- 您现在的位置：买卖IC网 > PDF目录296502 > MCP1603-330I/MC 0.5 A SWITCHING REGULATOR, 2800 kHz SWITCHING FREQ-MAX, PDSO8 PDF资料下载
参数资料
| 型号： | MCP1603-330I/MC |
| 元件分类： | 稳压器 |
| 英文描述： | 0.5 A SWITCHING REGULATOR, 2800 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封装： | 2 X 3 MM, 0.90 MM HEIGHT, PLASTIC, DFN-8 |
| 文件页数： | 5/26页 |
| 文件大小： | 758K |
| 代理商： | MCP1603-330I/MC |
2007 Microchip Technology Inc.
DS22042A-page 13
MCP1603
4.3
Soft Start
The output of the MCP1603 is controlled during start-
up. This control allows for a very minimal amount of
VOUT overshoot during start-up from VIN rising above
the UVLO voltage or SHDN being enabled.
4.4
Overtemperature Protection
Overtemperature protection circuitry is integrated in the
MCP1603. This circuitry monitors the device junction
temperature and shuts the device off, if the junction
temperature exceeds the typical 150°C threshold. If
this threshold is exceeded, the device will automatically
restart once the junction temperature drops by
approximately 10°C. The soft start is reset during an
overtemperture condition.
4.5
Overcurrent Protection
Cycle-by-cycle current limiting is used to protect the
MCP1603 from being damaged when an external short
circuit is applied. The typical peak current limit is
860 mA. If the sensed current reaches the 860 mA
limit, the P-Channel MOSFET is turned off, even if the
output voltage is not in regulation. The device will
attempt to start a new switching cycle when the internal
oscillator sets the internal RS latch.
4.6
Enable/Disable Control
The SHDN pin is used to enable or disable the
MCP1603. When the SHDN pin is pulled low, the
device is disabled. When pulled high the device is
enabled and begins operation provided the input
voltage is not below the UVLO threshold or a fault
condition exists.
4.7
Undervoltage Lockout (UVLO)
The UVLO feature uses a comparator to sense the
input voltage (VIN) level. If the input voltage is lower
than the voltage necessary to properly operate the
MCP1603, the UVLO feature will hold the converter off.
When VIN rises above the necessary input voltage, the
UVLO is released and soft start begins. Hysteresis is
built into the UVLO circuit to compensate for input
impedance. For example, if there is any resistance
between the input voltage source and the device when
it is operating, there will be a voltage drop at the input
to the device equal to IIN x RIN. The typical hysteresis
is 140 mV.
相关PDF资料 |
PDF描述 |
|---|---|
| MCP1603-ADJI/MC | 0.5 A SWITCHING REGULATOR, 2800 kHz SWITCHING FREQ-MAX, PDSO8 |
| MCP1700-1202ETO | Low Quiescent Current LDO |
| MCP1700-1802ETO | Low Quiescent Current LDO |
| MCP1700-2502ETO | Low Quiescent Current LDO |
| MCP1700-3002ETO | Low Quiescent Current LDO |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MCP1603-ADJI/MC | 功能描述:开关变换器、稳压器与控制器 2.0MHz 0.5A SynBuck PFM/PWM Reg RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel |
| MCP1603-ADJI/OS | 制造商:Microchip Technology Inc 功能描述:CONV DC-DC SGL-OUT STEP DOWN 5PIN TSOT - Rail/Tube |
| MCP1603B | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:2.0 MHz, 500 mA Synchronous Buck Regulator |
| MCP1603BT-180I/OS | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:2.0 MHz, 500 mA Synchronous Buck Regulator |
| MCP1603BT-330I/OS | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:2.0 MHz, 500 mA Synchronous Buck Regulator |
发布紧急采购，3分钟左右您将得到回复。