参数资料
型号: MCF5213LCVM66
厂商: FREESCALE SEMICONDUCTOR INC
元件分类: 微控制器/微处理器
英文描述: 32-BIT, FLASH, 66 MHz, RISC MICROCONTROLLER, PBGA81
封装: 10 X 10 MM, 1 MM PITCH, PLASTIC, ROHS COMPLIANT, BGA-81
文件页数: 27/56页
文件大小: 952K
代理商: MCF5213LCVM66
Electrical Characteristics
MCF5213 ColdFire Microcontroller, Rev. 3
Freescale Semiconductor
33
2.8
General Purpose I/O Timing
GPIO can be configured for certain pins of the QSPI, DDR Control, timer, UART, and Interrupt interfaces. When in GPIO mode,
the timing specification for these pins is given in Table 28 and Figure 5.
The GPIO timing is met under the following load test conditions:
50 pF / 50
Ω for high drive
25 pF / 25
Ω for low drive
Frequency un-LOCK range
fUL
–1.5
1.5
% fref
Frequency LOCK range
fLCK
–0.75
0.75
% fref
CLKOUT period jitter 4, 5, 8 ,9, measured at fSYS Max
Peak-to-peak (clock edge to clock edge)
Long term (averaged over 2 ms interval)
Cjitter
10
.01
% fsys
On-chip oscillator frequency
foco
7.84
8.16
MHz
1 All internal registers retain data at 0 Hz.
2 Depending on packaging; see Table 2.
3 Loss of Reference Frequency is the reference frequency detected internally, which transitions the PLL into self clocked mode.
4 Self clocked mode frequency is the frequency at which the PLL operates when the reference frequency falls below f
LOR with
default MFD/RFD settings.
5 This parameter is characterized before qualification rather than 100% tested.
6 Proper PC board layout procedures must be followed to achieve specifications.
7 This specification applies to the period required for the PLL to relock after changing the MFD frequency control bits in the
synthesizer control register (SYNCR).
8 Jitter is the average deviation from the programmed frequency measured over the specified interval at maximum f
sys.
Measurements are made with the device powered by filtered supplies and clocked by a stable external clock signal. Noise
injected into the PLL circuitry via VDDPLL and VSSPLL and variation in crystal oscillator frequency increase the Cjitter percentage
for a given interval.
9 Based on slow system clock of 40 MHz measured at f
sys max.
Table 28. GPIO Timing
NUM
Characteristic
Symbol
Min
Max
Unit
G1
CLKOUT High to GPIO Output Valid
tCHPOV
—10
ns
G2
CLKOUT High to GPIO Output Invalid
tCHPOI
1.5
ns
G3
GPIO Input Valid to CLKOUT High
tPVCH
9—
ns
G4
CLKOUT High to GPIO Input Invalid
tCHPI
1.5
ns
Table 27. PLL Electrical Specifications (continued)
(VDD and VDDPLL = 2.7 to 3.6 V, VSS = VSSPLL = 0 V)
Characteristic
Symbol
Min
Max
Unit
相关PDF资料
PDF描述
MSP430F2131TPWR 16-BIT, FLASH, 16 MHz, RISC MICROCONTROLLER, PDSO20
MSP430F2232IRHAR 16-BIT, FLASH, 16 MHz, RISC MICROCONTROLLER, PQCC40
MSP430F2252TDAR 16-BIT, FLASH, 16 MHz, RISC MICROCONTROLLER, PDSO38
MC9S12XEP100F1CAA 32-BIT, FLASH, 50 MHz, RISC MICROCONTROLLER, PQFP80
MB90347ESPFV 16-BIT, MROM, 24 MHz, MICROCONTROLLER, PQFP100
相关代理商/技术参数
参数描述
MCF5213LCVM66J 功能描述:32位微控制器 - MCU ColdFire Micro- Controller RoHS:否 制造商:Texas Instruments 核心:C28x 处理器系列:TMS320F28x 数据总线宽度:32 bit 最大时钟频率:90 MHz 程序存储器大小:64 KB 数据 RAM 大小:26 KB 片上 ADC:Yes 工作电源电压:2.97 V to 3.63 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:LQFP-80 安装风格:SMD/SMT
MCF5213LCVM80 功能描述:32位微控制器 - MCU MCF5213 KIRIN RoHS:否 制造商:Texas Instruments 核心:C28x 处理器系列:TMS320F28x 数据总线宽度:32 bit 最大时钟频率:90 MHz 程序存储器大小:64 KB 数据 RAM 大小:26 KB 片上 ADC:Yes 工作电源电压:2.97 V to 3.63 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:LQFP-80 安装风格:SMD/SMT
MCF5213LCVM80J 功能描述:32位微控制器 - MCU ColdFire Micro- Controller RoHS:否 制造商:Texas Instruments 核心:C28x 处理器系列:TMS320F28x 数据总线宽度:32 bit 最大时钟频率:90 MHz 程序存储器大小:64 KB 数据 RAM 大小:26 KB 片上 ADC:Yes 工作电源电压:2.97 V to 3.63 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:LQFP-80 安装风格:SMD/SMT
MCF5214 制造商:FREESCALE 制造商全称:Freescale Semiconductor, Inc 功能描述:CodeWarrior Development Studio for ColdFire㈢ Architectures
MCF5214CVF66 功能描述:32位微控制器 - MCU MCF5214 V2CORE 256KFLASH RoHS:否 制造商:Texas Instruments 核心:C28x 处理器系列:TMS320F28x 数据总线宽度:32 bit 最大时钟频率:90 MHz 程序存储器大小:64 KB 数据 RAM 大小:26 KB 片上 ADC:Yes 工作电源电压:2.97 V to 3.63 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:LQFP-80 安装风格:SMD/SMT