- 您现在的位置：买卖IC网 > PDF目录16589 > MC33886PVW (Freescale Semiconductor)IC H-BRIDGE 5.0A OUTPUT 20HSOP PDF资料下载
参数资料
| 型号： | MC33886PVW |
| 厂商： | Freescale Semiconductor |
| 文件页数： | 24/28页 |
| 文件大小： | 0K |
| 描述： | IC H-BRIDGE 5.0A OUTPUT 20HSOP |
| 标准包装： | 30 |
| 应用： | DC 电机控制器，H 桥式 |
| 评估套件： | 可供 |
| 输出数： | 1 |
| 电流 - 输出： | 5A |
| 电源电压： | 5 V ~ 40 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-SOIC（0.433"，11.00mm 宽）裸露焊盘 |
| 供应商设备封装： | 20-HSOP |
| 包装： | 管件 |
| 配用： | KIT33887EKEVBE-ND - BOARD EVALUATION FOR MC33887 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页当前第24页第25页第26页第27页第28页
5.0 A H-BRIDGE
THERMAL ADDENDUM - REVISION 2.0
5.0 A H-BRIDGE
33886HSOP
THERMAL ADDENDUM - REVISION 2.0
Introduction
This thermal addendum is provided as a supplement to the MC33186 technical
20-PIN HSOP-EP
data sheet. The addendum provides thermal performance information that may
be critical in the design and development of system applications. All electrical,
application, and packaging information is provided in the data sheet.
Packaging and Thermal Considerations
The MC33186 is offered in a 20 pin HSOP exposed pad, single die package.
There is a single heat source (P), a single junction temperature (T J ), and thermal
resistance (R ? JA ).
VW (Pb-FREE) SUFFIX
T J
=
R ? JA
.
P
98ASH70702A
20-PIN HSOP-EP
The stated values are solely for a thermal performance comparison of one
package to another in a standardized environment. This methodology is not
meant to and will not predict the performance of a package in an application-
specific environment. Stated values were obtained by measurement and
simulation according to the standards listed below.
Standards
Note For package dimensions, refer to
the 33886 device data sheet.
Table 7.
Thermal Performance Comparison
Thermal Resistance
R ? JA (1)(2)
?? C/W]
20
1.0
1.0
R ? JB (2)(3)
R ? JA (1)(4)
6.0
52
0.2
0.2
R ? JC
1.0
* All measurements
are in millimeters
NOTES:
1.Per JEDEC JESD51-2 at natural convection, still air condition.
2.2s2p thermal test board per JEDEC JESD51-5 and JESD51-7.
Soldermast
openings
3.Per JEDEC JESD51-8, with the board temperature on the center
trace near the center lead.
20 Terminal HSOP-EP
1.27 mm Pitch
Thermal vias
connected to top
buried plane
4.Single layer thermal test board per JEDEC JESD51-3 and
JESD51-5.
5.Thermal resistance between the die junction and the exposed
pad surface; cold plate attached to the package bottom side,
remaining surfaces insulated.
16.0 mm x 11.0 mm Body
12.2 mm x 6.9 mm Exposed Pad
Figure 24. Thermal Land Pattern for Direct Thermal
Attachment According to JESD51-5
33886
Analog Integrated Circuit Device Data ?
24
Freescale Semiconductor
相关PDF资料 |
PDF描述 |
|---|---|
| CI100505-10NJ | INDUCTOR MULTI LAYER CHIP 10NH |
| CI100505-8N2J | INDUCTOR MULTI LAYER CHIP 8.2NH |
| CI100505-6N8J | INDUCTOR MULTI LAYER CHIP 6.8NH |
| ECM18DCBS-S189 | CONN EDGECARD 36POS R/A .156 SLD |
| CI100505-4N7D | INDUCTOR MULTI LAYER CHIP 4.7NH |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MC33886PVWR2 | 功能描述:马达/运动/点火控制器和驱动器 5.0 A H-BRIDGE RoHS:否 制造商:STMicroelectronics 产品:Stepper Motor Controllers / Drivers 类型:2 Phase Stepper Motor Driver 工作电源电压:8 V to 45 V 电源电流:0.5 mA 工作温度:- 25 C to + 125 C 安装风格:SMD/SMT 封装 / 箱体:HTSSOP-28 封装:Tube |
| MC33886VW | 功能描述:马达/运动/点火控制器和驱动器 5.0 A H-BRIDGE RoHS:否 制造商:STMicroelectronics 产品:Stepper Motor Controllers / Drivers 类型:2 Phase Stepper Motor Driver 工作电源电压:8 V to 45 V 电源电流:0.5 mA 工作温度:- 25 C to + 125 C 安装风格:SMD/SMT 封装 / 箱体:HTSSOP-28 封装:Tube |
| MC33886VWR2 | 功能描述:马达/运动/点火控制器和驱动器 5.0 A H-BRIDGE RoHS:否 制造商:STMicroelectronics 产品:Stepper Motor Controllers / Drivers 类型:2 Phase Stepper Motor Driver 工作电源电压:8 V to 45 V 电源电流:0.5 mA 工作温度:- 25 C to + 125 C 安装风格:SMD/SMT 封装 / 箱体:HTSSOP-28 封装:Tube |
| MC33887APVW | 功能描述:马达/运动/点火控制器和驱动器 H-BRIDGE W/LD CURNT FDBK RoHS:否 制造商:STMicroelectronics 产品:Stepper Motor Controllers / Drivers 类型:2 Phase Stepper Motor Driver 工作电源电压:8 V to 45 V 电源电流:0.5 mA 工作温度:- 25 C to + 125 C 安装风格:SMD/SMT 封装 / 箱体:HTSSOP-28 封装:Tube |
| MC33887APVW-PB | 制造商:Freescale Semiconductor 功能描述: |
发布紧急采购，3分钟左右您将得到回复。