- 您现在的位置：买卖IC网 > PDF目录22239 > MC7908ACTG (ON Semiconductor)IC REG LDO -8V 1A TO220AB PDF资料下载
参数资料
| 型号： | MC7908ACTG |
| 厂商： | ON Semiconductor |
| 文件页数： | 9/16页 |
| 文件大小： | 0K |
| 描述： | IC REG LDO -8V 1A TO220AB |
| 标准包装： | 50 |
| 稳压器拓扑结构： | 负，固定式 |
| 输出电压： | -8V |
| 输入电压： | 可下调至 -35V |
| 电压 - 压降（标准）： | 1.3V @ 1A |
| 稳压器数量： | 1 |
| 电流 - 输出： | 1A |
| 工作温度： | 0°C ~ 125°C |
| 安装类型： | 通孔 |
| 封装/外壳： | TO-220-3 |
| 供应商设备封装： | TO-220AB |
| 包装： | 管件 |
MC7900 Series
APPLICATIONS INFORMATION
Design Considerations
-10 V
0.56
- 5.0 V
The MC7900 Series of fixed voltage regulators are
designed with Thermal overload Protection that shuts down
Input
0.56
2N3055*
or Equiv
Output
the circuit when subjected to an excessive power overload
0.56
condition. Internal Short Circuit Protection that limits the
maximum current the circuit will pass, and Output Transistor
Safe ? Area Compensation that reduces the output short circuit
current as the voltage across the pass transistor is increased.
MJE200*
or Equiv
MC7905*
1.0 m F
1.0 m F
10 m F
In many low current applications, compensation
capacitors are not required. However, it is recommended
that the regulator input be bypassed with a capacitor if the
regulator is connected to the power supply filter with long
wire lengths, or if the output load capacitance is large. An
input bypass capacitor should be selected to provide good
high ? frequency characteristics to insure stable operation
under all load conditions. A 0.33 m F or larger tantalum,
mylar, or other capacitor having low internal impedance at
high frequencies should be chosen. The capacitor chosen
should have an equivalent series resistance of less than
0.7 W . The bypass capacitor should be mounted with the
shortest possible leads directly across the regulators input
terminals. Normally good construction techniques should be
used to minimize ground loops and lead resistance drops
5.6
+ + +
Gnd Gnd
*Mounted on heatsink.
Figure 9. Current Boost Regulator
( ? 5.0 V @ 4.0 A, with 5.0 A Current Limiting)
When a boost transistor is used, short circuit currents are
equal to the sum of the series pass and regulator limits, which
are measured at 3.2 A and 1.8 A respectively in this case.
Series pass limiting is approximately equal to 0.6 V/R SC .
Operation beyond this point to the peak current capability of
the MC7905C is possible if the regulator is mounted on a
heatsink; otherwise thermal shutdown will occur when the
additional load current is picked up by the regulator.
1N4001G or Equiv
I O = 200 mA
10
R
since the regulator has no external sense lead. Bypassing the
output is also recommended.
-20 V
Input MC7905
-
V O ≤ 10 V
+20 V
Input
0.33 m F
+
1.0 m F
MC7815
1.0 m F
+
+15 V
Output
Clamp diode
1N4001G
or Equiv
Gnd
Gnd
+
1.0 m F
+
1.0 m F
+
1.0 m F
1.0 m F
+
1N4001G
or Equiv
Gnd
Figure 8. Current Regulator
Gnd
- 20 V
MC7915
-15 V
The MC7905, ? 5.0 V regulator can be used as a constant
Input
Output
I O +
) I B
current source when connected as above. The output current
is the sum of resistor R current and quiescent bias current as
follows:
5.0 V
R
The quiescent current for this regulator is typically 4.3
mA. The 5.0 V regulator was chosen to minimize dissipation
and to allow the output voltage to operate to within 6.0 V
below the input voltage.
1N4001G or Equiv
Figure 10. Operational Amplifier Supply
The MC7815 and MC7915 positive and negative
regulators may be connected as shown to obtain a dual
power supply for operational amplifiers. A clamp diode
should be used at the output of the MC7815 to prevent
potential latch ? up problems whenever the output of the
positive regulator (MC7815) is drawn below ground with an
output current greater than 200 mA.
http://onsemi.com
9
相关PDF资料 |
PDF描述 |
|---|---|
| EBM15DCCH | CONN EDGECARD 30POS R/A .156 SLD |
| 395-130-542-204 | CARD EDGE 130PS DL .100X.200 BLK |
| RBB108DHLD | CONN EDGECARD 216PS DIP .050 SLD |
| LT1249CN8 | IC PFC CTRLR AVERAGE CURR 8DIP |
| NCP500SQL50T1G | IC REG LDO 5V .15A 6-DFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MC7908BD2T | 制造商:MOTOROLA 制造商全称:Motorola, Inc 功能描述:THREE-TERMINAL NEGATIVE FIXED VOLTAGE REGULATORS |
| MC7908BT | 制造商:MOTOROLA 制造商全称:Motorola, Inc 功能描述:THREE-TERMINAL NEGATIVE FIXED VOLTAGE REGULATORS |
| MC7908CD2T | 功能描述:线性稳压器 - 标准 8V 1A Negative RoHS:否 制造商:STMicroelectronics 输出类型: 极性: 输出电压:1.8 V 输出电流:150 mA 负载调节: 最大输入电压:5.5 V 线路调整率: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOT-323-5L |
| MC7908CD2TG | 功能描述:线性稳压器 - 标准 8V 1A Negative RoHS:否 制造商:STMicroelectronics 输出类型: 极性: 输出电压:1.8 V 输出电流:150 mA 负载调节: 最大输入电压:5.5 V 线路调整率: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOT-323-5L |
| MC7908CD2TR4 | 功能描述:线性稳压器 - 标准 8V 1A Negative RoHS:否 制造商:STMicroelectronics 输出类型: 极性: 输出电压:1.8 V 输出电流:150 mA 负载调节: 最大输入电压:5.5 V 线路调整率: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOT-323-5L |
发布紧急采购，3分钟左右您将得到回复。