参数资料
型号: MC7457VG733NC
厂商: Freescale Semiconductor
文件页数: 21/71页
文件大小: 0K
描述: IC MPU RISC 733MHZ 483FCCBGA
标准包装: 36
系列: MPC74xx
处理器类型: 32-位 MPC74xx PowerPC
速度: 733MHz
电压: 1.1V
安装类型: 表面贴装
封装/外壳: 483-BCBGA,FCCBGA
供应商设备封装: 483-FCCBGA(29x29)
包装: 托盘
MPC7457 RISC Microprocessor Hardware Specifications, Rev. 8
Electrical and Thermal Characteristics
Freescale Semiconductor
28
L3_CLK to high impedance: All
other outputs
tL3CHOZ
—(tL3CLK/4)
+ 0.65
—(tL3CLK/4)
+ 0.65
ns
Notes:
1. Rise and fall times for the L3_CLK output are measured from 20% to 80% of GVDD.
2. For DDR, all input specifications are measured from the midpoint of the signal in question to the midpoint voltage of the rising
or falling edge of the input L3_ECHO_CLK
n (see Figure 10). Input timings are measured at the pins.
3. For DDR, the input data will typically follow the edge of L3_ECHO_CLK
n as shown in Figure 10. For consistency with other
input setup time specifications, this will be treated as negative input setup time.
4. tL3_CLK/4 is one-fourth the period of L3_CLKn. This parameter indicates that the MPC7457 can latch an input signal that is
valid for only a short time before and a short time after the midpoint between the rising and falling (or falling and rising) edges
of L3_ECHO_CLK
n at any frequency.
5. All output specifications are measured from the midpoint voltage of the rising (or for DDR write data, also the falling) edge of
L3_CLK to the midpoint of the signal in question. The output timings are measured at the pins. All output timings assume a
purely resistive 50-
Ω load (see Figure 8).
6. For DDR, the output data will typically lead the edge of L3_CLK
n as shown in Figure 10. For consistency with other output
valid time specifications, this will be treated as negative output valid time.
7. tL3_CLK/4 is one-fourth the period of L3_CLKn. This parameter indicates that the specified output signal is actually launched
by an internal clock delayed in phase by 90°. Therefore, there is a frequency component to the output valid and output hold
times such that the specified output signal will be valid for approximately one L3_CLK period starting three-fourths of a clock
before the edge on which the SRAM will sample it and ending one-fourth of a clock period after the edge it will be sampled.
8. Assumes default value of L3OHCR. See Section 5.2.4.1, “Effects of L3OHCR Settings on L3 Bus AC Specifications,” for more
information.
9. L3 I/O voltage mode must be configured by L3VSEL as described in Table 3, and voltage supplied at GVDD must match mode
selected as specified in Table 4. See Table 22 for revision level information and part marking.
Table 13. L3 Bus Interface AC Timing Specifications for MSUG2 (continued)
At recommended operating conditions. See Table 4.
Parameter
Symbol
Device Revision (L3 I/O Voltage) 9
Unit
Notes
Rev 1.1. (All I/O Modes)
Rev 1.2 (1.5-V I/O Mode)
Rev 1.2
(1.8-, 2.5-V I/O Modes)
Min
Max
Min
Max
相关PDF资料
PDF描述
MC74HC4052AFG IC MUX/DEMUX DUAL 4X1 16SOEIAJ
MC74HC4066AFEL IC MUX/DEMUX QUAD 1X1 14SOEIAJ
MC74HC4067ADWG IC MUX/DEMUX/QUAD SWITCH 24SOIC
MC74HC4316AFELG IC MUX/DEMUX QUAD 1X1 16SOEIAJ
MC74HC4852AN IC MUX/DEMUX DUAL 4X1 16DIP
相关代理商/技术参数
参数描述
MC7457VG867NC 功能描述:微处理器 - MPU APOLO7 RV1.2 1.1V 105C RoHS:否 制造商:Atmel 处理器系列:SAMA5D31 核心:ARM Cortex A5 数据总线宽度:32 bit 最大时钟频率:536 MHz 程序存储器大小:32 KB 数据 RAM 大小:128 KB 接口类型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作电源电压:1.8 V to 3.3 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:FBGA-324
MC74A5-33SNTR 制造商:Rochester Electronics LLC 功能描述:- Tape and Reel
MC74A5-50T 制造商:Rochester Electronics LLC 功能描述:- Tape and Reel
MC74AC00 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:QUAD 2-INPUT NAND GATE
MC74AC00D 功能描述:逻辑门 2-6V Quad 2-Input RoHS:否 制造商:Texas Instruments 产品:OR 逻辑系列:LVC 栅极数量:2 线路数量(输入/输出):2 / 1 高电平输出电流:- 16 mA 低电平输出电流:16 mA 传播延迟时间:3.8 ns 电源电压-最大:5.5 V 电源电压-最小:1.65 V 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:DCU-8 封装:Reel