies, smaller values
of capacitance should be used; at lower frequencies, larger
values of capacitance. At high frequencies, the value of
bypass capacitors depends directly on the physical layout of
the system. All bypassing should be as close to the package
pins as possible to minimize unwanted lead inductance.
Several different capacitors may be needed to bypass
various frequencies.
相关PDF资料 |
PDF描述 |
|---|---|
| MC100EP195BMNG | IC DELAY LINE 1024TAP 32-QFN |
| MC100EP196BFAG | IC DELAY LINE 1024TAP 32-LQFP |
| MC100EP196FAR2 | IC DELAY LINE 1024TAP 32-LQFP |
| MC10E195FNR2 | IC DELAY LINE 128TAP 28-PLCC |
| MC10E196FNR2 | IC DELAY LINE 128TAP 28-PLCC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MC100EL1648MG | 功能描述:VCO振荡器 BBG ECL Low PWR VCO RoHS:否 制造商:Exar 封装 / 箱体:SOIC-14 频率:300 kHz 负载电容: 封装:Reel 电源电压:4.5 V to 20 V 尺寸:4 mm W x 8.75 mm L x 1.75 mm H 最小工作温度:0 C 最大工作温度:+ 70 C |
| MC100EL1648MNR4 | 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:5 V ECL Voltage Controlled Oscillator Amplifier |
| MC100EL1648MNR4G | 功能描述:两极晶体管 - BJT BBG ECL LOW PWER VCO RoHS:否 制造商:STMicroelectronics 配置: 晶体管极性:PNP 集电极—基极电压 VCBO: 集电极—发射极最大电压 VCEO:- 40 V 发射极 - 基极电压 VEBO:- 6 V 集电极—射极饱和电压: 最大直流电集电极电流: 增益带宽产品fT: 直流集电极/Base Gain hfe Min:100 A 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PowerFLAT 2 x 2 |
| MC100EL16D | 功能描述:缓冲器和线路驱动器 5V ECL Differential RoHS:否 制造商:Micrel 输入线路数量:1 输出线路数量:2 极性:Non-Inverting 电源电压-最大:+/- 5.5 V 电源电压-最小:+/- 2.37 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Reel |
| MC100EL16D | 制造商:ON Semiconductor 功能描述:IC ECL 100 SMD 100EL16 SOIC8 |
发布紧急采购，3分钟左右您将得到回复。