- 您现在的位置：买卖IC网 > PDF目录359133 > MC33991 (飞思卡尔半导体(中国)有限公司) Gauge Driver Integrated Circuit(标尺驱动器集成电路) PDF资料下载
参数资料
| 型号： | MC33991 |
| 厂商： | 飞思卡尔半导体(中国)有限公司 |
| 英文描述： | Gauge Driver Integrated Circuit(标尺驱动器集成电路) |
| 中文描述： | 仪表驱动集成电路（标尺驱动器集成电路） |
| 文件页数： | 13/36页 |
| 文件大小： | 660K |
| 代理商： | MC33991 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页当前第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
MOTOROLA ANALOG INTEGRATED CIRCUIT DEVICE DATA
33991
13
TIMING DESCRIPTIONS AND DIAGRAMS
Figure 4. Single 16-bit Word SPI Communication
Figure 5. Multiple 16-bit Word SPI Communication
Data Input
The Input Shift register captures data at the falling edge of
the SCLK clock. The SCLK clock pulses exactly 16 times only
inside the transmission windows (CS in a logic [0] state). By the
time the CS signal goes to logic [1] again, the contents of the
Input Shift register are transferred to the appropriate internal
register, according to the address contained in bits 15-13. The
minimum time CS should be kept high depends on the internal
clock speed. That data is specified in the SPI Interface Timing
table. It must be long enough so the internal clock is able to
capture the data from the Input Shift register and transfer it to
the internal registers.
Data Output
At the first rising edge of the SCLK clock, with the CS at logic
[0], the contents of the status word register are transferred to
the Output Shift register. The first 16 bits clocked out are the
statusbits.Ifdatacontinuestoclockinbeforethe CStransitions
to a logic [1], the device begins to shift out the data previously
clocked in FIFO after the CS first transitioned to logic [0].
COMMUNICATION MEMORY MAPS
The 33991device is capable of interfacing directly with a
microcontroller, via the 16-bit SPI protocol described and
specified below. The device is controlled by the microprocessor
and reports back status information via the SPI. This section
provides a detailed description of all registers accessible via
serial interface. The various registers control the behavior of
this device.
A message is transmitted by the master starting with the
MSB (D15) and ending with the LSB (D0). Multiple messages
can be transmitted in succession to accommodate those
applications where daisy chaining is desirable, or to confirm
transmitted data, as long as the messages are all multiples of
16 bits. Data will transfer through daisy chained devices,
illustrated in Figure 5. If an attempt is made to latch in a
message smaller than 16-bits wide, it is ignored.
The 33991uses six registers to con the device and control
the state of the four H-bridge outputs. Registers are addressed
via D15-D13 of the incoming SPI word. Refer to Table 2.
Internal registers are
loaded som etim e
C S B
S I
S C LK
D 15
D 1
D 2
D 3
D 4
D 5
D 6
D 7
D 8
D 9
D 14
D 13
D 12
D 11
D 10
O D 12
D 0
O D 13
O D 14
O D 15
O D 6
O D 7
O D 8
O D 9
O D 10
O D 11
O D 1
O D 2
O D 3
O D 4
O D 5
1.
S O is tri-stated when C S B is logic 1.
N O TE S:
O D 0
S O
O utput shift register is
loaded here
SCLK
CS
SI
SO
C S B
S I
S C LK
D 15
D 1*
D 2*
D 13*
D 14*
D 15*
D 0
D 1
D 14
D 13
D 2
D 0*
O D 13
O D 14
O D 15
D 14
D 15
O D 0
O D 1
O D 2
D 1
D 2
D 13
1.
2.
3.
4.
S O is tri-stated w hen C S B is logic 1.
D 15, D 14, D 13, ..., and D 0 refer to the first 16 bits of data into the G D IC .
D 15*, D 14*, D 13*, ... , and D 0* refer to the m ost recent entry of program data into the G D IC .
O D 15, O D 14, O D 13, ..., and O D 0 refer to the first 16 bits of fault and status data out of the G D IC .
N O TE S
:
D 0
S O
CS
SCLK
SI
SO
F
Freescale Semiconductor, Inc.
Go to: www.freescale.com
n
.
相关PDF资料 |
PDF描述 |
|---|---|
| MC33993 | Multiple Switch Detection Interface(多开关监测接口) |
| MC33997 | Switching Power Supply with Linear Regulators(带线性稳压器的开关电源) |
| MC33998 | Switching Power Supply with Linear Regulators(带线性稳压器的开关电源) |
| MC34017 | Telephone Tone Ringer(电话振铃) |
| MC34063A | DC-DC CONVERTER CONTROL CIRCUITS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MC33991DW | 制造商:Freescale Semiconductor 功能描述:Gauge Driver Integrated Circuit |
| MC33991DWR2 | 制造商:Rochester Electronics LLC 功能描述:GUAGE DRIVER IC - Bulk |
| MC33993DWB | 功能描述:接口 - 专用 MSDI RoHS:否 制造商:Texas Instruments 产品类型:1080p60 Image Sensor Receiver 工作电源电压:1.8 V 电源电流:89 mA 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:BGA-59 |
| MC33993DWBR2 | 功能描述:接口 - 专用 MSDI RoHS:否 制造商:Texas Instruments 产品类型:1080p60 Image Sensor Receiver 工作电源电压:1.8 V 电源电流:89 mA 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:BGA-59 |
| MC33996EK | 功能描述:电源开关 IC - 配电 16LOW SIDE SW 1.2OHM RoHS:否 制造商:Exar 输出端数量:1 开启电阻（最大值）:85 mOhms 开启时间（最大值）:400 us 关闭时间（最大值）:20 us 工作电源电压:3.2 V to 6.5 V 电源电流（最大值）: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOT-23-5 |
发布紧急采购，3分钟左右您将得到回复。